What will be the resultant capacitance of the given combination? 1mF=2mF 3mF=4mF= 5mF

Q: Problem 14. A long transmission line has a char- acteristic impedance of (500-j40) № and is termin-…

A: Given a long transmission line with, Characteristics impedance, ZO=500-j40 Ω Terminated in an…

Q: A modulation frequency range from 30 to 15000 Hz is permitted in an FM system, together with a…

A:

Q: Q1) Consider a two point charges Q1-1 nc at (1,2,3), and Q2= 2nc at (2, 30, 90) in free space. Find:…

A: Solution is attached with this notes. Thank you.

Q: When connected to a 4-ohm resistor, a battery has a terminal voltage of 6.5V. If the open-circuit…

A:

Q: a) Can you compute y[n] = x[n] *h[n] with N = 5 point DFT? If yes, explain your algorithm. If no,…

A: +

Q: Use the diagram below for questions 11-17 12V 22 11. If current flow at point F is 3 amps and…

A:

Q: An EM wave progating in a certain medium is described by E = 31 sin(3922.8 x 10°t - 9.2x) az V/m…

A: Given: EM wave E=31sin3922.8×106t-9.2xaz V/m

Q: Design a circuit with a decoder( use block diag for decoder) for 3 bit binary inputs A,B,C that…

A:

Q: (c) Find Ix in the circuit. 4 mA Ix 31x

A: Given circuit,

Q: A uniform cylindrical shell has inner radius 6.39 meters, outer radius 19.31 meters, and length…

A:

Q: determine the current flowing in branch IAB

A:

Q: Calculate Required size of core and calculate number of turns in primary and secondary for small…

A: It is given that: Vs or Vo=12 VIo=3 AVp=230 Vf=50 Hzη=90%

Q: By applying conservation of power, find the current i_x in the circuit of the figure shown. The…

A: Given circuit, where, P1=24 WP2=-60 WPR=2.25ix2

Q: (e) Determine the voltage in the circuit. 12 V 10 V 8V

A: Given circuit:

Q: Question # 1 a) A certain filter has the following transfer function. 1500 H(jw)= (jw+50)² Find the…

A:

Q: QUESTION 3 Determine Vout. +30 V Vin OV -30 V Vout at Vin = +30V = Vout at Vin = -30V = www 2.2 ΚΩ…

A: assuming the diode is ideal, 1) If Vin=30V ,diode will be in reverse bias condition and hence it…

Q: discuss the application of nyquist criterion to determine stability of a closed loop control system

A: Nyquist criterion: Nyquist criterion is a tool widely used to determine the stability of a system.

Q: Vas Ic=1mA. If R = 400 52 and R = 5 k2, find AM and f by using the Miller's theorem.. Rus B www + HH…

A:

Q: Nodal Analyvis

A:

Q: = 0.22 kn, Zener The Zener regulator circuit in Figure Q1 has the following values: R₁ voltage, V₂ =…

A:

Q: 10k ww R₁ Ry = ? www OP-AMP V₁=1V V₁= 10v

A:

Q: A system has 30% overshoot and settling time of 5 sec for unit step input. The resonant peak of the…

A: Given, System has overshoot, MP=30%=0.3 Settling time, ts=5 s For unit step input.

Q: Is it more efficient if the transient response is high or is it more efficient if the transient…

A: In general systems, we require the response to any change in the voltage to be faster, hence the…

Q: If the voltage sources in the circuit shown are converted to current sources and then combined, what…

A: Given here a electrical circuit and asked to convert the voltage sources to current and asked to…

Q: Given a ring of radius 6.27 meters and total charge 18.38 nanocoulombs distributed evenly throughout…

A:

Q: A unity feedback system has an open-loop transfer function K G(s) s(s+10)* If the damping ratio is…

A: Given: Open loop transfer function, Gs=Kss+10 With unity feedback, Hs=1 Damping ratio, ζ=0.5

Q: 9. A coil has a resistance of 10 ohms and a time constant of 1 second. If the coil is connected…

A:

Q: av + Switch Iks I malt

A:

Q: How can we Calculate the electric potential of important charge distributions?

A: Electrical potential due to continuous charge distribution can be find taking a small potential dv…

Q: 1. In the below circuit, find the current /through 1 Ohm resistor using Thevenin’s and Norton's…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: e) calculate the input impedance, Zi, output impedance, Z, and voltage gain, Av.

A: It is given that:

Q: or the common emitter amplifier circuit in Figure Q4(a), determine the low cut- ff frequency for…

A:

Q: Find the voltage across the capacitor terminal at time 1 ms for the circuit below. ww R 10 Ω 100 V…

A: Given here a RC series circuit and asked to find the voltage across the capacitor after 1msec .

Q: How could you make compensated silicon that has twice as many acceptors as donors?

A: To make a compensated silicon semiconductor that has twice as many acceptors as donors, the silicon…

Q: The radar in which both transmission and ception is done using the same antenna are called:

A: The solution is provided in the following section.

Q: 4. What is the Boolean expression for the AND-OR logic diagram B B

A: Given, The logic circuit

Q: A parallel RLC resonant circuit has a quality factor Q-80, and a resonant frequency of 200 krad's.…

A:

Q: The following equality gives S₁ in terms of Z-Parameters for a 2-port network. • Show all steps in…

A: Given: The following equality gives S11 in terms of Z-Parameters for a 2-port network:…

Q: 500 V 470 Ω Μ 470 Ω Figure 5-9 470 Ω he total current flowing in the circuit in Figure 5-9 is:

A: Given data, Circuit diagram is given as,

Q: s[k] h x[k] n[k] r[k] W g[k] Decision Device u[k] = s[k-d] 1. Figure 1 above is schematic…

A: Two possible usage for that block So we have to understand followings points...

Q: find the power dissipated in the 6 resistor.

A: As in the above circuit resistances are in parallel and in series so, We will be using following…

Q: 1. For the circuit given below plot the output waveform indicating positive and negative peak…

A: We have analyzed the circuit in the positive and negative half cycle. In the positive half cycle…

Q: Consider the half-wave inductive-load rectifier circuit of Fig. 2 with R-L load and vs = 110√2sinut…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: (b) Based on the combined circuit (series and parallel) as shown in FIGURE Q1(b), answer the…

A: Given here a electrical circuit and asked to find the total resistance and total current and I1 , I2…

Q: A balanced Y-connected load absorbs in total 3 kW at a power factor of 0.6 lagging. If th line…

A: Given, A balanced Y-connected load absorbs, Total power, PL=3 kW Power factor, cosθ=0.6 lagging Line…

Q: Q3.A. A TV station is transmitting 10 kW of power with a gain of 15 dB towards a particular…

A: We need to find out electric field at given point due given power

Q: At 40 °N latitude (p) Determine (i) (ii) (iii) The direct normal extra-terrestrial irradiance (Io)…

A: Given:  The latitude = 400N Following equations are given with their usual notations…

Q: P.2.16: You are given two z-directed line charges of charge density +1 nC/m at x = 0, y = -1.0 m,…

A:

Q: Q5. Consider x[n] as given below. x[n] = {"(- -n(-1)"-3, -3≤n≤2 otherwise

A: In the question x[n] is given in the range of n from -3 to 2. In part C , circular time advancement…

Q: 3. A relay coil has a resistance of 500 ohms and inductance of 10mH. The triggering current of relay…

A: Solution is attached with this notes.Thank you.

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.