A cubic block of cement is tossed into a cylindrical tank of water with a diameter of 2 feet, causing thewater to rise 2.5 inches. Use the value of a from your calculator or n=3.1416.a. What is the volume of the cube to the nearest cubic inch?The volume isin3b. What is the length of the edge of the cube to the nearest 0.1 inch?The length isin.

Note the formula's corresponding to question : Volume of cylinder is πr2h where r is radius of base…

A cubic block of cement is tossed into a cylindrical tank of water with a diameter of 2 feet, causing the water to rise 2.5 inches. Use the value of r from your calculator or 7~ 3.1416. a. What is the volume of the cube to the nearest cubic inch? The volume is in'. b. What is the length of the edge of the cube to the nearest 0.1 inch? The length is in.

A cubic block of cement is tossed into a cylindrical tank of water with a diameter of 2 feet, causing the water to rise 2.5 inches. Use the value of r from your calculator or 7~ 3.1416. a. What is the volume of the cube to the nearest cubic inch? The volume is in'. b. What is the length of the edge of the cube to the nearest 0.1 inch? The length is in.

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter69: Simple Practical Machine Applications

Section: Chapter Questions

Problem 4A: A steel forging in the shape of a right circular cone weighs 214.6 pounds. The base of the cone has...

See similar textbooks

Similar questions

Determine the number of cubic centimeters of material needed for the cast plate shown. The casting is 3.20 centimeters thick. Round the answers to the nearest thousandth cubic meter.
A steel forging in the shape of a right circular cone weighs 214.6 pounds. The base of the cone has a diameter of 8.72 inches. If the steel in the forging weighs 490.5 pounds per cubic foot, what is the height of the cone? Round the answer to the nearest tenth inch.
The length, L, of the standard 82° included angle drill can be calculated using the formula L=0.575 , where Ø represents the diameter of the drill. Determine the length of a drill point with a diameter of 12.5 mm. Round your answer to 1 decimal place.
A bronze bushing with a diameter of 22.225 millimeters is to be pressed into a mounting plate. The assembly print calls for a bored hole in the plate to be 0.038 millimeter less in diameter than the bushing diameter. The hole diameter in the plate checks 22.103 millimeters. By how much must the diameter of the plate hole be increased in order to meet the print specification?
How much stock per stroke is removed by the wheel of a surface grinder if a depth of 4.725 millimeters is reached after 75 strokes? Round the answer to 3 decimal places.
The exterior wall the gabled end of the house shown remains to be painted. a What is the area of the outside wall? b If each gallon of paint covers approximately 105ft2, how many gallons of paint must be purchased? c If each gallon of paint is on sale for 22.50, what is the total cost of the paint?