A capacitor of 1µF is connected to a 50 Hz supply. The capacitive reactance is ___. Kindly provide a CLEAR and COMPLETE solution. #41 a. 10/π kilo ohms b. 50 mega ohms c. π/104 ohms d. 10/π ohms

Q: An alternating voltage is given by v =100 sin(50rt -0.30) V. Which of the following statements is tr...

A:

Q: 25 A timer is set in PWM mode 1 Peripheral clock = 48MHZ Prescaler = 8 %3D Value in TGRA = 0XD6D8 %3...

A: According to the question, we need to calculate the frequency of the generated signal for PWM mode 1...

Q: An alternating voltage v-90cos(wt - 161.5 degrees) maybe represented function by 90sin (wt- 71.5 deg...

A: Option - a ( answer )

Q: Example Design Problem, The filter needs to pass 250HZ but attenuate 2kHz and 3kHz signals

A: In design equation, there can be infinite number of solution. In low pass filter, low frequency comp...

Q: Summary of instrumentation amplifier

A: We need give the summary of an instrumentation amplifier.

Q: [9] Write the Boolean expression for the circuit that corresponds to the followin input/output table...

A:

Q: 4] Write 3810 in binary notation.

A: It is the decimal number  To convert it into binary we need to divide it with 2 

Q: M[dB] 26 dB 20 dB 10 dB + 6 dB · @ (rad/s) 0.1 1 100 1000

A: The solution is given below 

Q: A magnetic circuit consists of silicon steel 2,500 permeability, of 10 cm length and a cross section...

A:

Q: Determine the capacitor size in micro farad necessary to increase the power factor by 20% if the loa...

A: The solution is given below 

Q: 2) Explain the relationship between Rp , trigger angle and conduction angle. 3) State the difference...

A: 2) Firing angle is defined as the angle between the instant the SCR would conduct if it would be a d...

Q: Draw the logic diagram for the following functions, then map it using NAND only technology and NOR o...

A:

Q: A magnetic circuit consists of silicon steel of 3000 permeability, of 10 cm length and a 2 cm air ga...

A:

Q: Express the following time-harmonic fields as phasors (a) A = 5 sin(2t + a/3)a, +3cos(2t + 30° la, (...

A:

Q: Answer the question briefly. 1. How to generate an AC? Explain. 2. What are the types of alternating...

A:

Q: A si diode has reverse saturation current of 2.5 micro amp at 300k find forward voltage for a forwar...

A: The equation of current and voltage in forward biad condition is given as: ID=I0eVηVT The value of d...

Q: 2. Prove the following continuous time Fourier transform relationship. [1 -7<N< T Continuous Time si...

A:

Q: Find the pull exerted on the plunger of an electromagnet when the total flux is 381 uWb. The diamete...

A:

Q: :1 Which of the following is a disadvantage in contact mode scanning? O Very poor resolution of scan...

A: In contact mode scanning, the lateral force exerted on tha sample can be quite high, it will leads t...

Q: Are the signals periodic or not? If it's periodic, what's the period? Show it by calculating.   a)...

A: The solution is given below

Q: Non-Directional Overcurrent Relay

A: Non-Directional Overcurrent Relay This relay has the same construction as the watthour meter, with ...

Q: 10 : 1 D4 115Vrms v, 60HZ 50µF c R$2.2k +

A:

Q: 1+z-2 (b) X,(z) = 1+0.9z-1 + 0.81z-2 Find the inverse z-transform of the second-order system 1+z-1 X...

A:

Q: 37. Sketch v, for each network of Fig. 2.181 for the input shown.

A: The diode will conduct only during forward bias so the diode can be replaced by short circuit and du...

Q: A full wave bridge rectifier is supplied from 230V, 50Hz and uses a transformer of turns ration 15:1...

A: The solution is given below

Q: A 29.5 cm long straight wire carries 118 A and lies perpendicular to a uniform field of 5,900 lines ...

A: We need to find Power for given current and magnetic field

Q: A capacitor is made with a dielectric layer of mylar film that is 12μm thick. The effective area of ...

A:

Q: The diodes in the circuit are silicon with forward voltage of 0.7 V. Fill up the table showing the s...

A:

Q: A 7.5 hp, 220 V, 19 amp, 4-pole, Y-connected, Design Class C, three-phase induction motor was tested...

A: Given information about a three-phase 7.5 HP, 220 V, 19 amp, 4-pole, Y-connected, Class C, induction...

Q: Determine the capacitor size in micro farad necessary to increase the power factor by 20% if P1 and ...

A:

Q: For the given circuit and input waveform determine the output waveform 2.2 kn 20 5 V -5

A: Given circuit is a series negative clipper with positive reference voltage This reference voltage te...

Q: 1. For the circuit shown, find the current I through the 6 Q resistor using Thevenin's Theorem R-62 ...

A:

Q: A 3 – phase induction motor has a 4 – pole, star – connected stator winding. The motor runs on a 50 ...

A:

Q: What is the need for modulation? Justify with examples.

A: MODULATION: Modulation is critical branches of electronics science that is widely used in communicat...

Q: Find the phase angle in the given alternating quantity: 90sin 400πt V. Kindly provide a CLEAR and CO...

A: Bsin( wt+ theta) Compare the given signal with the above  Signal

Q: How many GPS Satellites are present?

A: In this case, the number of GPS satellites present should be found. 

Q: Find z transform of the signal x(n) which x[n]=(%)" sin(4n)u[n]

A: We need to find z transform of given signal

Q: INSTRUCTION: USE 5 DECIMAL PLACES What value of R. will the circuit be in resonance given a parallel...

A:

Q: 1. Determine current l, in the circuit of Figure below using mesh analysis ww 5/0' A -/2A 20/90 V

A:

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A: Bandwidth of the signal : There are mainly two type of Bandwidth of any signal that are the passband...

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A: We need to tell about bandwidth of frequency modulated signal

Q: Using the given circuit, calculate: 1) Equivalent capacitance 2) Charge across each capacitor 3) Vol...

A: Solve the problem

Q: In the network, find the value of ZL for maximum power transfer. The load impedance has both variabl...

A: Given: Consider the following network: The load impedance has both variable resistance and variable...

Q: Determine the total resistance and the current along 3 ohms in downward direction.

A:

Q: 4. Draw the ouput voltage waveforms.

A:

Q: a Ix A,079( 2Vx 12 be HE 10 I3 I2 -jia I4 jia 12 2Ix Vx I1 e all

A:

Q: (a) [3] Write 1101012 in decimal form. (b) [4] Calculate 110102 – 11012 in binary form. [Do not conv...

A:

Q: For the digital system shown in below: 1) Write down the difference equation that represents the sys...

A: Solve the problem

Q: A shunt motor has a nameplate rating of 140 hp, 500 V, 205 A, 1700 rpm. The shunt field circuit resi...

A:

Q: The reluctance of a non-magnetic path is 12 AT-Wb. Find the flux needed to be set up if surrounded b...

A: