A culture of Staphylococcus is diluted as follows: (1) 20mL are added to 80mL of water. (2) 10uL from (1) are then added to 9.99mL of water. (3) A 10-2 dilution is made from tube # (2). (4) 100uL from (3) are plated for a pour plate and incubated. There were 34 colonies counted on one quarter of the plate following incubation. a) What was the overall dilution? b) How many cfu/mL were present in the original culture?

A culture of Staphylococcus is diluted as follows: (1) 20mL are added to 80mL of water. (2) 10uL from (1) are then added to 9.99mL of water. (3) A 10-2 dilution is made from tube # (2). (4) 100uL from (3) are plated for a pour plate and incubated. There were 34 colonies counted on one quarter of the plate following incubation. a) What was the overall dilution? b) How many cfu/mL were present in the original culture?

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 2.4P

See similar textbooks

Similar questions

What would the final concentration of a bacteria culture be if 2.7 x 106 cells/ml were diluted 8.2 x 10-2? What would the initial concentration of a bacteria culture be if the final concentration was 3.7 x 102 cells/ml and the total dilution was 4.6 x 10-4?
In this experiment, a culture was serially diluted to the concentrations below. Each plate was plated with 0.25mL of the dilution. Using the most diluted plate, what is the correct concentration of the original culture? A) 2.0 X 10^-3 cells/mL B) 2.0 X 10^5 cells/mL C) 4.0 X 10^5 cells/mL D) 5.0 X 10^4 cells/mL
What is the amount (mL) of pre-culture (108 cell/mL) necessary to inoculate (to add) in a 2-liter culture media for a concentration of 6.5 × 106 cells/mL?
You place 1 ml of a bacterial broth culture into bottle A containing 99 ml of sterile water and mix. You take 1 ml from bottle A and transfer it to bottle B, which contains 99 ml of sterile water. What is the dilution of the bacterial culture in bottle B?
If an unknown bacteria was given that was gram-positive coccus, and the catalase test was performed, what can be determined from the result of the test?
What is the purpose of the pour plate technique? If a pure culture is used to inoculate the plate, why are some colonies bigger than others?
Given a log phase bacterial culture with 1 x 10^6 cells per ml and a generation time of 30 minutes how long does it take the culture to reach a density of 6.4 x 10^7 cells per ml?
How would you produce a 10^-1 dilution if a 3 mL bacterial sample using the entire 3 mL volume? suppose your professor handed you a test tube with 2.0 mL of an E. coli broth culture in it and told you to make a 10^-1 dilution of the entire culture. Explain how you would do this. Show your calculations.
Noah wanted to transfer Staphylococcus aureus from a broth to an agar plate. He picked up the broth culture, removed the cap, and flamed the mouth of the tube. He inserted an inoculating loop to obtain a bacterial sample. Then, he flamed the mouth of the tube and replaced the cap. Noah opened the lid of a labeled agar plate diagonally and used the loop to streak the surface of the agar. After closing the lid, he flamed the loop in an incinerator and put it back in its container. The plate was incubated upside down for 24–48 hours. What did Noah do wrong in this transfer? a. He did not use the transfer tool correctly. b. He did not handle the culture tube correctly. c. He did not handle the agar plate correctly. d. He used the wrong tool in transfer.
Why are plated media stored in an inverted position?
You were asked to prepare a dilution series of a bacterial culture where only 3 tubes will be used (all with 5 mL total solution). Draw a schematic diagram to make tube 1 have a 10-2 dilution, tube 2 have 10-3 dilution, and tube 3 to have 10-5 dilution You were instructed to dilute an antibiotic solution 1/10, redilute 1/25, and again 1/50, then you need to make 100mL of each dilution. How would you go about preparing this dilution series? (Present your answer in a schematic diagram)
I tested organism growth on the MSA plate for strep. pyongenes, strep. pneumonia, s. aureus, and straph. epidermidis and my results were that streptococci organism did not grow or change color and the s.aureus changed color (yellow) and s.epi there was no change in color but they both showed growth. 1. If an unknown gram-positive bacterium was given, what would it mean if it grew on MSA? Name the organisms used above My answer: that it would be either s.aureus or s. epidermis because they are selective for salt-tolerant bacteria and can grow on mannitol 2. what would it mean if it both grew on MSA and turned yellow? Can you add to my answer or correct it. Thank you!