A certain gas at 30 degrees C is subjected to a pressure of 200kPa abs. if it has a volume 35 L, compute the mass of this gas. Use gas constant. R=210 N-m/kg-“K. a. 0.11kg c.0.97kg b. 0.23kg d.1.12kg

A certain gas at 30 degrees C is subjected to a pressure of 200kPa abs. if it has a volume 35 L, compute the mass of this gas. Use gas constant. R=210 N-m/kg-“K. a. 0.11kg c.0.97kg b. 0.23kg d.1.12kg

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 6RQ: One British thermal unit will raise the temperature of _____ 1b of water _____F.

See similar textbooks

Related questions

Q: A composite beam is made of two brass [E = 98 GPa] plates bonded to an aluminum [E = 64 GPa] bar, as…

Q: Two metal bars are fastened together at the bolted flange connection shown. There are 4 total bolts…

Q: Small explanation. Aerodynamic lift results from ________ Principle.

Q: d the accelerations of its ends are: a = 12 ounter clockwise direction and ag = 20 m/s clockwise…

Q: (i) determine the magnitudes of the principal stresses. (ii) determine the directions of the…

Q: he pendulum consists of a 6.5- kg circular plate and a 2.5- kg slender rod. Determine the radius of…

A: Given:mc=6.5 Kgmr=2.5 Kgd=1 ml=2 m

Q: The elevator starts from rest and moves upward with a constant acceleration. If the average…

Q: The water that is pumped into the system discharges into a tank that is weighed. It is found that…

A: Given data as per the question pressure at point A=−2.8 psi=-403.2 lbft2W=700 lb in 8 sDiameter of…

Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…

Q: What is the specific weight of air at a temperature of 30 degrees C and absolute pressure of 560…

Q: GPS 4-A smooth 2-kg collar, shown in figure, is attached to a spring having a stiffness k = 3 N/m…

A: Normal force: The response force, which is an act against the weight, is the normal force. The…

Q: A room has a facade and openings according to the figure below and a continuous fire, fully…

A: Given: Let us consider the given data, Gas temperature,Tg=700°C Ambient temperature, Ta=20°C Ai=9…

Q: a. b. C. d. A jet lands on an aircraft carrier at 60 m/s. What is its acceleration if it stops in…

A: Write the given data for air-jet. vi=60 m/svf=0t=2 s

Q: برط & Smar SOLVE sve

Q: 3. The response of a system under arbitrary force can be determined by adding the responses…

Q: You are an engineer assigned to the design team of a machinery driveshaft that can connect itself to…

Q: A liquid jet V, of diameter D, strikes a fixed cone and deflects back as a conical sheet at the same…

A: Write the force equilibrium in x-direction.…

Q: A stepped bar is held in equilibrium by several forces acting at different points along the length,…

Q: The pinion shaft is fitted with FAG inch-dimensioned tapered roller bearings mounted in O…

A: Factor of safety is a important aspect in making the structures especially for materials which are…

Q: A solid constant-diameter shaft is subjected to the torques shown. The bearings shown allow the…

Q: a scuba diver with, tank, and gear has a mass of 78 Kg. The diver and gear displace a total volumen…

Q: Q2/A/ Use the Crank-Nicolson method to solve for the temperature distribution of a long thin rod…

Q: Pulley C has an inner hub which is fixed to its outer one and turns with it. At the instant WA = 7.5…

Q: Determine the x-, y-, and z-coordinates of the mass center of the body constructed of three pieces…

Q: Q24: Briefly explain what you would change in the shown system so that less power is used to produce…

Q: 8 kunde FIG. P 5-25

Q: 6. During a winter day, wind at 70 km/h, 5°C, and 1 atm is blowing parallel to a 4-m-high and 15…

Q: system is in equilibrium. The system is pushed with an initial speed va b) a) Find the amplitude of…

Q: 5. The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this…

A: Given:P=83.4 KPaT=25°Cv=9 m/sA=2.5*1.5 m2

Q: Orthogonal turning of a mild steel tube with a tool of rake angle 10° is carried out at a feed of…

A: Given data: t1=0.14 mm/revt2=0.28 mmα=10° Need to determine the values of shear angle and shear…

Q: Q.5. For the velocity profile in laminar boundary layer: 3 2 u U 2 8 Find the thickness of boundary…

Q: The Insulated piston-cylinder assembly expands isothermally from 72.5 psi at 773.15°K to 14.5 psi.…

A: Here I'm going to calculate the work done for an isothermal process, after that I'm gonna calculate…

Q: FIND THE FORCES IN JOINT A

Q: 5-26. Body A in Fig. P 5-26 weighs 50 lb and B weighs 100 lb. The coeffi- cient of static friction…

A: Given:WA=mAg=50 lbWB=mBg =100 lbμ=0.25

Q: The shape factor F2-1 is

A: Given data, Solid sphere 1 of radius r is placed inside a hollow. Hemispherical surface 2 of raius…

Q: A Carnot engine operates on steam between 65° C and 425 °C.The ideal efficiency is:

A: Given, Temperature of hot reservoir = T1 = 425oC = (425+273) K = 698 K Temperature of cold reservoir…

Q: 5. The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this…

Q: Find the position of the cross-section’s centroid. Then, determine the moments of inertia of…

A: Draw the above given diagram. Write the centroid of all three sections. For 1,x1=6.5 mmy1=2.5 mmFor…

Q: The figure shows an anvil for an impact hammer held in a fixture by a circular pin. If the force is…

Q: What are the angles at which the approximate maximum speed is reached for the next equation? Range:…

Q: The flat surface shown is submerged vertically in water. Find the fluid force against the surface.…

Q: The composite bar shown is firmly attached to unyielding supports. An axial load P=200 KN is applied…

Q: izontal axis wind turbine having blade elocity of 20 m/see is available. What timal energy…

Q: A heat recovery device involves transferring energy from the hot flue gases passing through an…

Q: Two blocks A and B of the same mass 1.77 kg are released from rest on a 30° incline when they are S…

A: Given:m=1.77 Kgθ=30°S=9.5 mμA=0.29μB=0.36

Q: 5-24. In Fig. P 5-24, the uniform bar A weighs 100 lb and the block B weighs 40 lb. The coefficient…

A: Given:WA=100 lbWB=40 lbμ=0.40

Q: Calculate the y-coordinate of the centroid of the shaded area. The triangle is equilateral. 104 68…

A: Given data: ◆ The side of an equilateral triangle and included angle between two sides: a = 344 mm ,…

Q: The figure below shows a moving vehicle represented by two moving loads. The two loads are x = 2 m…

Q: QUESTION 1 A system consists of two rotating disks with 11-400 lbm-in2 and 12 = 100 lbm-in2…

Q: At the instant θ = 60°, the slotted guide is moving to the right with a velocity of 4 m/s and an…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
Compute the density of air inside an air conditioned room with a temperature of 20°C and a pressure of 1.01325 bar.
Solve with the correct units. Two liquids of different densities(p1=1500 kg/m3 and p2=500 kg/m3) are poured together into a 100-liter tank, filling it. If the resulting density of the mixture is 900 kg/m3,find the respective quantities of liquids used.
Prove that the density, specific weight and specific gravity of a substance are directly proportional to each other. Also calculate the density of pure water in kg/m3.
Compute the absolute pressure in kPa underneath the surface of the seawater which is 200m below the surface assuming that the density of seawater is 1200kg/m3. Let Patm = 101.325kPa a. 2494.965kPa b. 2475.345kPa c. 2455.725kPa d. 2734.329kPa
A 3-kg plastic tank has a volume capacity of 0.2 m 3 and is filled with water. What is the mass of air that the tank can carry? How many tanks can be filled by helium (SG = 0.138) if the total mass of helium is the same with that of air? How many tanks can be filled with oxygen (SG = 1.1044) if the total mass of oxygen is the same with that of air?
Capillary rise of 3 mm is noticed when a glass tube is immersed in a container containing oil of specific gravity 0.64. The contact angle of oil is 190 and surface tension of the oil at 200C in contact with air is 0.088175 N/m. Find the following: (i) Mass density of the oil in kg/m3 (ii) Capillary rise of oil in the glass tube in m of oil
The pressure at 9.85m depth in a fluid is 102,482Pa. Calculate the density of the fluid and present the answer in Pascal with accuracy up to one decimal place. Consider 1 atm = 101325 Pa. Assume the value of gravity to be 9.8 m/s2.
If a certain gasoline weighs 7,000 N/m3, determine the value of its specific volume relative to water at 15oC.
Calculate the pressure at depth 2 m using P = ρgh. p= (pressure) 19.855 kPa p= (density of the liquid) 1000 kg/m3 g= (gravity) 9.8 m/s2 h (height below the free surface of the liquid) 2m write the answer in a text form
An atmospheric pressure of 101.325 kPa will be supported by how much height of the water? a. 10.32 m b. 15.42 m c. 13.23 m d. 15.45 m
A spherical research balloon is filled with 420 m3 of atmospheric air at a temperature of 10°C. If the air inside the balloon is heated to 80°C according to PVn =C, where n = 0. What will be the final diameter of the balloon? show cancellation of units and formula used