A circuit has a voltage of 5020 V and a current of 52-10 A. The angle of the circuit's impedance is
Q: disadvantages of potential transformer.
A: Potential transformers, which drop a circuit's voltage to a lower voltage for measurement, are also…
Q: A field of strength 5 × 10 ampere turns / meter acts at right angles to the coil of 50 turns of area…
A:
Q: Q1. Q2. Q3. The governor of a grid connected steam generating unit controls the following (a) grid…
A: Note: As per the policy we can solve only 3 questions, please re-upload the remaining question as a…
Q: 4. What is the voltage gain of an inverting op-amp in which the feedback resistor has a value of…
A:
Q: 3 V 1Ω M 1/6 F Figure Q1(b) t=0 + vc(1) 2/3 H
A:
Q: Determine the equivalent frequency domain impedance, Z for the circuit shown in Figure Q2(a). Z ΖΩ…
A:
Q: and (c) are How many parallel paths are there in the armature windings of Prob. 1, if (a), (b),…
A:
Q: Nodes A to B has a voltage drop of 5.0 cos (2t + /3. Nodes A and D is connected by 0.2 F capacitor.…
A:
Q: A three phase A-Y connected transformer with 50 MVA, 33:11 kV is protected with a differential…
A: When designing a relay, circuit breaker, or other protective equipment, keep in mind that power…
Q: A 3phase synchronous motor of 8000W at 1100V has Synchronous reactance of 8ohm per phase. find the…
A: It is given that: Pout=8000 WVL=1100 VXS=8 Ωη=0.8
Q: Q3 Based on the FET amplifier circuit shown in Figure Q3, name the transistor and its configuration.…
A:
Q: 1. Nodal Analyris 1 JAĴ 10 um IOLO (c Ej5 4 m | 10L 30" GE j8 3 REQUIRED: IA, IB, IC, ID 9 LE BE LET…
A:
Q: What will be the resultant capacitance of the given combination? 1mF 2mF 3mF 4mF = 5 mF
A: Given data, Circuit diagram is given as,
Q: The power input to a 3-phase induction motor is 60 kW. The stator loses a total of 1kW. find the…
A: The term "induction motor" refers to a motor that operates on the electromagnetic induction…
Q: Find the IRMS
A:
Q: Assuming the barrier potential at the junction for silicon and germanium to be respectively 0-7 V…
A: (a) The circuit is shown below: The above diode is in forwarding bias, applying K.V.L in the above…
Q: Problem 8. For the circuit shown in Figure 5.14, find (a) the value of the supply voltage V and (b)…
A: Given circuit,
Q: The quality factor of a bandpass filter that has an upper cutoff frequency of 121 krad/s and a lower…
A: Given, Upper cutoff frequency, ωH=121 kradsec Lower cutoff frequency, ωL=100 kradsec
Q: A thermally conducting solid bounded by two concentric spheres of radii a and b. a<b, is such that…
A: Given that the temperature of the inner surface is T1 The temperature of the outer surface is…
Q: Fill-in Questions: 1. The Zener diode is usually operated on the 2. The Vz of a Zener diode will…
A: GIVEN: two circuit diagrams FIND: fill the blanks on bases of given circuit diagram (1)…
Q: An RC High-pass filter consists of 5 nF capacitor and a 50 K resistor. The output voltage is taken…
A: Given, An RC high pass filter consists, Capacitance, C=5 nF Resistance, R=50 kΩ
Q: A 400V, 3-phase Induction motor has input power of 14 KW and operates at power factor of 0.87…
A: Given data, A 400 V, 3-phase induction motor has Pin=14 kWcosϕ=0.87 laggingη=86% Two wattmeter…
Q: A cylindrical wire has length 40 cm, cross-sectional area 60 mm², and resistance 3.0 22. The wire is…
A: Given data, The length of wire is 40 cm, The cross-section area of the wire is 60 mm2, The…
Q: A unity feedback system has an open-loop transfer function K G(s) s(s+10)* If the damping ratio is…
A: Given: Open loop transfer function, Gs=Kss+10 With unity feedback, Hs=1 Damping ratio, ζ=0.5
Q: Vs Zs -↑ + V₁ Two-port Network Figure Q4(a) 1₂ ↑ + V₂ ZL
A:
Q: e(s) Git H₂ 4 ਉਪਰ ਤ H3 H₂ ($) H₁ ੭} G ( s),
A:
Q: 2. For the half-wave rectifier shown below, the cut-in voltage is 0.7 V. Sketch the voltage transfer…
A: Given circuit is a Half wave rectifier we have asked to solve vi,vii,viii,ix,x, Note: output we…
Q: What will be the resultant capacitance of the given combination? 1mF=2mF 3mF=4mF= 5mF
A: Given circuit,
Q: A 40 2 resistor, a 5 mH inductor, and a 1.25 µF ca- pacitor are connected in series. The…
A: Given here a data related to RLC series circuit and asked to solve for current.
Q: what are the advantages of root locus? need of feedback ?
A: The root locus is a graph that displays the position of a system's poles (the roots of the…
Q: Q1. For the scheme shown in figure Q1, using the message signals spectra shown a) Draw the spectrum…
A: All the frequency are written in kHz. Now adding M1'(f) and M2'(f), we get, cos220,000 πt=1+cos…
Q: How could you make compensated silicon that has twice as many acceptors as donors?
A: To make a compensated silicon semiconductor that has twice as many acceptors as donors, the silicon…
Q: A 4 pole wave connected, armature of the DC shunt wound generator is connected to the following…
A:
Q: Problem 14. A long transmission line has a char- acteristic impedance of (500-j40) S2 and is termin-…
A: Given data, Characteristics impedance Z0=500-j40 Ω Load impedance ZL=500+j40 Ω
Q: What is tungsten,CFL,led bulb... Which one save electricity and why
A: The endeavour to lower energy consumption by utilising fewer energy services is known as energy…
Q: Find the reactance of a 0.45 H inductor at 60 Hz frequency. At what frequency is the reactance 500…
A:
Q: Why is voltage the same across a parallel circuit? 2. Explain why, for a parallel resistive circuit,…
A:
Q: A balanced Y-connected load absorbs in total 3 kW at a power factor of 0.6 lagging. If th line…
A: Given, A balanced Y-connected load absorbs, Total power, PL=3 kW Power factor, cosθ=0.6 lagging Line…
Q: 6. Using source conversion find current in 202 resistor of the circuit shown in fig.2. GIET 2A www…
A: The circuit is shown below: Using the source transformation, the current source in the above…
Q: A 220 V, 10 kW, 900 rpm separately excited DC motor has an armature resistance Ra=0.020. When the…
A: Given a separately excited DC motor having, Terminal voltage, V=220 V Speed, N = 800 rpm Armature…
Q: Find VGS and VDS for the E- MOSFET in the figure shown. The Datasheet information is listed with the…
A:
Q: Given the field: D = 20 } [–sin20 ap + sin 2 a Find the total charge lying within the volume 1<p <…
A:
Q: 3. A coil consists of a Resistance of 980and an inductance of 180 mH. if an alternating voltage v-…
A:
Q: 8. Determine the reluctance of a materi- al with a length of 0.28 m and a cross- sectional area of…
A: Given: A material has Length, L=0.28 m Cross sectional area, A=0.08 m2 Absolute permeability,…
Q: 1- find he transfer function H(jw)= Vo(jw)/Vs(jw). 2- find the kind of the filter, center frequency,…
A:
Q: 5 advantages and 2 disadvantages of electrical illumination
A: Advantages of electrical illumination 1) Low maintenance – Longer life reduces the need for…
Q: For the circuit in Fig. 3.51, obtain vi and vg. 10 Ω ww 11 Μ 5Ω 2 Ω 64 4Ω Μ 1/2 Ο 34
A: Circuit is given as:
Q: An RC high pass filter consists of an 820 W resistor. What is the value of C so that Xc is t times…
A: Given an RC high pass filter consists, Resistance of resistor, R=820 W Input frequency, f = 12 kHz…
Q: f) For the circuit shown, determine i, and i2. 20 mA www. 6 ΚΩ www ΑΚΩ
A: Given circuit,
Q: Q3 Represent the following function as a K-map and simplify it F(w,x,y,z) =(0, 1, 2, 4, 5, 6, 8, 10,…
A: In this questions, we need to simplify the expression using the Kmap.
Step by step
Solved in 2 steps
- assume that the circuit is connected to a 400 hz line and has a total impedance of 21.6 ohms the resistor has resistance of 36 ohms and the capacitor has a current flow of 2 A through it fid the missing valuesThe actual impedance of a system is 300 Ω. The base kVA is 300 kVA, and the base voltage is 11 kV. What is the actual impedance with 400 kVA and 38 kV as base values? a. 300 b. 33.52 c. 0.744 d. 0.083Please answer this question and show the solution. What is the value of reactive power in a RL series circuit with a supply voltage of 220V, 60Hz and has a component of 12 ohms and 30mH?
- In a series circuit of R = 5 ohms and L = 0.03H the current lags the applied by 80 deg. What is the complex impedance?Finding equivalent impedance using phasor formAnd question 2 finding iWhat is the nature of a circuit if its total impedance is 4-j4 ohms? Group of answer choices reactive capacitive inductive passive
- 10.3µF ,10µF 300Ω ,200Ω, 1.3H, and 0.7H circuit elements are connected in series at 220V 50Hz. Solve and analyze the circuit? What feature does it work in? Find the power factor of the circuit current, circuit?TOTAL IMPEDANCE FIND CIRCUIT ( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).A series RL circuit in which R=5 ohms and L=20 mH has an applied voltage e=100+50sinwt+25sin3wt with w=500 radians per sec. Determine the power dissipated in the resistor of the circuit.
- Which of the following statements is true of a shorted component in a series circuit? a. The resistance of the component will be higher than normal. b. The voltage drop across the component will be higher than normal. c. The current through the component will be lower than normal. d. The voltage drop across the component will be lower than normal.HW/5 Determine the i; and I;. for the circuit shown below, for t>0. 3mHCalculate the current and total impedance for the circuit below. Put in polar and rectangular form