A car of mass m is stationary but on the verge of slipping on a road that is inclined steeply (see figure). What is the magnitude of the force of friction acting on the car parallel to the road, where the road is inclined at 0 = 52 degrees relative to the horizontal? mg tan38° mg cos52° one needs to know the coefficient of static friction to answer this question

A car of mass m is stationary but on the verge of slipping on a road that is inclined steeply (see figure). What is the magnitude of the force of friction acting on the car parallel to the road, where the road is inclined at 0 = 52 degrees relative to the horizontal? mg tan38° mg cos52° one needs to know the coefficient of static friction to answer this question

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 63PQ: A 75.0-g arrow, fired at a speed of 110 m/s to the left, impacts a tree, which it penetrates to a...

See similar textbooks

Similar questions

Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
A horizontal force of 800 N is needed to overcome the force of static friction between a level floor and a 200-kg crate. If g = 9.8 m/s2 , what is the coefficient of static friction?
A moving truck (m = 3200 kg) is parked on a hill that is inclined at an angle of 11◦ from the horizontal. Assuming that the static friction between the truck and surface on which it is parked is at its maximum value, what is the coefficient of static friction of the surface?
The total aerodynamic force F acting on the airplane has a magnitude of 6250 lb. Resolve this force into vertical and horizontal components (called the liftand the drag, respectively)
Two blocks A and B have a weight of 10 lb and 6 lb , respectively. They are resting on the incline for which the coefficients of static friction are uA = 0.15 and uB= 0.25. Determine the incline angle ?theta for which both blocks begin to slide. What is the friction force under each of the blocks when this occurs? The spring has a stiffness of k = 2lb lb/ft and is originally unstreched.
A 250.0 N box is placed on a horizontal surface and a force of 150 N is applied at anangle of 30.0o from the horizontal. As a result, the box slides along the surface with anacceleration of 05.00 m/s2What is the coefficient of friction between the box and the surface?
A boy has stacked two blocks on the floor so that a 5.00kgblock is on top of a1.60kg block. If the coefficient of static friction between the two blocks is 0.400 and the coefficient of static friction between the bottom block and the floor is 0.220,with what minimum force should the boy push horizontallyon the upper block to make both blocks start to slide together along the floor?
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0 m/s2to the right, what is the magnitude F of the applied force?
If the coefficient of kinetic friction, , between the block and the surface is 0.30 and the magnitude of the frictional force is 80.0 N, what is the weight of the block? ( Assume the block is on a horizontal surface)
A 42.0 kg box on a horizontal surface is being pulled by a horizontal force F= 110N. If the acceleration of the box is 1.20 m/s^2, what is the coefficient of kinetic friction between the box and the surface?
A 10 kg block sits on a horizontal surface and is pushed parallel to that surface. The coefficients of static and kinetic friction are 0.2 and 0.1, respectively. How much force is required to get the block moving?
A block of mass M1 = 3 kg rests on top of another block of mass M2 = 5 kg. As shown in the figure, the top block is connected by a cord to a wall at left. The bottom block rests on a frictionless inclined plane of angle theta = 20o and has a force F applied to it down the plane. If the minimum force for which the bottom block will begin to slide has magnitude F = 2.5 N, what is the coefficient of static friction (us) between the two blocks?