A clean tube of diameter 2.5 mm is immersed in a liquid with a coefficient of surface tension equal 0.40 N/m. The angle of contact of the liquid with the glass can be assumed to be 135°. The density of the liquid equal 13600 kg/m³. What would be the level of the liquid in the tube relative to the free surface of the liquid inside the tube? -3.93 mm -9.39 mm -3.39 mm Nothing mentioned -3.33 mm

A clean tube of diameter 2.5 mm is immersed in a liquid with a coefficient of surface tension equal 0.40 N/m. The angle of contact of the liquid with the glass can be assumed to be 135°. The density of the liquid equal 13600 kg/m³. What would be the level of the liquid in the tube relative to the free surface of the liquid inside the tube? -3.93 mm -9.39 mm -3.39 mm Nothing mentioned -3.33 mm

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

The surface tension of fluid in contact with air at 25oC is 0.51 n/m. The pressure inside a droplet is to be 0.05 N/cm2 greater than outside pressure. Determine the diameter of the droplet
Step by Step Determine the distance that the column of fluid will rise in a 1-cm open tube when the tube is inserted in fluid with a density of 990 kg/m^3 and a surface tension of 0.09 N/m. Provide answer in cm and assume a contact angle of 0-degree.
A 1.6-mm-diameter tube is inserted into an unknown liquid whose density is 960 kg/m3, and it is observed that the liquid rises 5 mm in the tube, making a contact angle of 15°. Determine the surface tension of the liquid.
The pressure on the suction side of pumps is typically low, and the surfaces on that side of the pump are susceptible to cavitation, especially at high fluid temperatures. If the minimum pressure on the suction side of a water pump is 0.70 psia absolute, determine the maximum water temperature to avoid the danger of cavitation.
The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and the U-tube contains 20 cm high alcohol in both arms. Now the U-tube is rotated about the left arm at 4.2 rad/s. Determine the elevation difference between the fluid surfaces in the tow arms.
Consider a U-tube whose arms are open to the atmosphere. Now water is poured into the U-tube from one arm, and light oil (ρ = 790 kg/m3 ) from the other. One arm contains 70-cm-high water, while the other arm contains both fluids with an oil-to-water height ratio of 4. Determine the height of each fluid in that arm.
The clutch system shown in the figure is used to transmit torque through a 2 mm thick oil film with μ = 0.38 N.s/m2 between two identical 30 cm diameter disks. When the driving shaft rotates at a speed of 1450 rpm, the driven shaft is observed to rotate at 1398 rpm. Determine the transmitted torque.
The barometric pressure at the base ofmountain is 750 mm Hg and at the top is600 mm Hg. If the average air density is1kg/m3, the height of mountain (in m) isapproximately- A 1500 B 2040 C 7500D 1200
An open barge has the dimensions shown in the figure. If the barge is made out of 5.5-cm-thick steel plate on each of its four sides and its bottom, what mass of coal can the barge carry in freshwater without sinking? Is there enough room in the barge to hold this amount of coal? (The density of coal is about 1500 kg/m3.)
A piston with an outer diameter of 124.75 mm and a length of 75 mmis pushed upwards at a constant velocity of 6 m/s in a cylinder whichhas an inner diameter of 125 mm. A pressure of 1 kPa acts on theupper side of the piston and the piston has a mass of 2 kg. The gapbetween the piston and the cylinder is filled with an oil with aviscosity of 0.26 Ns/m^2. Determine the power that is required to push the piston upwards.(assume a linear velocity distribution in the gap)
The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and the U-tube contains 20 cm high alcohol in both arms. Now the U-tube is rotated about the left arm at 4.2 rad/s. Determine the elevation difference between the fluid surfaces in the tow arms. Include the free body diagram in your solution. a.0.96 m b.0.67 m c.0.33 m d.0.81 m
The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and the U-tube contains 20-cm-high alcohol in both arms. Now the U-tube is rotated about the left arm at 3.5 rad/s. Determine the elevation difference between the fluid surfaces in the two arms.