A circular wire coil with 28 turns and radius 3.92 cm is placed in a uniform magnetic field of strength 8.56 T, directed perpendicular to the plane of the wire loops. Over a period of 3.98 s, the magnetic field fades away to zero. What is the average induced emf (voltage) in the coil over this period of time? 0.291 V O 0.175 V O 0.364 V

A circular wire coil with 28 turns and radius 3.92 cm is placed in a uniform magnetic field of strength 8.56 T, directed perpendicular to the plane of the wire loops. Over a period of 3.98 s, the magnetic field fades away to zero. What is the average induced emf (voltage) in the coil over this period of time? 0.291 V O 0.175 V O 0.364 V

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter23: Faraday’s Law And Inductance

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A circular loop of wire with a radius of 4.0 cm is in a uniform magnetic field of magnitude 0.060 T. The plane of the loop is perpendicular to the direction of the magnetic field. In a time interval of 0.50 s, the magnetic field changes to the opposite direction with a magnitude of 0.040 T. What is the magnitude of the average emf induced in the loop? (a) 0.20 V (b) 0.025 V (c) 5.0 mV (d) 1.0 mV (e) 0.20 mV
A metal bar of length 25 cm is placed perpendicular to a uniform magnetic field of strength 3 T. (a) Determine the induced emf between the ends of the rod when it is not moving, (b) Determine the emf when the rod is moving perpendicular to its Length and magnetic field with a speed of 50 cm/s.
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ23.9. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative.
In a 250-turn automobile alternator, the magnetic flux in each turn is B, = 2.50 104 cos t, where is in webers, is the angular speed of the alternator, and t is in seconds. The alternator is geared to rotate three times for each engine revolution. When the engine is running at an angular speed of 1.00 103 rev/min, determine (a) the induced emf in the alternator as a function of time and (b) the maximum emf in the alternator.
To monitor the breathing of a hospital patient, a thin belt is girded around the patients chest as in Figure P20.21. The belt is a 200-turn coil. When the patient inhales, the area encircled by the coil increases by 39.0 cm2. The magnitude of Earths magnetic field is 50.0 T and makes an angle of 28.0 with the plane of the coil. Assuming a patient takes 1.80 s to inhale, find the magnitude of the average induced emf in the coil during that time. Figure P20.21
A flat, square coil of 20 turns that has sides of length 15.0 cm is rotating in a magnetic field of strength 0.050 T. If tlie maximum emf produced in die coil is 30.0 mV, what is the angular velocity of the coil?
A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.00 V when the wheels rotate at = 20.0 rad/s. (a) If the generator's magnetic field has magnitude B = 0.600 T with N = 100 turns, find the loop area A. (b) Find the time interval between the maximum emf of +6.00 V and the minimum emf of 6.00 V.
A 2.00-m length of wire is held in an eastwest direction and moves horizontally to the north with a speed of 0.500 m/s. The Earths magnetic field in this region is of magnitude 50.0 T and is directed northward and 53.0 below the horizontal. (a) Calculate the magnitude of the induced emf between the ends of the wire and (b) determine which end is positive.