A certain microwave oven delivers 750 watts (J/s) of power to a coffee cup containing 41.0 g of water at 35.3°C. If the wavelength of microwaves in the oven is 9.75 cm, how long does it take, and how many photons must be absorbed, to make the water boil? The specific heat capacity of water is 4.18 J/°C-g and assume only the water absorbs the energy of the microwaves. photons

A certain microwave oven delivers 750 watts (J/s) of power to a coffee cup containing 41.0 g of water at 35.3°C. If the wavelength of microwaves in the oven is 9.75 cm, how long does it take, and how many photons must be absorbed, to make the water boil? The specific heat capacity of water is 4.18 J/°C-g and assume only the water absorbs the energy of the microwaves. photons

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter10: Liquids And Solids

Section: Chapter Questions

Problem 2ALQ: Consider a sealed container half-filled with water. Which statement best describes what occurs in...

See similar textbooks

Similar questions

The heat of neutralization, Hneut, can be defined as the amount of heat released (or absorbed), q, per mole of acid (or base) neutralized. Hneut for nitric acid is -52 kJ/mol HNO3. At 27.3C, 50.00 mL of 0.743M HNO3 is neutralized by 1.00 M Sr(OH)2 in a coffee-cup calorimeter. (a) How many mL of Sr(OH)2 were used in the neutralization? (b) What is the final temperature of the resulting solution? (Use the assumptions in Question 11.)
9). What is the boiling point of the automobile radiator fluid prepared by mixing 1.04 L of ethylene glycol (HOCH2CH2OH, density = 1.114 g/mL) with 1.08 L of water (density = 1.000 g/mL)? The Kb of water is 0.520°C/m.
What is the boiling point of the automobile radiator fluid prepared by mixing 1.11 L of ethylene glycol (HOCH2CH2OH, density = 1.114 g/mL) with 1.06 L of water (density = 1.000 g/mL)?The Kb of water is 0.520°C/m.
The concentration of mercury in a polluted lakeis 4.5 ppb (part per billion), and the density of water is 1.0 g/mL. (a) Calculatethe concentration of mercury: (i)in g/L (microgram per liter), and (ii) in mol/L.(b)If the lake has surface area of 1.3km2and an average depth of 16m, how many kilograms of mercury are present in the lake?
Phenobarbital 180 mg/m 2 /24 hours given every eight hours is ordered for a childwhose BSA (body surface area) is 0.29 m 2 . How many mg will you need if the child willbe on the medication for 10 days?
When two cotton plugs, one moistened with ammonia and the other with hydrochloric acid, are simultaneously inserted into opposite ends of a glass tube that is 87.0 cm long, a white ring of NH4Cl forms where gaseous NH3 and gaseous HCl first come into contact.NH3(g) + HCl(g) ⟶ NH4 Cl(s)At approximately what distance from the ammonia moistened plug does this occur?
A company has just patented a new synthetic alcohol for alcohol beverages. You analyse asample of the new product by placing a small volume of it in a round-bottomed flask with avolume of 612.0 mL and an evacuated mass of 131.918 g. You submerge the flask in a waterbath at 100°C and allow the volatile liquid to vaporize. You then cap the flask and remove itfrom the water bath. You weight it and determine the mass of the vapour in the flask to be0.9198 g. what is the molar mass of the volatile liquid, and what does it mean with regard tothe new product? (Assume the pressure is 1 atm)
Fermentation of glucose produces ethyl alcohol and carbon dioxide;C 6H 12O 6(l) → 2 C 2H 5OH(l) + 2 CO 2(g)What is ΔH° rxn (in kilojoules) if 658.1 mL of CO 2 was collected over water at 12.00°C and 696.4 mm Hg? The vapor pressure of water at this temperature is 10.52 mm Hg. Species ΔH°f, kJ/mol C6H12O6(l) -1260 C2H5OH(l) -277.7 CO2(g) -393.5
A 315mL of water was added to 2100 mL of 19M NaCI solution. What is the newconcentration of the solution?(Use the given information: MW: Na = 23 g/mol, C1 = 35g/mol)A. 2.85 MB. 2.48 MC. 18.60 MD 19.0 M 500g of Al2S3 is dissolved in H20 to make 15.0 L of solution. What is its normality? (MW:Al=27g/mol, S=32g/mol, H=1g/mol, 0=16g/molA. 0.11 NB. 0.07 NC. 0.22 ND. 0.04 N
A core sample is saturated with an oil (?o = 35oAPI), gas and water. The initial weight of the sample is 224.14 g. After the gas is displaced by water (?w = 1 g/cm3 ), the weight is increased to 225.90 g. The sample is the placed in a Soxhlet distillation apparatus, and 4.4 cm3 water is extracted. After drying the core sample, the weight is now 209.75 g. The sample bulk volume, 95 cm3 is measured in a mercury pycnometer. Find the porosity, water saturation, oil saturation, gas saturation and lithology of the core sample.
Suppose you are overtaken by a blizzard while ski touring and you take refuge in a tent. You arethirsty, but you forgot to bring liquid water. You have a choice of eating a few handfuls of snow (say400 g) at −5.0 °C immediately to quench your thirst or setting up your propane stove, melting thesnow, and heating the water to body temperature before drinking it. You recall that the survival guide you leafed through at the hotel said something about not eating snow, but you cannotremember why–after all, it’s just frozen water. To understand the guide’s recommendation, calculatethe amount of heat that your body will have to supply to bring 400. g of snow at −5.0 °C to yourbody’s internal temperature of 37 °C. The specific heats of liquid water and ice are 4.184 J/(g•°C) and2.062 J/(g•°C), respectively, and the enthalpy of fusion of ice is 6.01 kJ/mol.
The minimum level of mercury levels in water considered safe is 1 part per billion (ppb) by weight. Ifyou did an analysis and found that the concentration was 0.59 parts per billion. What quantity of mercuryin grams was present in 8.52 L of the water, the density of which is 0.998 g/ml? (1 ppb Hg = 1 ng Hg per1 g water)