A certain circuit is composed of two parallel resistors. the total resistance is 1403 ohms. One of the resistors is 2000 ohms. The other resistor value is

Q: with a subtransient reactance of 0.1 pu, are connected through a line of reactance 0.1 pu on the…

A: The solution is given below

Q: A discrete-time periodic signal x[n] is real valued and has a fundamental period N = 5. The nonzero…

A:

Q: 3) Find Thevenin equivalent (VTH and RTH) seen by the terminals. 200 IA 10 2 10 V A. .. Find…

A:

Q: Obtain the transfer function E,(s)/E(s) of the system shown in Figure Rz

A: The given circuit is shown below:

Q: term ‘DC motor’ is used to refer to any rotary electrical machine that converts direct current…

A: In this Question we will write about how rotor in a DC motor rotates....

Q: Draw the Schematic symbols of various types of special-purpose Diodes. Label the terminals properly

A: In this question we will Draw the Schematic symbols of various types of special-purpose Diodes.....

Q: Using source transformation determine the power dissipated by the 5.8k resistor (write your result…

A:

Q: single-phase transformer with a rating of 50kva has an iron loss of 400 W and a full load copper…

A: The solution is given below

Q: Find the z parameters of the two-port network in Fig. 18.9. Answer: z11 = 14, z12 = z21 = Z22 = 6…

A: This question belongs to circuit theory . It is based on the concept of calculation of z parameters…

Q: An iron bought in the Philippines is rated at 1200 W and is connected to a 110-V source in Japan.…

A: Brief description : Here they have mentioned an iron which is purchased in Philippines with having…

Q: A frequency modulator circuit has 100HZ/V frequency deviation constant. The FM signal produced is 50…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: o Vo Si | 10 mA 2.2 kQ 2.2 kN

A: We will find diode current for given circuit

Q: 1. When gre the p-n junctions of the n-channel FET blocked?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: Calculate the resistance of 87 m length of a wire having a uniform cross-sectional area of 0.25 mm²…

A: This question belongs to electrical network theory . It is based on the concept of formula of…

Q: Use a A-to-Y transformation in finding the currents I . 1, and /y for the circuit shown in Fig.…

A: The circuit given is shown below:

Q: Q1/b: the inverter always produce: Q1/c: SVPWM have Q1/d : the binary number of the sectors…

A: As per the guidelines given to us, we can only provide the solution to the three subparts of the…

Q: Part A - Calculating the output voltage of a difference op-amp circuit Learning Goal: To analyze…

A: Part A  The given circuit is shown below: The voltage at the node b,  Vb=R2R1+R2VxVx=100 mVR2=100…

Q: 500-hp synchronous motor is connected to 2300 volts. the motor is to operate at 90% power factor.…

A: We need to find out current for given power

Q: A shunt generator delivers 195 A at terminal p.m. of 250 V. The armature resistance and shunt field…

A: Since you have posted a question with multiple sub parts , we will solve first three sub parts for…

Q: Question 18 Determine base voltage Vg 10 V 4.3 k2 Vị I B = 100 390 k2 Z +10 V A 0.7 V В) 9.3V 10 V…

A:

Q: ZMI Zd 8m(r, || RpL)Z, 1+ g„(r, || RpL) 1+ g„(r, || RpL) and ZM2 gd m (1+g„(r, || RpL)).C, gd CM1=…

A: We need to show the given equation .

Q: For the following network, find l1, Pa, and Iz. 24 V 120

A:

Q: Q1) Draw the ladder diagram for the logic circuits A&B В: S* (M+W) = (S*W)HS*M) W (M+W) M A

A:

Q: Diodo kr = 0.001 RL = 1K Load Resistor AL Capacitor PIV = 10V ** If rating is given, do not include…

A: Given: Consider the following circuit: To find: (9) What is IDpk rating? (10) What is IDave rating?

Q: QI: A BPCM system is used to transmit signal of 512 levels, the input signal works in the range…

A: We need to find data rate and signal to noise ratio.

Q: 19) USE SOUACE TRANSFORMAIION To FIND Io 3kn 3kn 34kn 33kn 33kn Io Hkn )2mA + 12v To

A: Source transformation  A current source connected in parallel to a resistance can be converted into…

Q: Part A For the given circuit, determine the mutual inductance, M. L1 = 7.0 H, L2 = 6.0 H, R1 = 6.0…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An 8-pole, 50 Hz, 3-phase induction motor has a full-load slip 2.5% and maximum torque of twice the…

A: In this question induction motor full load slip and relation between full load torque and maximum…

Q: induced emf is equal to rate of change of magnetic flux. 4.a- According to 4.b- In a 3-phase, 4…

A: We need to select correct option for given statement

Q: show work

A:

Q: Conductors A and B are connected in parallel. Their respective specific resistances are in the ratio…

A:

Q: 2 MN 1.4 ΜΩ 2 µA 1.3 μΑ 3 ΜΩ () 41 μΑ 2.7 ΜΩ

A:

Q: hat is the z-transform of h(n) = ō(n) - 26(n – 1) + d(n – 2). z- 2 +z1 а. b. 1- 2z1 + 2z2 1- 2z1 +…

A: Option C Use the basic z transform properties and then use delay properties of z transform Split the…

Q: A three-phase circuit has two parallel connected balanced loads. The first balanced delta load with…

A: The solution is given below

Q: determine the voltage gains: (a) Av=Voj/Vi and (b)Av=Vo/Vi. R. R Vio W R. Vo1 oVo R, Ri-1KΩ R2-10K…

A:

Q: 7.5Kva distribution transformer operates as follows: full load and unity pf for 1.5hrs; half loaf…

A: The solution is given below

Q: 7.5 kN. 5 kN 10 Vo 2 k. 6 V o- o Vo.

A: Brief description: The value of output voltage for the given amplifier is Vo . Vo = -37.5 V  Here…

Q: 1. Draw the AC equivalent circuit of the voltage divider bias configuration below with emitter…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: For the network , determine: a. Ig. b. Ic. c. VCE- d. Vc. - 16 V 12 k2 Vc IB VCE B = 80 9.1 k2 15 k2…

A:

Q: 8.Find the total current for the given network. 10 IT 25V- 12.5 310 312.5 312.5

A: We will find out total current for given circuit

Q: An electric fan motor draws 3A of current from a 220-V source. What is the power associated with the…

A:

Q: If the current through x ohm resistance in the circuit is 5A, find the value of x. x ohm 12 ohm 135…

A: In this question we need to find a value of x.

Q: 7.5 k. 5 k. 10 Vo 2 kN 6 V o- o Vo.

A:

Q: +12 V 36 k2 36 ka V = 2 mV = 200 33 k2 -12 V

A:

Q: usé differential equation method to: 1. Find the initial capacitor voltage V (t0) when switch moves…

A: We need to find out voltage across capacitor in given circuit

Q: 2.46. Compute the convolution y(t) = x(t) * h(t) of the following pair of signals: 0<t<T 0<t<2T x(t)…

A:

Q: What is transconductance explained simply?

A:

Q: Find Z(jw) in the following network. www

A: In this question we need to find a Z(jw) of the given circuit.

Q: For the bridged T-network of the following figure, vi = 2 cos t and the system is in the steady…

A:

Q: R, U, R U, Figure 3.1.1.2

A: …

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.