A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by (4cos2T103t) volt with percentage of modulation 25%- Calculate: sideband power and carrier, the .bandwidth, and the value of

A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by (4cos2T103t) volt with percentage of modulation 25%- Calculate: sideband power and carrier, the .bandwidth, and the value of

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Wave Optics

Section: Chapter Questions

Problem 39P

See similar textbooks

Similar questions

A transmitter transmits an AM signal with a carrier frequency of 1470 kHz. When a superheterodyne radio receiver (which has a poor selectivity in its RF-stage bandpass filter) is tuned to 1530 kHz, the signal is heard loud and clear. However, if this radio is cheap, its front-end bandpass filter is not very selective. Thus, the same signal is also heard (not as strongly) when tuned to another carrier frequency setting within the AM range of 535-1605 kHz. State, with reasons, at what frequency you will hear this station. The IF is 455 kHz.
Q1) The maximum peak to peak value of an AM wave is 52 volts and its frequency is 58000000. The peak to peak value of the modulating signal is 13volts and its frequency is 21000. If it is transmitted through an antenna with an internal resistance of 93ohms, Find the following: 1. modulation index m 2. percentage modulation %m 3. Amplitude of carrier Vc 4. Total power Pt 5. Carrier power Pc 6. Power in side bands Psb 7. Power in upper side band Pusb 8. Total transmitted current It 9. Carrier current Ic
For a Symmetrical Slab AlGaAs Waveguide, calculate the number of Modes that will propagate if the Wavelength is 870 nm and the Thickness is 8.5 um.
A station is given a carrier frequency of 88 kHz. Having a modulating frequency of 12 kHz, compute for the upper and lower sidebands of the station.
The mean optical power launched into an optical fiber link is 1.5uw and the fiber has attenuation of 0.5 dB/km. Determine the maximum possible link length without repeaters when the minimum mean optical power level required at the detector is 2uw.
For cellphone 4G LTE operates at frequency 1.90 GHz. What is corresponding wavelength the cellphone operates on?
Determine the %modulation of an AM signal if the maximum voltage is 50 V and the minimum voltage is 30V.
If the peak value of a 1.5-kHz audio oscillator is 25V, what is the instantaneous voltage whenϴ = 215°?
design an ordinary end fire uniform linear array with only one maximum so that its directivity is 20 dB (above isotropic). The spacing between the elements is lambda/4 and its lenth is much greather than the spacing. Determine the (a) the number of elements (b) overall length of the array (in wavelengths) (c) approximate half-power beamwidth(in degrees) (d)amplitude level (compared to the maximum of the major lobe) of the first minor lobe (in dB) (e) progressive phase shift between the elements (in degrees)
The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.0-?H inductor is used in a tuning circuit for a radio, what are the extremes that a capacitor must reach in order to cover the complete band of frequencies? What does Cmax= What does Cmin= Both answer in nF
The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a tuning circuit for a radio, what are the extremes that a capacitor must reach in order to cover the complete band of frequencies? Cmax = nF Cmin = n
A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz). If its LC circuit has an effective inductance of 200 µH, what must be the range of its variable capacitor?