A commercial airliner with four jet engines, each producing 94 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below. 94 kN 6.4 m 3 13.2 m 13.2 m 94 kN 6.4 m 94 kN- Answer: d = m

A commercial airliner with four jet engines, each producing 94 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below. 94 kN 6.4 m 3 13.2 m 13.2 m 94 kN 6.4 m 94 kN- Answer: d = m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A commercial airliner with four jet engines, each producing 64 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below.
A 500 N block is resting on an inclined plane and is subjected to a constant force of 600N acting parallel to the inclined plane. After the block has moved 3 m from rest along the inclined plane the force 600N is removed. The inclined plane has a slope of three vertical to four horizontal. Coefficient of friction is 0.20 a. Which is the following gives the distance that the black will move further along the inclined plane until it will stop? b. Which of the following gives the velocity of the block when this for 600 Newton was removed? c. Which of the following gives the velocity of the block when it returns to its initial position?
In the figure shown,block B is pulled downwith a velocity of 0.3 m/s.Calculate the velocity ofblock A and determine thedirection of motion.
The elevations of the ski jumping hill shown below are as follows: hA = 44 mhB = 1.6 mhC = 4.9 m If the velocity of a ski jumper is measured to be 27.9 m/s at position B, what will be the launch velocity (in m/s) at position C
A body weighing 2,225 N is being dragged along a rough horizontal plane by a force F = 445 N. The coefficient of friction is 1/12 and the line of the pull makes an angle of 18 degrees above the horizontal. Which of the following most nearly gives the velocity of the body after travelling 5.50 m starting from rest?
A volleyball player throws the ball with an initial velocity that makes an angle ?= 35º with the horizontal. Determine: The magnitude of minimum initial velocity with which the ball must be thrown in order to pass the net of height h. More data: h= 2.40 m Y= 2.15 m L= 12 m
The helicopter flying in Figure 4 with a constant velocity of 180 km/h and is directly above point A when a loose part begins to fall. The part lands 6.5 seconds later at point B on an inclined surface. 16. The vertical motion component of the falling part is A. uniform motion B. non-uniformly accelerated C. uniformly accelerated D. stationary
. An open cylinder tank 0.5 m in diameter and 1 m in height is completely filled with water and rotated about its axis at 240 rpm. Determine the volume of water spilled out of the tank. Unit of the Correct Answer: liters Decimal Places required in the final answer: 2 An open cylindrical tank 3m high and 1.5m in diameter contains 2m high of water. If the cylinder rotates about its geometrical axis, what constant angular velocity can be attained if the depth of water at the center is 0.5m? Unit of the Correct Answer: rad/sec Decimal Places required in the final answer: 3 A vertical cylindrical tank is 9 m high and 5 m in diameter. It is two thirds full of water and is rotated uniformly about its axis until on the point of overflowing. Compute the linear velocity at the circumference of the tank. An open cylindrical vessel 2m diameter and 4.2 m depth is 2/3 full of water. If rotated about the vertical axis at constant angular speed 80 rpm, determine the amount of water in…
A ship which moves at a steady 22-knot speed (1 knot = 1.852 km/h) executes a turn to port by changing its compass heading at a constant counterclockwise rate. If it requires 59 s to alter course 90°, calculate the magnitude of the acceleration a of the ship during the turn.Answer: a = m/s2
Situation 2: The displacement (in meter) of a particle moving along x - axis is givenby x=At^2 + B , where A = 2m and B = 3m. Calculate average velocity between t =3sand t = 5s.Situation 2: Calculate instantaneous velocity at t = 5sSituation 2: Calculate instantaneous acceleration.
A baseball pitching machine “throws” baseballs with a horizontal velocity v0. Knowing that height h varies between 788 mm and 1068 mm, determine (a) the range of values of v0, (b) the values of ∝corresponding to h = 788 mm and h = 1068 mm.
Water flows smoothly over a small bump in a channel of constant width, as shown in Figure P10.11. At any cross-section the velocity may be considered constant over the entire area. If V1 is the velocity at entry, where the depth is Y1, and V2 is the velocity where the bump has its highest point, where the depth is Y2. If Y1/Y2 = 1.8, find (a) The Froude number of the flow at entry. (b) The Froude number at the top of the bump.