A coil, with 100 mH Of Inductanče and resistance, has been CO UP 01 Da ower supply Vs(t)= 200 sin(100t) V for a long time, at t-0 the AC source rise to = 400 sin(100t+ 45°) V, determine the circuit current i(t).
Q: Two coils of inductance ?1 = 1.16 mH, ?2 = 2 mH are connected in series. Find the total energy…
A:
Q: Consider the electric circuit consists of two coils, as shown. The self inductances of coils are…
A: The given circuit is excited with the current i(t) = I0 Sin(wt) from the primary side. The secondary…
Q: i(1) 50 mH 3() A coil with an inductance of 50 mH is connected to a current source as shown in the…
A: In the circuit Inductor is connect to independent current source. Find the voltage V(t)?
Q: A coil having a resistance of 45ohms and inductance 0.4 H is connected in parallel to a 20 microF…
A: Step1 In this question, we have to find out Current I taken from mains. Following parameters are…
Q: For the circuit shown below: determine i(t) of the circuit below, when v1(t)=10 cos 10t -Reactive…
A:
Q: 3. A resistor and a capacitor are connected in series with a variable inductor. When the circuit is…
A:
Q: Find the equivalent capacitance with respect to the terminals a, b for the circuit shown The…
A: The equivalent capacitance across terminals a and b is obtained by following the below procedure,
Q: Two coils A and B are connected in series, and their effective inductance is 12.0H which the current…
A: As here 12H inductance is found when currents in both coils are in opposite direction, and 8H is…
Q: a coil of 10 ohms resistance and 0.1 H inductance is connected in parallel with a capacitor of…
A:
Q: Q5) The combined inductance of two coils connected in series is 0.4 H or 0.2 H depending on the…
A: Given, the self-inductance of the first inductor is, L1=0.3H Let, the self-inductance of the first…
Q: A coil has an inductance of 40 mH and negligible resistance. Calculate its inductive reactance and…
A: As per the question, it is given that Inductance = 40 mH Frequency f1 = 50 Hz Voltage V1 = 240 V…
Q: 1. A coil of resistance 50 2 and inductance of 100 mH is connected in series with a capacitance of…
A: Voltage and current at different loads R-Load - There is no phase difference between voltage and…
Q: 70. Ideal inductors and capacitors are 90 degrees out of phase with each other. True False 71.…
A:
Q: 4. If the current flowing through a 75 mH inductor has the waveform shown in figure 3, (a)sketch the…
A:
Q: An R-C circuit consisting of a 4.7µF capacitor in series with a 200 2 resistor, is connected to a…
A:
Q: 8. A coil of inductance 9 H and resistance 50 Q in series with a capacitor is supplied at constant…
A:
Q: na pure inductive circuit, connected to an ac source, the current in it leads the applied voltage by…
A: in a pure inductive circuit, connected to an AC source the current in it leads the applied voltage…
Q: The current in a 200 mH inductor is t0. The voltage across the inductor (passive sign convention) is…
A: It is given that: L=200 mHiL0=75 mA , t≤0;iLt=B1…
Q: Please answer (b)-(d) NOT A
A: The maximum energy stored in the capacitor, the time interval of power transferred to the capacitor,…
Q: A 120 microfarad capacitor is connected in parallel with a coil of 78 ohm resistance and 321 mH…
A: Given data, Supply voltage V =215 V C=120 μF R=78 Ω, L=321 mH Frequency f = 60 Hz
Q: If the current flowing through a 75 mH inductor has the waveform shown in figure 3, (a)sketch the…
A: In this question, We need to determine the voltage waveform if current waveform is given in the…
Q: 12. 7.12 In the circuit , let Ig represent the dc current source, σrepresent the fraction of initial…
A:
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A:
Q: The voltage pulse applied to the 100 mH inductor shown is 0 for t<0. and is given by the…
A: Given: Voltage and time relation across an inductor.
Q: Statement for Lin An inductor designed with 400 turns coil wound on an iron core of 16 cm² cross…
A: Given values are - N=400AreaA=16cm2=16×10-4m2Lengthl=1mm=1×10-3mVoltageV=230Voltfrequencyf=50Hz
Q: a 34 A circuit shown consistsof three coils of inductances 1.0 µF capacitance. At an instant, when…
A: a) We can draw the circuit as
Q: 100 µF 15 mA 6 kO 0.3 H 60 mH 24 V 250 µF 3 k2 4 kO 2 ΚΩ
A:
Q: A source delivers an AC voltage of the form AV = 198 sin( 51 nt), where AV is in volts and t is in…
A: Here, we have given some information about the voltage delivered by the voltage source. The maximum…
Q: An inductance of 1 H, a resistance of 400 S2 and capacitance of 5 x 10º F are connected in series…
A: First we will find out total impedance in polar form then we will find out the current we
Q: 1. A coil of 10 Q resistance and 0.1 H inductance is connected in parallel with a capacitor of…
A: In this question, Choose the correct option What is value of capacitance C We know Xc= 1/wC XL =…
Q: The current in a 200 mH inductor is i = 75 mA, t≤0; i = ( B 1 cos 200t+ B 2 sin 200t) e −50t A,…
A: as we know current at t=0, is =75 mA so,i0=B1cos0+B2sin0e0=B1B1=75×10-3 calculate the voltage,…
Q: Two inductances L1 and L2 are connected in series with mutual inductance M. If the total inductance…
A:
Q: Two coils connected in series-aiding fashion have a total inductance of 250 mH. When connected in a…
A: Given that two coils are connected in series and inductance of one coil is 3 times the other. L1=3L2…
Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.
A:
Q: A pure inductance of L = 158 mH is connected to a V = 116 V, 50 Hz supply. The %| current taken by…
A: In this question we need to find a current taken by inductor.
Q: The voltage pulse applied to the 100 mH inductor shown is 0 for t<0 and is given by the…
A: The current-voltage relation in the above case is given as
Q: A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this…
A:
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A: Given Voltage, V = 8V Current, l = 2mA Frequency, f = 10KHZ Resistance, R = 14K ohms Inductance.…
Q: Determine, in polar and rectangular forms, the current flowing in an inductor of negligible…
A:
Q: A pure inductance of L = 144 mH is connected to a V = 112 V, 50 Hz supply. The current ta by the…
A:
Q: A resistor of resistance R = 15 MN is connected in series to a capacitor or capacitance %3D C = 19…
A: The series RC circuit can be analysed based on the initial and steady state voltage across the…
Q: A coil of inductance 710.61 µH and resistance 20 Q is connected in parallel with a variable…
A: In this practical tank circuit is given....We have to find out capacitance value, dynamic impedance…
Q: A resistor and a capacitor are connected in series with a variable inductor. When the circuit is…
A:
Q: Find the impodance theorctically of a wire if it canies the frequency 10 kHz have a voltage is 8v,…
A: The impedance of a wire is nothing but the ratio of Voltage across the wire to the current through…
Q: The circuit shown in the figure is in steady state, when the switch is closed at t= 0.Assuming that…
A: Given circuit is - Given that switch is closed at t = 0.
Q: A 10 2 resistor, a 0.2 H inductor, and a 0.1 F capacitor are connected to a voltage source as below.…
A: To find the current i(t) and magnitude of the current
Q: 1. A coil of resistance 50 2 and inductance of 100 mH is connected in series with a capacitance of…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 53.37-ohm resistor,…
A:
Q: A series circuit having pure resistance of 40 ohms, pure inductance of 50.07 m Hand a capacitor is…
A: First find the total impedance seen by source and than equate this with impedance of series circuit…
Step by step
Solved in 2 steps with 2 images
- A resistance of 100 Ω, an inductance of 0.1 H, and a capacitance of 5(10−5) F are connected in series.If the total electromotive force is given by 110 sin 377t, such that at t = 0,Q = 0, and i = 0, find thecurrent for t > 0.Two coils of inductance ?1 = 1.16 mH, ?2 = 2 mH are connected in series. Find the total energy stored when the steady current is 2 Amp?a series rlc circuit having values of pure resistance r=40 ohms and pure inductance l = 50.07 mh. the circuit draws 10 A of current when it is connected across a 400 v , 50hz ,ac supply. calculate the (1) capacitor value and (2) power factor of circuit.
- Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v, the current is 2mA, resistance is 12 kΩ , inductance 27 mH and capacitance 0.2 µfShort Problem: Given a parallel RLC circuit comprised of the following element: 57.81-ohm resistor, ideal inductor with reactance of 65.75 ohms; and a capacitor with reactance of 6.59 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts.COURSE: Electrical EngineeringSUBJECT: Electrical ApparatusINSTRUCTIONS:• Write the GIVEN with their respective symbols and units.• Do not skip the SOLUTIONS, do it step-by-step with their respective symbols and units• Round up to 3 three decimal places the FINAL ANSWERS and BOX it. PROBLEM:A capacitor in series with a 66 Ω resistor is connected to a 120 V, 60 Hz source. If the impedance of the circuit is 116 Ω, determine the size of the capacitor.
- If a circuit is connected to a voltage source of 1sin(10t + 84 degrees) and Capacitance(C) = 2F, Resistance(R) = 6 Ohms and Inductance(L) = 5H. Find the instantaneous current flowing in the circuit at time t = 0.46 seconds. - Capacitor, Resistor and Inductor connected in seriesa series r-c circuit takes a current whose equation is i=0.85sin(754t+pi/4) when connected to a source of emf having the equation e=340sin754t. calculate the capacitance of the capacitor, circuit power factor, and power.A 30 μF capacitor is connected in parallel with a coil of inductance 50 mH andunknown resistance R across a 120 V, 50 Hz supply. If the circuit has an overallpower factor of unity, find (a) the value of R, (b) the current in the coil, and (c)the supply current.
- H5. An RCL circuit connected in series has R = 180 ohms, C = 1/280 farad, L = 20 henries, and an applied voltage E(t) = 10 sin t. Assuming no initial charge on the capacitor, but an initial current of 1 ampere at t = 0 when the voltage is first applied, find the subsequent charge on the capacitor at t=0.5. Use 4 decimal places.A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds, is placed next to a second coil, end to end. At t = 0.720 s, a lab tech measures the emf across the second coil, and the result is −3.50 V. What is the mutual inductance (in mH) of the coils?A resistance of 16 Ω is connected in series with a pure inductance of 39.9 mH and the circuit is connected to a 100 V, 50 Hz, sinusoidal supply. Calculate the phase angle of the impedance. Give your answer as a number without units to 0 decimal places.