A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lbs/ft2, (the unconfined compressive strength (qu) is 3850 lbs/ft2). Determine the soil's cohesion. (answer in lbs/ft2)

A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lbs/ft2, (the unconfined compressive strength (qu) is 3850 lbs/ft2). Determine the soil's cohesion. (answer in lbs/ft2)

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter12: Shear Strength Of Soil

Section: Chapter Questions

Problem 12.18P

See similar textbooks

Related questions

Q: A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a…

A: To determine the soil cohesion-

Q: A cohesionless soil sample is subjected to a triaxial test. The critical state friction angle of the…

A: Given friction angle is 28 degrees

Q: Three samples of Soil were collected during soil exploration for the construction of a Highrise…

A: To determine: The most appropriate test to determine shear strength parameters for each of the…

Q: A sample of saturated cohesionless soil tested in a drained triaxial compression test showed

Q: A consolidated drained (CD) triaxial test was conducted on a granular soil. At failure the cell…

A: Given data : Deviator stress (σd)=8505 psfConfining pressure (σ3')=3150 psf

Q: A soil has a void ratio of 0.6 under a normal stress of 105 kPa. It is required to reduce the void…

A: Given: Normal stress 1 = 105 kPa Void ratio 1, e1 = 0.6 Void ratio 2, e2 = 0.45 Compression index,…

Q: The corresponding toughness index and liquidity index of the soil specimen,

A: Given. For laboratory investigations, liquid limit-60% plastic limit- 27% natural moisture- 32%…

Q: Three samples of loose sand were tested under consolidated undrained (CU) conditions. The failure…

A: Given data- Consolidated Undrained (CU) Test- Cell Pressure σc=206 kPaDeviators Stress σd = 122…

Q: A unconfined compressive strength test was performed on a clay sample. The sample had a diameter of…

Q: Tick ALL that are are related with Oedometer test of cohesive soils □ One-dimensional consolidation…

Q: A normally consolidated soil was subjected to tri-axial test with the following data: cell pressure=…

A: Compute the shear stress on the failure plane?

Q: A consolidation test has been performed on a sample obtained from a saturated clay at a point 12m…

A: To determine is the given soil is under consolidated, normally consolidated or over consolidated.…

Q: A consolidated-undrained test on a normall consolidate clay yield the following results: Confining…

A: Given:- Confining pressure = 160 kPa Deviator stress = 181 kPa Pore pressure = 77 kPa To find:- From…

Q: The following data are given for a specimen of soil: M= 221 g, Ms = 128 g, Gs = 2.7, S, = 75%. %3D…

Q: A cohesive soil sample obtained from a known normally consolidated clay deposit is found to have a…

A: The compression index of soil is defined as the slope of the graph between pressure and void ratio…

Q: (a) A dry sand sample is tested in direct shear. The test procedure includes having a normal…

Q: A triaxial test is performed on a normally consolidated clay. The sample is further consolidated by…

Q: A consolidated drained tri-axial test was conducted on a normally consolidated clay. The results are…

Q: A tri-axial compression test on a cohesive sample of cylindrical in shape, which fails along a plane…

A: Given data in question Major principal stress Minor principal stress Failure plane angle To find…

Q: sample of dry sand is tested in direct shear. The shear box holding the sample has a circular cross…

Q: Please provide a solution and diagram An undisturbed soil sample, 100 mm in diameter and 200 mm…

Q: The results of a laboratory consolidation test on a clay sample are given below: Pressure, P Void…

A: (a) Draw the e-logp plot as shown below. Therefore, the graph of e-logp is shown above.

Q: For a laboratory consolidation test on a clay specimen (drained on both sides) the following results…

Q: A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: A cohesionless soil sample was subjected to a triaxial test. The sample failed when the minor…

A: Given:- A cohesionless soil sample was subjected to a triaxial test The value of minor principal…

Q: A site is underlain by a saturated clay layer with thickness = 5m. A sample extracted from the…

Q: A normally consolidated soil was subjected to tri-axial test with the following data: cell pressure=…

Q: The cross-sectional area of the boOx was 3600 mm' and one division of the proving ring dial gauge…

Q: Part #2 Effective Stress (kPa) Void Ratio (%) The following are the results of laboratory…

Q: Compute the angle of resistance in degrees.

Q: 3- A sand sample is subjected to drainage cutting test with a hollow cylinder device. Rupture occurs…

A: Solution A)σCell/σ3=200 Kpa σ1= 300 Kpa drainage allowed U=0 (pore water…

Q: or an unconsolidated undrained test on a soil having USCS classification of CL and sample diameter…

A: Question is based on unconsolidated undrained soil classification . Diameter of sample, strain and…

Q: Determine the effective stress increase, rate of increase of effective stress in the soil at depth…

Q: A specimen of saturated sand was subjected to a tri-axial test under a chamber pressure of 400 kPa.…

A: solution Given chmaber pressure σc=400kpa cohesionless soil c= 0angle of internal friction ∅=34°

Q: highway engineering laboratory test CBR (California Bearing Ratio) 1- What is the reason for…

A: The California Bearing Ratio (CBR) test is a penetration test used to evaluate the subgrade strength…

Q: A clay soil specimen with the initial height of 1.0 in is loaded for a design pressure of 20 psi.…

A: The unit weight of sand will be: Y1=GsYw/(1+e) =2.65*62.4/(1+0.65)=100.22 pcf

Q: 5. A laboratory consolidation test was performed on a cohesive soil specimen with drainage on top…

A: consolidation test data such as height of specimen, drainage conditions, degree of consolidation and…

Q: The following data are given for the laboratory sample. o=175 kPa; e = 1.1;o+Ao 300 kPa; e = 0.9 -…

A: Calculate the coefficient of volume compressibility?

Q: A clay sample is consolidated to p'=400 kN/m² and then sheared in standard triaxial test in…

A: vt=2.0517 q’t=240 kN/m3 p’t=255 kN/m2

Q: A normally consolidated soil was subjected to tri-axial test with the following data: cell pressure=…

Q: In the conventional laboratory compression test, what is the cause of soil volume decrease?

A: Some of the reason of change in volume of soil sample during laboratory compression test are…

Q: 3. The maximum stress that causes the failure of a cohesive soil specimen in a tri-axial test is…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Nonrigid analyses are superior because they consider the flexural deflections inthe mat and the…

A: Rigid and Nonrigid methods are developed to design mat foundation. The Rigid method has some…

Q: The coefficient of permeability of fine sand is 0.022 cm/s at a void ratio of 0.72. Estimate…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: A cohesive soil sample is subjected to an unconfined compression test

Q: 2. A direct shear test was conducted on a specimen of a dry sand. The shear strength of the soil was…

A: Given data in question Direct shear test Depth Specific gravity Porosity Shear strength To find…

Q: Adry sand is known to have an angle of internal friction equal to 35°. What is the maximum major…

Q: Identify the in situ test that is good for estimating Elastic Modulus of Soil. Standard Penetration…

A: The elastic modulus of soil or young's modulus of soil is an elastic soil parameter, which is used…

Q: Adry sand is known to have an angle of internal friction equal to 36°. A triaxial test is planned,…

A: Given data: Angle of internal friction angle (ϕ) = 36oConfining stress or pressure (σc or σ3)=40 kPa

Concept explainers

Test for Determination of Shear Strength

The term shear strength is often associated with the soil. Shear strength is defined as the resistance to the deformation of soil particles due to the continuous action of shear stress. In short, shear strength is the maximum shear stress that a soil can sustain.

Question

A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lbs/ft², (the unconfined compressive strength (q_u) is 3850 lbs/ft²). Determine the soil's cohesion. (answer in lbs/ft²)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Test for determination of shear strength

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lb/ft2 [i.e., unconfined compressive strength lb/ft2]. Determine the soil’s cohesion.
A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lb/ft2 [i.e., unconfined compressive strength lb/ft2]. Determine the soil’s cohesion. If an unconfined compression test is performed on the same clayey soil, what axial load can be expected at failure?
The following results were obtained from a liquid limit test on a clay using the Casagrande cup device. Number of blows Moisture content (%) 6 12 20 28 32 52.5 47.1 43.2 38.6 37.0 a) Determine the liquid limit b) If the natural water content is 38% and the plastic limit is 23%, calculate the liquidity index. c) Would you expect a brittle failure? WHY?
(a) A sample of dry sand is tested in direct shear. Under an applied normal stress of 4,800 psf, the sample falls when the shear stress reaches 3,100 psf. What is the angle of internal friction for this soil?(b) A second sample of the same sand material is also to be tested in direct shear, but the applied compressive loading will be 3,500 psf instead of 4,800 psf. What shear stress is expected to fail the sample?
a) An unconfined compression test is performed on a cohesive soil (having no fissures) with an initial diameter and height of 50 mm and 100 mm, respectively. Measured deformation and load at the time of failure are given as 4 mm and 184 N, respectively. Find the undrained shear strength of this soil sample. b) Also, an unconsolidated undrained (UU) triaxial test is performed on the same specimen under o3=100 kPa. Draw the total stress-based Mohr circles for both tests and plot the Mohr- Coulomb failure envelope.
# 3) A sand soil sample is subjected to a direct shear test under a normal load of 185 kPa. The specimen failed when the shear stress reached 100 kPa. If the normal load is increased to 240 kPa, what will be the shear strength of the specimen?
A direct shear test was conducted on a dried sand sample in a test box of 60mm x 60mm normal load of 400N. The soil sample failed at an applied shear force of 250N. a. Determine the shear strength parameters of the soil. b. Estimate the required shear force to cause a shear failure under a normal load of 600N. (Show all working calculations.)
A normally consolidated soil was subjected to tri-axial test with the following data: cell pressure= 320kPa; The specimen failed when the deviator stress is 460 kPa. Compute the angle of resistance in degrees.
A tri-axial compression test on a cohesive sample of cylindrical in shape, which fails along a plane making an angle of 60 degrees with the horizontal, yields the following effective stress. Compute the angle of internal friction. Compute the cohesion of the soil sample. Compute the shear stress (MN/m^2) at the rupture plane.
A triaxial compression test was conducted on a saturated soil sample to determine its shear strength parameters: effective cohesion (C') and effective friction angle (O'). The confining pressure used during the test was 30 psi. The deviator stress on the sample at the time of failure was 40 psi. The porewater pressure measured at the time of failure was 5 psi a) The figure below shows the stress conditions on the sample at the time of failure. Provide the values of total stresses, o1 and oz on the sample. Total horizontal stress, o3 (psi) = (Report to the nearest whole number, i.e. no decimals) Total vertical stress, o1 (psi) (Report to the nearest whole number, i.e. no decimals) %3D b) The figure below shows the effective stress Mohr's Circle for the above soil sample at failure. What are the values of effective normal stresses at points A and B?
A sand sample is subjected to direct shear testing at it's (in - situ) water content. Two tests are performed. For one of the tests, the sample shears at a stress of 400 kPa when the normal stress is 600 kPa. From these data,Determine the value of the apparent cohesion. Determine the corresponding angle of internal friction.
If an unconfined compression test is performed on the same clayey soil as described in Problem 4 , what axial load can be expected at failure? problem 4: A cohesive soil sample is subjected to an unconfined compression test. The sample fails at a pressure of 3850 lb/ft2 [i.e., unconfined compressive strength lb/ft2]. Determine the soil’s cohesion.