A choke coil is connected in series with a fixed resistor. A 240 – volts, 50 – Hz supply is applied and current of 2.5 Amperes flows. If the voltage drop across the coil and fixed resistor are 140 volts and 160 volts respectively, calculate the following:   Resistance of coil ?  Inductance of the coil (?)

Q: Q4: Find the energy stored in free space for the region 2mm <r<3 mm, 0 <0<90°, 0< < 90° given V =…

A: Given voltage expression, V=300 cosθr2 volt The region, 2 mm&lt;r&lt;3 mm,  0&lt;θ&lt;90°,…

Q: An AM transmitter uses high-level modulation of the final RF power amplifier, which has a dc supply…

A:

Q: What is the value of this resistance in ohms of a 4-band resistor with color combinations of…

A:

Q: b) A periodic composite signal with a bandwidth of 2500 Hz is composed of two sine waves. The first…

A: It is given that: B.W.=2500 Hzf1=100 HzVmax1=20 VVmax2=5 V

Q: A 2-wire d.c. ring distributor is 300 m long and is fed at 240 V at point A. At point B, 150 m from…

A: It is given that: L=300mVA=240 VLAB=150mLBC=50mLCA=100mIAB=IAIBC=IA-120ICA=IA-200IB=120 AIC=80…

Q: you have a moving iron ammeter to measuring the current signal shown in figure bellow, the reading…

A:

Q: b) Explain what will happen to the Fermi level at the source contact and the drain contact in the…

A: Fermi Level : The Level in between the valence and conduction band is known as the Fermi level, when…

Q: Describe the functionality of a D-type flip-flop.

A: D-type flip-flop. It has two stable states is known as a D-type flip-flop. When operating, a D-type…

Q: I need to answer of this Control System Question

A: Given data : Gs=ks(s+3)(s+5)

Q: -3s+1 s+a = Given a plant P (s) and a model for measureable output disturbance d with transfer…

A: Given,Ps=-3s+1s+aandQs=1s+bWhere,a=4.8b=9

Q: 3. Solve the ff: a.) An FM receiver has an input S/N of 4. If the modulating frequency is 2.8 kHz…

A:

Q: is equal to the product of the midband gain and the bandwidth at any level of gain.

A: About amplifiers. Gain bandwidth product definition.

Q: Three identical impedances of 10∟53.1o ohms are connected in delta to a three-phase three-wire 240…

A: In this question,  We need to determine the line current and total power?  We know line current I=…

Q: The reactance data for the power system shown in Figur in per unit on a common base is as follows:…

A: Positive-sequence impedance network for Problem-   The positive-sequence impedance network is…

Q: Explain the trade-offs between relays and PLCS for control Applications?

A: Relay is a conventional electro mechanical device used for protection and controlling an electrical…

Q: 1.In digital modulation the information signal is one: A) sinusoidal B) sequence of logical ones and…

A:

Q: Find the transfer function, G(s) vi(t) = (+ Vi (s) Vo(s) 192 ww 1H oooo + 20 vo(t)

A:

Q: Using mesh analysis, find 1₁ and 12 from the circuit given below, where Vs1 = 66/30° V. j10 Ω 40 Ω…

A: Given circuit:

Q: For the 1-T cell memory shown in Figure below, what are the initial and final voltages of the…

A: A capacitor is a device used for storing  charges , it is a passive component having two terminals.…

Q: Given the electric flux density, D = 0.3ra.nC/min free space: (a) find E at point P(r= 2, 0 = 25., p…

A: Given: D→=0.3r2 ar^nCm2 in free space Required:  (1) find E→at point Pr=2,θ=25°,φ=90°  (2) Find the…

Q: Given the input voltage as shown below. M 1 V-5V 0.5 M2 4 M1 1 C-2 F 1.5 t(ms) The average power…

A:

Q: Explain how the following background correction techniques work: (i) beam chopping; (ii) deuterium…

A: Introduction - Background Correction (BGC) is a critical component of any spectrometric study. The…

Q: 3.In ASK modulation, the modulated wave A) has frequency changes B) is pulsating (appears as…

A: ASK modulation is known as amplitude modulation technique which is mainly used in digital data…

Q: a) Draw the energy band diagram of a MOSFET transistor, when -5 volts are applied to the drain…

A: a) We need to draw an energy band diagram of a MOSFET transistor when -5 V  are applied to the drain…

Q: A certain regulator has a percent load regulation of 1%. a) What is the unloaded output voltage if…

A: FULL WAVE BRIDGE RECTIFIER: For a positive half cycle when AC supplied voltage is positive then the…

Q: ect all that are true    A) A PID controller can always be written as an observer-based controller…

A: PID controller refers to Proportional Integral Controllers. Device used in  in industrial…

Q: each tap conductor must be sized using which table in the NEC? a. 250.166 b. 250.102(C)(1) c. 250.66…

A: According to NEC, 250.166 is used for sizing of the grounding electrode conductor for a direct…

Q: A circuit has an ac voltage source and a resistor and capacitor connected in series. There is no…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q3) In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A. The…

A:

Q: A deflection bridge shown in figure below is used to measure an unknown capacitance,Cu. The…

A: The given circuit diagram is shown below: It is given that: VS=20 VC1=10 μF=10×10-6 FR2=60 ΩR3=40…

Q: Q4 A 220 V d.c. shunt motor has an armature resistance of 0.5 ohm, and runs at 850 rpm., When taking…

A:

Q: Find the Fourier transform of x (t) = sin (10t + 0.17)

A:

Q: a) Sketch the output voltage for the following networks: R

A: The output of the circuit can be obtained by considering the state of the diode and then by using…

Q: Design a circuit to simulate the following mathematical equation using minimum number of operational…

A:

Q: Simplify the Boolean function F(w, x, y, z)=Σ (0, 2, 4, 6, 8, 10, 11).

A: We need to simplify the Boolean function

Q: What is meant by “a positive-edge flip-flop?”

A: NMOS: A transistor called an n-channel metal-oxide-semiconductor (NMOS) employs n-type dopants in…

Q: Use your own words to define the following concepts: a) c) b) Equilibrium Density of states Fermi…

A: (a) EQUILIBRIUM: According to the equilibrium equation, there can be no net force.The object should…

Q: Design a BCD-to-10 s complement converter. (using K-map).

A: 10's Complement :- For any decimal number 10's complement can find by adding 1 in 9's complement of…

Q: Express the following in engineering units. 10000 Ohms 0.025 Volts

A: Given parameters. Resistance, R=10000 Ohms Voltage, V=0.025 Volts

Q: A)- Explain the trade-offs between relays and PLCs for control Applications. (

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 7.) Draw a diagram of a CMOS setup and explain the CMOS voltage transfer character- istic. Indicate…

A: Complementary metal oxide semiconductor devices are chips in which both P-channel and N-channel…

Q: Describe the effect of resistive load on sending and receiving end voltages, Power transferred and…

A: Effect of resistive load on sending and receiving end voltages, power transferred and Power factor.…

Q: An interaction between two elementary particles causes an electron and a positron to be shootout…

A: Given data, r=100 fm = 100×10-15 m

Q: P 12.3-7 A balanced Y-Y circuit is shown in Figure P 12.3-7. Find the average power delivered to the…

A: It is given that:

Q: 7) For the sequence {1, 0, 1, 0}, IDFT will be None of the above {0.5, 0, 0.5, 0} {1, 1, 0, 1} {0.5,…

A: Given data, Yk=1,0,1,0 Length of the sequence N=4

Q: 1. A three-phase, three-wire CBA system with an effective line voltage of 106.1 V, has a balanced…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Find the Inverse Laplace Transform

A: Inverse Laplace is a math tool. It is used to convert the complex domine to time domine.

Q: A 470 ohm resistor has 18.8 volts across it. What is the power consumed by that resistor? Enter your…

A: Given, Resistance, R = 470 ohm Voltage across it, V = 18.8 volts

Q: B) Determine the internal optical power of the double hetetostructure LED has 85% quantum efficiency…

A:

Q: What is the output F of the following circuit? +2.5 V OVO 2.5V 5V Unknown OV Logic 1 Mp1 MNI +2.5 V…

A: Answer:0V