A capacitor has a reactance (Xc) of 45 2 when operated on a 60 Hz supply. Determine the value of its capacitance (C). C = 7.96 µF C = 58.95 μF C = 79.58 μF C = 5.89 μF

Q: 1. Find below Ay (1st stage, 2nd stage, and overall), Z₁, Z, for the circuit

A: The required parameters can be calculated by using the DC and AC analysis of the cascaded amplifier…

Q: If the capacitor in an RC ci find the CORRECT stateme Select one: a. The time constant b. The time…

A: Time constant of RC circuit is given by, τ=RC........eqn 1 Now, capacitor is replaced by two…

Q: 11. A 3-phase, 50 Hz, 150 km line has a resistance, inductive reactance and capacitive shunt…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Determine all DC and AC values and the quiescent power dissipation for the CE amplifier shown. Use…

A:

Q: 4) Consider the amplifier shown below with its corresponding small signal model. Using the provided…

A:

Q: An unloaded star connected solidly grounded 10 MVA, 11 KV generator has positive, negative and zero…

A:

Q: A 3-phase system supplies 34.2 A at a line voltage of 208 V for a balanced load at 0.89 pf. Find the…

A:

Q: I have submit my tution work please help me i will give likes

A:

Q: D. Design a sequential circuit with eight (8) states and the state transitions are defined in the…

A:

Q: + 100 Ω Μ 20 V3ia Τα t = 0 Χ 100 Ω 0.4 Η 0000 v(t) + - 25 mF

A:

Q: PRACTICE PROBLEM 11.3 8/45° V 392 www |1Ω In the circuit of Fig. 11.4, calculate the average power…

A:

Q: Let us discuss the Eigenfunction property of LTI systems. Discuss when the eigenfunction property is…

A: In response to the given problem, we have to give     - description about eigenfunction property of…

Q: Calculate the steps in a 4 section rotor resistance starter for a 3-phase slipring induction motor…

A:

Q: 3. We have two voltages v₁(t) = 15 sin(400nt + 45°) V and v₂(t) = 5 cos(400nt - 30°) V. Determine…

A: NOTE :     As per our company guidelines we are supposed to answer only first three…

Q: 1. Determine i(t) in the given circuit, the switch had been open for a long time and then closed at…

A:

Q: In the figure shown, the silicon transistor has a β = 150. The statement below are not correct…

A:

Q: please choose the correct answer

A: Given here a coil has a resistance of 5 Ω and inductance of 8 mH .here we have to find the reactance…

Q: Vo 7) Consider the multi-stage amplifier shown below with its corresponding small signal model.…

A: The given problem is from BJT small signal model. The expression for voltage gain Av is given in the…

Q: The circuit shown below is at dc steady state before the switch opens at t = 0. Find the voltage…

A:

Q: find the value of Z₁ in order that Z₁ absorbe the maximum average power -j10 Ω 40 Ω Τε Select one:…

A: Given, ZL=? for maximum power transfer.

Q: Refer to the circuit diagram in Figure 3, compute the V₁ using appropriate method. 12V( 100Ω V 300Ω…

A:

Q: A 2-pole, 50 Hz, 3-phase, turbo-alternator is excited to generate the busbar voltage of 11 kV on no…

A: A synchronous generator's output of electrical torque includes synchronising torque. A magneto is an…

Q: What is the current through the zener diode? V₁ 13 V Select one: a. 0 mA b. 7 mA c. 13 mA d. 8.3 mA…

A: Given circuit:

Q: Convolve the x(n) with h(n) * x(n) * and h(n) are given by, x(n) = (1, 2, 3)  h(n) = (1, 2, 1)

A:

Q: Six resistors are connected to a battery (see the figure below). It is known that R1 = 50, R2 = 252,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: a successive approximation a/d converter has a resolution of 20 volts . what is it's digital output…

A: Given: Resolution=20 volts Analog input=2.17 volt

Q: Determine whether the following assumptions are correct, and briefly support your answer based on…

A: The given circuit is as shown below with labeled diode current directions.

Q: 7 For a certain load, it is given that v(t)= 30cos(40t-10) V and i(t) = 12sin(40t+50). The average…

A: Given data, For a certain load vt=30cos40t-10° Vit=12 sin40t+50° V

Q: wye-connected load has an impedance of (4.69 + j1.71) per phase. The load is connected across a 120…

A:

Q: An analog video signal has maximum frequency of 6 MHz. We want to send this analog video signal in…

A: Given an analog video signal has, Maximum frequency, fm=6 MHz Required data rate, Rb=216 Mbps

Q: Calculate the voltage V4 Ω (presented on attach image) by nodal analysis.

A:

Q: Consider a circuit consisting of a 12 V battery, a 50 Ω resistor, and a 100 µF capacitor connected…

A:

Q: A 3-phase synchronous motor of 8000 W at 1100 V has synchronous reactance of 82 per phase. Find the…

A: A synchronous motor's current draw will be at its lowest for constant power when the power factor is…

Q: -fund the current

A:

Q: Standard intermediate frequency used for AM receiver is a. 455 MHz b. 455 KHz c. 455 Hz d. None of…

A: The function of AM signal is to decode an incoming signal and convert it into an original audible…

Q: Q2. Consider an ideal low pass filter (LPF) with h[n] = sin (@con) 7th where cutoff frequency @co =…

A: Here signal function is given as and input is given by  Cut off frequency Wco = 0.5

Q: Determine the Q-point for each amplifier shown in the figure.

A: For figure a R1=680 Ω                        C1=10 μFR2=510 Ω                        C2=10 μFRE1=4.7…

Q: The process of transferring a mobile station from one base station to another is

A: The correct option along with the explanation is provided in the following section.

Q: 54. Design a single-stage common-emitter amplifier with a voltage gain of 40 dB that operates from a…

A: Given : Voltage gain : 40 dB DC supply voltage: 12 V swapping resistor 330 Ω maximum input voltage…

Q: (b) Analyze the filter coefficient, h(n) for the following frequency response of a symmetric FIR…

A: Given: Frequency response of symmetric FIR filter. we have to analyze the filter coefficients. By…

Q: on a practical inductor at 10 MHz give L = 8 µH and Q = 40. Find the capacitance C for parallel…

A: Given, f = 10 MHz L = 8 μH Q = 40 C = ?

Q: In the following circuit, the switch has been in position a for a long time and then moves to…

A: The required parameters can be obtained by analysing the state of the circuit before and after t=0.…

Q: A garage is illuminated by a single incandescent light bulb dangling from a wire. The bulb radiates…

A: (a) The average intensity at a distance r is given by the expression as shown below:  Iav=P4πr2…

Q: R₁ 22 ΚΩ VIN- R₂ www 220 ΚΩ -VOUT Figure 15.4: A non-inverting amplifier circuit. Consider the op…

A: Given data, Gain bandwidth = 220 kHz Circuit diagram is given as,

Q: The 2G GSM technology uses a carrier separation of

A: The solution is provided in the following section.

Q: What is the current l4 (mA)? VA SR6 15k0 IT R1 RA 1.5k 1kO 12 + V.- 14 +V1- RS R2 Sk0 S10kO R3 E 20…

A: The required parameters can be calculated by calculating the total current in the current and then…

Q: A slab of dielectric material has a relative dielectric constant of 3.8 and contains a uniform…

A: Given parameters: For a given lossless material Dielectric constant, εr = 3.8 Uniform electric flux…

Q: 11C) The power input to a 3-phase induction motor is 60 kW. The stator loses a total of 1kW. find…

A: The phrase "induction motor" refers to a motor that works on the basis of electromagnetic induction.…

Q: Can you explain the difference between these two forms? Like where the current is going, and how it…

A: In the first figure, the solar cell is in operating condition when the sun light strikes on it. So,…

Q: waveforms to scale versus time. 2. The current through a 200-mH inductance is given by i₁(t) =…

A: clc; clear all; close all; syms t; i=exp(-2*t)*sin(4*pi*t); l=0.2; %200mH=0.2H k=diff(i); v=l*k;…