Chapter 10 A car tire is filled to an absolute pressure of 2.80 ATM (atmospheric pressure) at a temperature of –30.2°C.Later it is driven to a place where the temperature is 40.0°C. What is the absolute pressure (in ATM) of thetire at the hot place?(1 ATM = 1.01 × 10° Pa and also assume the volume of the tire remains constant.)Enter your answer (at least 3 significant figures) in units of ATM but do not type the units in your answer.For example, if your answer is 2.12 ATM, enter 2.12 as your answer.

Here tyre is act as a adiabatic wall (no exchange of heat) Adiabatic equation (P1/P2) ^(1-Y) =…

A car tire is filled to an absolute pressure of 2.80 ATM (atmospheric pressure) at a temperature of -30.2°C. Later it is driven to a place where the temperature is 40.0°C. What is the absolute pressure (in ATM) of the tire at the hot place?

A car tire is filled to an absolute pressure of 2.80 ATM (atmospheric pressure) at a temperature of -30.2°C. Later it is driven to a place where the temperature is 40.0°C. What is the absolute pressure (in ATM) of the tire at the hot place?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 49P: The height of the Washington Monument is measured to be 170.00 m on a day when the temperature is...

See similar textbooks

Related questions

Q: A hydrogen atom is 5.3x10^-11m in radius. Use the uncertainty principle to estimate the minimum ener...

A: Given: r=5.3*10-11 m

Q: The LRT passes through a station with an initial velocity of 23 m/s and decelerates at a rate of 0.1...

Q: Two identical springs with each one of their ends are fixed to a support and the other are attached ...

Q: In the Photoelectric Effect, decreasing the intensity (amplitude) of light: Question 5 options: Incr...

Q: An object with a mass of 5.13 kg placed on top of a spring compresses it by 0.25 m. a) What is the f...

Q: A 3.10 kg particle has a velocity of (2.96 i - 3.98 ĵ) m/s. (a) Find its x and y components of momen...

A: The momentum of a body is given by p = mv, where m = the mass of the body v = velocity of the body ...

Q: Two identical springs with each one of their ends are fixed to a support and the other are attached...

A: The net spring constant of identical springs attached in parallel is given by Knet = nK, where n = n...

Q: 80p 60

A: Slope of velocity time graph represent acceleration.

Q: Two motor vehicles, BMW and Ducati, are driving at SLEX southbound lane. At 9:00:00 am they are 100 ...

A: Given : Distance between BMW and Ducati =100 m Initial velocity of BMW (ua) = 100 km/hr Initial velo...

Q: Two identical charges Q are placed at x = - a and at x = a. What is the magnitude of the net electri...

Q: Two elevators of equal mass, A and B, are pictured below and move at constant speed. Elevator B move...

Q: 3. Determine the viod percentage and show the radius of small sphere atom (0.732)

Q: This figure (lal = 24.0 m/s) represents the total acceleration of a particle moving clockwise in a c...

Q: A spaceship in outer space has a gyroscope within it used for rotation and stabilization. The moment...

Q: A 457.0 kg copper bar is put into a smelter for melting. The initial temperature of the copper is 29...

Q: 8. Two point charges, q1=q2=13nC, are located on the x-axis and is 8 meters apart. Assuming that q1 ...

Q: I. The electric field and the electric force have the same direction. II. The electric field surroun...

Q: Find the heat loss per second through a 9 m2 copper object 2 cm thick if the temperature of one surf...

Q: Two resistors are arranged in a circuit, as shown below. 24-volt 4.0 2 6.0 2 source

Q: 1) Are the normal force and the force of gravity on an object on a surface always equal in magnitude...

Q: 4. A small bulb is rated at 7.5 W when operated at 125 V. Its resistance (in ohms) is ANS = 2100

Q: What is the potential difference between plates of 30μF capacitor whose charge 50μC?

A: Given data: Capacitance (C) = 30 μF Charge (Q) = 50 μC Required: Potential difference (V)

Q: A pipe transports gas up a hill. At the bottom of the hill, the mean velocity in the pipe is 10m/s a...

Q: •19 (a) Find the frequency of revolution of an electron with an energy of 100 eV in a uniform magnet...

Q: A mercury barometer at the base of the mountain reads 756 mm. At the same time, another barometer at...

Q: The power of a contact lens is -7 Diopters. Is the contact lens a converging lens or diverging lens?

A: Here given that power of contact lense is (-7) Diopters. We know power of lense formula, Power = (1...

Q: The distance covered by an object (in metre) is given by s = 8t3 - 7t2 + 5t | Find its speed at t = ...

Q: Assume the pulley and cord are massless, and the cord is inextensible. Neglect friction. (a) Through...

A: Givenm1=2 kgm2=6.3 kgInitial speed ,u=2.85 m/s

Q: A very long, hollow cylinder (radius 3.1cm) is formed by rolling up a thin sheet of copper. Electric...

A: Ampere circuital law Closed integral of dot procuduct of magnetic field and closed loop length is eq...

Q: With a fireworks bazooka, a firework is fired vertically upwards, with a speed of 150 m/s. a) Calcul...

Q: 2. A spring has a force constant of 525 N /m. A force of 375 N is applied to the spring. Find the el...

A: As per the answering guidelines we will solve only the first problem. Please upload the other proble...

Q: If R = 7 k2 and C = 6 µF, what is the time constant for the dis- charge of the capacitors? (include ...

Q: A pipe transports gas up a hill. At the bottom of the hill, the mean velocity in the pipe is 10 m/s ...

Q: You (50kg) are running westward at a speed of 15m/s has a head-on collision with your crush (75kg) ...

A: After the collision, as we are locked together and moving(hope so..dreams..), what we had is an inel...

Q: Example: A (1.84 N) body is suspended by a spring which is stretched (15.3 cm) when it is loaded. If...

Q: A man pulls a 100 N crate up a frictionless 30° slope 5 m high (vertical distance moved) as shown . ...

A: The work done by a force can be defined as the product of the displacement of an object and the comp...

Q: 1.) What is the equivalent resistance of the following circuit? 5.0 N 2.5 N 10 N ww ww 10 N 15 0 5.0...

A: Resistors in Series : A circuit is said to be connected in series when the same amount of current fl...

Q: climbing on a hill that is inclined at 22º with the horizontal and you wish to build a rope tow to p...

A: According to Newton's second law F = ma

Q: When drawing free-body diagrams, does the label “centripetal force” get used? Explain why or why no...

A: Centripetal force : Centripetal force is the force acting on an object in curvilinear motion directe...

Q: Sam is 5’7 ft tall and tossed a coin straight up which reached 3.1 m above the floor. At what veloci...

Q: A copper wire 660 ft long has a resistance of 1.046 Ω. How long is a copper wire of the same size (i...

Q: That does the 220-V mark in outlets as shown below indicate? 110 V Plug

A: In alternating current the real voltage is its root mean square voltage

Q: Part A A standard 100 W (120 V) lightbulb contains a 9.40 cm -long tungsten filament. The high-tempe...

Q: Draw a sketch and also a good FBD to identify the relevant forces doing work. Pay attention to the u...

Q: Consider the circuit shown in Figure. 2.00 0 3.00 0 1.00 0 18.0 V 4.00 N 1. The equivalent resistanc...

A: V = 18 volts R1 = 2 ohm R2 = 3 ohm R3 = 1 ohm R4 = 4 ohm

Q: Velomobile Characteristics Mass: 29 kg in addition to the rider Aerodynamic drag: F, = 0.0492 V* (Ne...

Q: A particle moves in one dimension from rest under the influence of a force that varies with the dist...

Q: A capacitor is composed of 2 plates separated by a sheet of insulating material 2mm thick and of rel...

Q: 1. A parallel-plate capacitor has a rate of 5 mF with no dielectric material. What will be its

Q: If nl and n3 are either both larger or smaller than n2 in a thin film interference, then what will h...

Concept explainers

Diatomic Gas

Molecule, is a collection of two or more atoms together (which constitute the smallest observable unit) into a pure material. There are some ways to represent the structure of a molecule. Factor symbols represent atoms in Lewis structures, and dots represent electrons that accompany them. A pair of mutual electrons (covalent bond) may be represented by a single dash. The ball-and-stick model depicts the spatial structure of the atoms better.

Question

Chapter 10

A car tire is filled to an absolute pressure of 2.80 ATM (atmospheric pressure) at a temperature of –30.2°C.
Later it is driven to a place where the temperature is 40.0°C. What is the absolute pressure (in ATM) of the
tire at the hot place?
(1 ATM = 1.01 × 10° Pa and also assume the volume of the tire remains constant.)
Enter your answer (at least 3 significant figures) in units of ATM but do not type the units in your answer.
For example, if your answer is 2.12 ATM, enter 2.12 as your answer.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A popular brand of cola contains 6.50 g of carbon dioxide dissolved in 1.00 L of soft drink. If the evaporating carbon dioxide is trapped in a cylinder at 1.00 atm and 20.0C, what volume does the gas occupy?
What is the gauge pressure inside a tank of 4.86104 mol of compressed nitrogen with a volume of 6.56 m3 if the rms speed is 514 m/s?
A company advertises that it delivers helium at a gauge pressure of 1.72107 Pa in a cylinder of volume 43.8 L. How many balloons can be inflated to a volume of 4.00 L with that amount of helium? Assume the pressure inside the balloons is 1.72105 Pa and the temperature in the cylinder and the balloons is 25.0 .
The height of the Washington Monument is measured to be 170.00 m on a day when the temperature is 35.0 . What will its height be on a day when the temperature falls to -10.0 ? Although the monument is made of limestone, assume that its coefficient of thermal expansion is the same as that of marble. Give your answer to five significant figures.
(a) Find the density in SI units of air at a pressure of 1.00 atm and a temperature of 20 , assuming that air is 78% N2, 21% O2, and 1% Ar, (b) Find the density of the atmosphere on Venus, assuming that it's 96% CO2 and 4% N2, with a temperature of 737 K and a pressure of 92.0 atm.
Using a numerical integration method such as Simpson's rule, find the fraction of molecules in a sample of oxygen gas at a temperature of 250 K that have speeds between 100 m/s and 150 m/s. The molar mass of oxygen (O2) is 32.0 g/mol. A precision to two significant digits is enough.
One process for decaffeinating coffee uses carbon dioxide ( M=44.0 g/mol) at a molar density of about 14,0 mol/m3 and a temperature of about 60 . (a) Is CO2 a solid, liquid, gas, or supercritical fluid under those conditions? (b) The van der Waals constants for carbon dioxide are a=0.3658 Pa m6/mol2 and b=4.286105 m3/mol. Using the van der Waals equation, estimate pressure of CO2 at that temperature and density. `
What is the total translational kinetic energy of the air molecules in a room of volume 23 m3 if the pressure is 9.5104 Pa (the room is at fairly high elevation) and die temperature is 21 ? Is any item of data unnecessary for the solution?
The absolute pressure in your car tires is 3.3 × 105 Pa at a temperature of 35.0°C when you drive it onto a ferry boat to Alaska. -What is the absolute pressure of the tires, in pascals, later when the temperature has dropped to -40.0°C? Assume the volume of each tire does not change.
What is the partial pressure of water on a day when the temperature is 30 ∘C and the relative humidity is 77 % ?
In a closed, insulated system, the vapour pressure of water at 14.81 °C is 5560 Pa. What percentage of the standard atmospheric pressure (1 atm) is this? (Value between 0 and 100 with 3DDP).
If a pneumatic cylinder has a volume of 14 cubic inches at 1000 PSIG when the temperature is 85°F and then the temperature is elevated to 125°F by compression to 12 cubic inches. What does the gage pressure increase to?