Question 10A charge of 0.5 C moves at a speed of 400 m/s at an angle of 30° to a magnetic field of strength B-0.5 T. What force does it experience?O 100 NO 87 NO 15 NO 28 NO 50 NQuestion 11A circuit consists of a 100 Q resistor, a 100 µF capacitor, and a 100 mH inductor in series. Calculate its impedance at a frequency of 100 Hz.O 840 QO 73 0

Given, Charge,q=0.5 C Velocity,v=400 m/s Angle, θ=30° Magnetic field,B=0.5 T

Answered: A charge of 0.5 C moves at a speed of…

A charge of 0.5 C moves at a speed of 400 m/s at an angle of 30° to a magnetic field of strength B-0.5 T. What force does it experience? 100 N 87 N 15 N 28 N 50 N

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 46P: Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform...

See similar textbooks

Similar questions

(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
Two rectangular loops of wire lie in the same plane as shown in Figure OQ31.11. If the current I in the outer loop is counterclockwise and increases with time, what is true of the current induced in the inner loop? More than one statement may be correct, (a) It is zero, (b) It is clockwise, (c) It is counterclockwise, (d) Its magnitude depends on the dimensions of the loops, (e) Its direction depends on the dimensions of the loops.
The magnetic field through a square loop of wire with sides of length 3.00 cm changes with time as shown in Figure P32.8, where the sign indicates the direction of the field relative to the axis of the loop. Plot the emf induced in the loop versus time. FIGURE P32.8
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
(a) If the emf of a coil rotating in a magnetic field is zero at t = 0, and increases to its first peak at t = 0.100 ms, what is the angular velocity of the coil? (b) At what time will its next maximum occur? (c) What is the period of the output? (d) When is the output first one-fourth at its maximum? (e) When is it next one-fourth at its maximum?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ31.5. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative. Figure OQ31.5
Figure P30.41 shows a compact, circular coil with 220 turns and radius 12.0 cm immersed in a uniform magnetic field parallel to the axis of the coil. The rate of change of the field has the constant magnitude 20.0 mT/s. (a) What additional information is necessary to determine whether the coil is carrying clockwise or counterclockwise current? (b) The coil overheats if more than 160 W of power is delivered to it. What resistance would the coil have at this critical point? (c) To run cooler, should it have lower resistance or higher resistance? Figure P30.41
(a) A car generator turns at 400 rpm when 1he engine is idling. Its 300-turn, 5.00 by 8.00 cm rectangular coil rotates in an adjustable magnetic field 50 that it can produce suf?cient voltage even at low rpms. What is the field strength needed to produce a 24.0 V peak emf? (b) Discuss how this required field strength compares to those available in permanent and electromagnets.
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
The bar in Figure OQ31.6 moves on rails to the right with a velocity v,. and a uniform, constant magnetic field is directed out of the page. Which of the following statements are correct? More than one statement may be correct. (a) The induced current in the loop is zero. (b) The induced current in the loop is clockwise. (c) The induced current in the loop is counterclockwise. (d) An external force is required to keep the bar moving at constant speed. (e) No force is required to keep the bar moving at constant speed.