A certain coal-fired power plant has a rated power capacity of P = 950 MW. The output of this plant is W = 0.25QH, where QH is the energy input as heat from the hot reservoir. a)Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant.  b)If the power plant operates for a full day at its rated capacity, how much energy QH in MJ is needed?  c) If, on average, one ton of coal contains Q = 25 GJ of energy, how many tons nH of coal would the plant need to operate for a day at its rated capacity

Q: Silicon tetrachloride, SiCl4, is a key chemical in the silicon chemical vapor deposition. The purity...

A:

Q: A conditioning room has an atmosphere with a 57.81 mole% CO2 concentration. Outside the room, the co...

A: Given that, CO2 concentration in the room = 57.81 mole% = 0.5781 Total pressure P = 1 atm Temperatur...

Q: How was the Fahrenheit temperature scale calibrated? Decribe how this calibration process reflects m...

A: Fahrenheit is a scale to measure the temperature of an object. The temperature of an object is defin...

Q: A closed tank contains vapor and liquid water at 300 F. The height of the liquid level is 5.1 m. Wha...

A: A closed tank contains the vapor and liquid water. Given data: Temperature of water = 300 0F The hei...

Q: A composition analyzer is used to measure the concen-tration of a pollutant in a waste water stream....

A: The concentration of a pollutant present in a waste-water stream is measured by a composition analyz...

Q: Buckley et al. (1985) discuss using a selector to con-trol condensate temperature at 100∘C in a refl...

A: According to Buckley et at al, chemical and petroleum industries generally use water-cooled condense...

Q: An automobile engine is supplied with a gasoline that is found by analysis to contain 88% carbon and...

A:

Q: Is the following statement true? For the false statement, explain why you think they are false:Feedb...

A: Feedback control controls the input of system by signal developed by measuring the output of a syste...

Q: 4.4 (a) To generate steam at 60 atm, two processes are proposed: (1) Vaporize water at 1 atm and com...

A: (a) Generation of steam at 60 atm. Process 1: Water is vaporized at 1 atm and then compressed to 60 ...

Q: Balance the following equations:a) PCl5(s) + H2O (l) - POCl3(l)

A: The balanced reaction is the reaction in which the number of atoms on the reactant side should be eq...

Q: Which column gives narrower peaks in a chromatographic separation: plate height 5 0.1 mm or 1 mm?

A: The height of plate for a column where the peak obtained is narrower is to be determined.

Q: The Ksp of PbI2 is 1.4 × 10–8. Calculate the molar solubility of lead(II) iodide.

A: Since no solvent is given, take the solvent as water and calculate the solubility of PbI2 in water. ...

Q: Vapor–liquid equilibrium for heptane–toluene system.(a) The vapor pressure of toluene is given in Ex...

A:

Q: Forty-five kg of a solution of 30 wt% ethylene glycol in water is to be extracted with furfural. Usi...

A: Mass fraction of water= 100-30% ethylene glycol =70% Draw a line from C(0,1) to Feed to 70% mass fra...

Q: A process is carried out in which a mixture containing 25.0 wt% methanol, 42.5% ethanol, and the bal...

A:

Q: Using RCRA procedures, determine if the following are classified as hazardous wastes. State the reas...

A: Code: F024 Pentachlorobenzene may have adverse effect to aquatic animals and hence it is considered...

Q: Why is heterogeneous azeotropic distillation a more feasible technique than homogeneous azeotropic d...

A: The reason of choosing heterogeneous method for azeotropic distillation instead of homogeneous one i...

Q: Explain how a molecule that contains polar bonds can be nonpolar.

A: Polarity is the segregation/separation of electric charge resulting in a molecule or its chemical gr...

Q: For molecular geometry shown here, list the number of total electron groups, the number of bonding g...

A: The total number of electron groups, the number of bonding groups and lone pair number on central at...

Q: Measurements indicate that 23.6% of the residents of a city with a population of 531,314 are college...

A:

Q: Thermodynamics. A flow of oxygen at -50oC and 6.3 atm flows at a rate of 125 kg / h. Uses:a) The equ...

A:

Q: Carburetted water gas is produced in the same way as blue water gas except that it is done in the pr...

A:

Q: A liquid of unknown density is placed in the tank. A second pressure transducer is placed 1 meter ab...

A:

Q: In a thermostat control system for a home heating system,(a)Identify the manipulated variable(b)Iden...

A: (a)   In a home heating system controlled by a thermostat, the heat evolved from the furnace that ma...

Q: The flue gas from a furnace goes out with the following composition (dry basis): 12% CO2, 3% O2, 2% ...

A: Basis: 100 mol of dry fuel gas Given that: barometric (atmpspheric) pressure Patm = 759 mm Hg, Pwate...

Q: The rate-based model requires component mass-transfer coefficients, interfacial areas, and heat-tran...

A: The temperature difference is driving force for heat flow similarly, concentration difference is the...

Q: The proximate analysis of a coal is 32% VCM, 5%M, 10% ash, 1.2% N, and 6.2% S. Its calorific value i...

A: Composition of the given coal: 32%VCM (Volatile Combustible matter), 5% M (Moisture), 10% ash, 6.2%S...

Q: A furnace is fired with fuel oil containing 86% C, 1%N, and 0.1%S with a calorific value of46.4 MJ/k...

A: Note:  We are authorized to answer three subparts at a time, since you have not mentioned which part...

Q: Discuss the advantages and disadvantages of the available correlations for estimating binary-pair ma...

A:

Q: Expressing Cj=hj (X) for a Liquid-Phase Batch ReactionSoap consists of the sodium and potassium salt...

A: Take the basis of the calculation to be sodium hydroxide (NaOH). The given reaction is written in th...

Q: Gaseous fuel composed of 70% carbon, 25% hydrogen and 5% oxygen is burned with 20% excess air. Air i...

A: The given fuel composition is: Carbon, C = 70%Hydrogen, H = 25%Oxygen, O = 5% The basis is taken as ...

Q: Whenever a substance is heated, its enthalpy increases, as suggested by the relation, ∆?=Cp∆?. Howev...

A:

Q: Can you explain briefly about the types of Electricity Generation?

A: Electricity is the type of energy which is widely used in the industries to carry out the various op...

Q: Acrylic acid (CH₂=CHCOOH) is used to prepare poly-mers, adhesives, and paints. The first step to mak...

A: The amount of propylene that must be added to the mixture in pounds per hour is to be determined.

Q: What are the methods of cleaning oil spills

A: Oil spill (liquid petroleum hydrocarbon) can be defined as leak of pour of oil into seawater as a re...

Q: Thermodynamics. A 5.0 ft3 tank contains fifty pounds of CO2. The tank safety limit is 1500 psig. Use...

A: Given that, Volume of the tank V = 5 ft3 = 0.141584 m3 Mass of carbon dioxide m = 50 lb = 22679.6 g ...

Q: Plot the level response for a tank with constant cross-sectional area of 4 ft2 as a function of time...

A: The cross-sectional area of the given tank is constant, A = 4 ft2 Initial level of water, h(0) = 1 f...

Q: A fuel containing 75% ethane and 25% propane is burned with dry air. All of the H2 burns to H2O and ...

A:

Q: The octane number of gasoline is the % by volume iso-octane in an iso-octane(C8H18) – n-heptane (C7H...

A: Given that, The octane number of gasoline is 85 30% excess air is provided for the combustion reacti...

Q: A step tracer input was used on a real reactor with the following results:For t≤10 min, then CT= 0.F...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: The Sun supplies about 1.0 kilowatt of energy for each squaremeter of surface area (1.0 kW>m2, wh...

A: The percentage of the energy of the sunlight required to produce the sucrose is to be determined.

Q: A tank holds 100 gal of a water-salt solution in which 4.0 lb of salt is dissolved. Water runs into ...

A: Let S(t) be the amount of salt (lb/min) at time ‘t’ minutes in the tank. Now, S’(t) will be the rate...

Q: A mixture of a saturated hydrocarbon and N2 is burned in excess air supplied at 25°C, 740 torrs with...

A:

Q: What are the environmental impacts of solar energy?

A: Non conventional resources such as coal used for production of energy, produces 25 times more carbon...

Q: How do ficks law of drug absorption governs the absorption process?

A: Drugs are administered far from their site of action. Hence, it is required to permeate them and cro...

Q: An operator introduces a step change in the flow rate qi to a particular process at 3:05A.M., changi...

A: