b) A chopper is operated at 50HZ with the input voltage , Vin=100V and supplies a 25V atload. Given L=200mH, C = 70µF and R= 20n. Calculate the duty cycle, average inductorcurrent,maximum inductor current, IL(max) ,minimum inductor current, IL(min) , peak to peakripple voltage of the capacitor and ripple factor.Sebuah pemenggal dikendalikan pada 50Hz dengan voltan input, Vin=100V dan bekalan25V pada beban. Diberi L = 200mH, C = 70µF dan R= 200. Kira kitaran duti, arusperaruh maksimum, IL(max) , arus peraruh minimum, IL(min) dan voltan riak puncak kepuncak kapasitor dan factor riak.

Given f=50 Hz Vin =100 V Vout =25 V L=200 mH C=70 μF R=20 Ω

A chopper is operated at 50HZ with the input voltage , Vin=100V and supplies a 25V at load. Given L= 200mH, C = 70µF and R=20n. Calculate the duty cycle, average inductor current,maximum inductor current, IL(max) ,minimum inductor current, IL(min) , peak to peak ripple voltage of the capacitor and ripple factor.

A chopper is operated at 50HZ with the input voltage , Vin=100V and supplies a 25V at load. Given L= 200mH, C = 70µF and R=20n. Calculate the duty cycle, average inductor current,maximum inductor current, IL(max) ,minimum inductor current, IL(min) , peak to peak ripple voltage of the capacitor and ripple factor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Similar questions

Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
A LRC electric circuit is conected in series has a voltage source of E(t)=20sin(10t) Volts, and a resistance of 20 ohm, and a inductance of 0.05 Henrys and a capacitor of 0.01 Farads, if the current equal to 0, and the initial charge of the capacitor is 2 coulombs, Calculate the charge in the capacitor when t=0 and the current in the circuit when t > 0
Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic impedance of 50 ohms; capacitance is 40 pF/m and an inductance equal to 50 microH/m.
A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is connected at source end which is delivering 0.5 Pu of active power and the transmission line is compensated with a series capacitance of 0.5 Pu. Find the load angle with series capacitance compensation ?
An RG-8/u coaxial cable line has a 50 W characteristic impedance and a nominal capacitance of 10 mF/ft. What is the outer diameter if the wire conductor inside diameter is 0.023 inches and the dielectric constant of the insulation is 2.23?
Given the capacitance of four capacitors Ca= 30 µF, Cb = 20 µF, Cc = 40 µF and Cd = 10 µF. If Cb and Cc are connected in parallel and the parallel combination is connected in series with Ca and the combination is further connected in parallel with Cd, calculate (a) the equivalent capacitance (b) the voltage across each capacitor if the circuit is supplied by 240 volts DC source (c) the charge on each capacitor.
Method: Transient Analysis Solve for Current and Voltage at 20 ms and 100 ms for: Capacitor 1 (C1) (20 microFarad) Capacitor 2 (C2) (10 microFarad) Inductor (L1) (10 mH) Resistor 1 (R1) (500 ohms) Resistor 2 (R2) (200 ohms) Voltage: 25 V, 1000 Hz
An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms. What is the inductance of the cable per foot.
A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
For the configuration shown in the figure below, determine Zi if Vs = 40 mV, Sense = 0.5 kΩ, and Ii = 20 µA
Determine the value of a capacitor that has the reactance provided at the given frequency at 1.56 kohms at 1.2 kHz and 3.35 kohms at 5.6 kHz
Calculate the value of capacitance required to produce 110 Ω of reactance at 750 MHz. Round the final answer to one decimal place. Take the value of pi (π) as 22/7. pF