A coil is wound with 125 turns on a rectangle former with a length and width of 100 mm and 50 mm, respectively. The coil rotates in a uniform magnetic field of density 1.0 T. The ends of the coil are electrically connected to the terminals of a 120 resistor. a) Calculate the rotation speed of the coil in Revolution per Minute (RPM) to produce an a.c. waveform with a frequency of 60 Hz. b) Calculate the period of the waveform. c) Calculate the maximum value of the e.m.f. generated in the coil. d) Write the instantaneous expression for the current flowing through the resistor e) Determine the amount of current flows in the coil when the coil has rotated through 45 from the position of zero e.m.f. f) Sketch the current waveform indicating i. The peak amplitude of the current ii. The peak-to-peak current iii. The average current iv. The root mean square (r.m.s.) current V. The waveform period

A coil is wound with 125 turns on a rectangle former with a length and width of 100 mm and 50 mm, respectively. The coil rotates in a uniform magnetic field of density 1.0 T. The ends of the coil are electrically connected to the terminals of a 120 resistor. a) Calculate the rotation speed of the coil in Revolution per Minute (RPM) to produce an a.c. waveform with a frequency of 60 Hz. b) Calculate the period of the waveform. c) Calculate the maximum value of the e.m.f. generated in the coil. d) Write the instantaneous expression for the current flowing through the resistor e) Determine the amount of current flows in the coil when the coil has rotated through 45 from the position of zero e.m.f. f) Sketch the current waveform indicating i. The peak amplitude of the current ii. The peak-to-peak current iii. The average current iv. The root mean square (r.m.s.) current V. The waveform period

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 90CP: A rectangular copper loop of mass 100 g and resistance 0.2 is in a region of uniform magnetic field...

See similar textbooks

Similar questions

(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ31.5. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative. Figure OQ31.5
A 50-turn rectangular coil with dimensions 0.15m0.40m rotates in a uniform magnetic field of magnitude 0.75 T at 3600 rev/min. [a) Determine the emf induced in the coil as a function of time, (b) If the coil is connected to a 1000 resistor, what is the power as a function of time required to keep the coil turning at 3600 rpm? (c) Answer part (b) if the coil is connected to a 2000 resistor.
A circular loop of wire of radius 10 cm. is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2104T perpendicular to the arcs of rotation, (a) Find an Expression for the time-dependent flux through the ring (b) Determine die time-dependent current through the ring if it has a resistance of 10.
A rectangular copper loop of mass 100 g and resistance 0.2 is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth's surface (see below). The loop is let go from rest what it is at the edge of the nonzero magnetic field region. (a) Find an expression for the speed when the loop just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the tune when it exits the region of magnetic field for the following values, a=25cm,b=50cm,B=3T,g=9.8m/s2 ?Assumethat the magnetic field of the induced current is negligible compared to 3 T.
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated in Figure P31.42. The horizontal component of the Earths magnetic field at the coils location is equal to 2.00 105 T. (a) Calculate the maximum emf induced in the coil by this Held, (b) What is the orientation of the coil with respect to the magnetic field when the maximum emf occurs?
A rectangular coil with resistance R has N turns, each of length and width as shown in Figure P31.36. The coil moves into a uniform magnetic field B with constant velocity v. What are the magnitude and direction of the total magnetic force on the coil (a) as it enters the magnetic field, (b) as it moves within the field, and (c) as it leaves the field?