A clay layer 25 feet thick is overlain with 50 feet. thick of sand with specific gravity of 2.71. The water table is 20 feet below the sand surface. The saturated unit weight of clay is 141.0 pcf. The sand below the water table has a unit weight of 128.0 pcf. The sand above the water table has an average moisture content of 20.0%. After drying the sand was found to have a dry unit of 92.0 pcf. Determine the effective stress at the mid-height of Lhe clay layer.

A clay layer 25 feet thick is overlain with 50 feet. thick of sand with specific gravity of 2.71. The water table is 20 feet below the sand surface. The saturated unit weight of clay is 141.0 pcf. The sand below the water table has a unit weight of 128.0 pcf. The sand above the water table has an average moisture content of 20.0%. After drying the sand was found to have a dry unit of 92.0 pcf. Determine the effective stress at the mid-height of Lhe clay layer.

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.15P

See similar textbooks

Similar questions

50 ft thick sand is underlain by 25 ft clay. The ground water table, initially at the ground surface, was lowered to a depth of 25 ft below the ground. After such lowering, the degree of saturation of the sand above water table was lowered to 20%. Saturated and dry unit weight of sand are 135 pcf and 116 pcf respectively. The saturated unit weight of clay is 120 pcf. a. what is the unit weight of the sand above the water table after lowering in pcf? b. What is the vertical effective pressure at the midheight of the clay layer when the water table is lowered 50 ft. Below the ground in psf?
a deposit of clay underlain a 4.5m thick sand. the degree of saturation of sand is 37%, the void ratio is 0.52. the moisture content of clay is 42 %. the natural groundwater table is located at 2m below the natural ground surface. assume that the sp.gr. of sand and clay are both 2.65. compute: unit weight of sand above the water table effective pressure at point 10m below the ground surface total pressure at point 10m below the ground surface
A sand with Gs= 2.66 and void ratio e=0.60 is completely dry. It been becomes wetted by a rising groundwater table. Compute the unit weight in KN/cu.m. under the following conditions:a) When the sand is completely dryb) When the sand is 40% saturatedc) When the sand is completely saturated
A certain saturated sand (S = 100,) has a moisture content of 25.1 percent and a specificgravity of solids of 2.68. It also has a maximum index void ratio of 0.84 and a minimum indexvoid ratio of 0.33. Compute its relative density and classify its consistency.
A soil layer consists of 4m upper layer of dry sand have a Gs= 2.64 and a void ratio of 0.53 and a lower layer is a clay having a void ratio of 1.0 and a specific gravity of 2.75. The effective stress at the bottom of the clay layer is equal to 93.46 kPa when the ground water is table is 4m below the ground surface. What is the thickness of the clay layer?
The profile at a site consists of 5m of sand overlying 10m of compressible clay, which in turn overlies a dense sand. The water table is at the top of the profile. The total unit weight of the top sand is 19kN/m3 and that of the clay is 18kN/m3. The Cv of the clay is estimated to be 5x 10-3 cm2/sec. Initially the clay is normally consolidated. It is planned to place a temporary fill that will exert a vertical load of 200kPa over the entire site. How long must the fill be in place so that, after it is removed, the maximum past pressure at every point in the clay is at least 50kPa larger than the vertical effective stress that existed before the fill was placed?
A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60. Under this layer is a 2.5m deep clay profile with a specific gravity of 2.7 and a moisture content of 30%. The water table is observed at 1m below the ground surface. Under the clay layer is a sand profile. a.) Determine the degree of consolidation. If the ground surface has a surcharge of 75kPa. b.)Determine the effective soll pressure at the midweight of clay. c.) Determine the compression index of a normally consolidated clay after the surcharge of 75kPa. Clay is observed to have à vold ratio of 0.40 after the surcharge. (Assume unit weight of soil profile above the clay layer is the same when the soil was not subjected to surcharge load) Answer in 3 decimals Pls answer asap
A layer of sand extends from group level at 9m and overlies a layer of clay of very Low permeability 6m. The water table is 6m below the surface of the sand the saturated unit weight of the sand is 19kn/m3.and that of the clay 20kn/m3.the unit weight of the sand above the ? table is 17kn/m3 .over a short period of time the water table lower by 3m. And expected to remain permanently at that Level. Determine the effective vertical stress at depth of 8 and 12m. Below the ground level.(a) immediately after the lowering of water table (b) several years after the lowering of the water table. Explain your answer for each step.
3. A sand has a natural water content of 5% and bulk unit weight of 18.0 kN/m3. The void ratios corresponding to the densest and loosest state of this soil are 0.51 and 0.87. Find the relative density and degree of saturation.
A soil layer consists of 4 meters upper dry sand with a void ratio of 0.45 and a specific gravity of 2.70. The lower 3 meters is clay having a void ratio of 0.9 and a specific gravity of 2.75. The ground water table is 4 meters below ground surface. Compute a) effective stress at 4 meters below ground surfaceb) effectivestress at the bottom of the clay layer c) effective stress at 6 meters below ground surface.
A sand with G, = 2.66 and e = 0.60 is completely dry. It then becomes wetted by a rising groundwater table. Compute the unit weight (lb/ft³ or kN/m³) under the following conditions: (a) When the sand is completely dry (b) When the sand is 40% saturated (S = 40%) (c) When the sand is completely saturated.
A 400 cm³ volume of moist sand weighs 1020 gm. Its dry weight is 918 gm and specific gravity of solids, G is 2,67. Assuming density of water as 1 gm/cm³, the void ratio is