OSSecOA current Ip5A flows throughlong regular wire in emty space.an infinitelyItsquare perimerer with a side length of3 [cm] atA Seconddistance of d=4Ecm] fromtheeurrentOn +he same plane with this currentldirection is giver in the figure J are awailable.Caleulate the enductance L42 as EuH].

A current Ip5A flows through an infinitely long regular wire in emty space. A Second square side length of perimeter with a a : 3 [cm] at a distance of d=4[cm] from. the current on +he same plane with this current (direction is giver in the figure e Jare awailable , Caleulate the L42 as CMHI. enductance (H,=47 10 H/m)

A current Ip5A flows through an infinitely long regular wire in emty space. A Second square side length of perimeter with a a : 3 [cm] at a distance of d=4[cm] from. the current on +he same plane with this current (direction is giver in the figure e Jare awailable , Caleulate the L42 as CMHI. enductance (H,=47 10 H/m)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The figure is a cross section through three long wires with linear mass density 58.0 g/m. They each carry equal currents in the directions shown. The lower two wires are 4.0 cm apart and are attached to a table. What current I will allow the upper wire to "float" so as to form an equilateral triangle with the lower wires?
Find the capacitance in picofarad between inner and outer curved conductor surfaces shown in the figure containing two dielectrics, εr1 = 4.9 and εr2 = 3.5. Here r1 = 39.4 mm, r2 = 64.4 mm, α1 = 19.7 degrees, α2 = 41.2 degrees and L = 158.6 mm.
A lossy capacitor Cx, rated for operation of 5 kV, 50 Hz is represented by an equivalent circuit with an ideal capacitor Cp in parallel with a resistor Rp. Cp is 0.102 microF and Rp=1.25 Mohm. The power loss, and loss tangent of this lossy capacitor at rated voltage respectively ?
Two long straight current-carrying wires are lined up parallel to one another in vacuum at a distancedCurrents of I1 and flow I2 through the wires, both in the same direction generating the field of B Delta f at a midpoint between themWrite down an expression for BM in terms of the currents running in each of the wires Assume vacuum permeability u= 1
a rod of semiconducting meterial of length L = 2 m and cross-sectioanal area A=5mm2 lies along the x axis between x=0 and x=L. the meterial obeys Ohm's law, and its resistivity varies along the rod according to p=p0 (1-(x2/L2)) where p0=4,5 * 10-4 ohm*m. the end of the rod at x=0 is at a potential V0= 30 V greater than the end at x = L. a)what is the total resistance, in units of ohm, of the rod ? b)what is the current, in units of miliamperes in the rod? c)what is the electric potential, in units of Volt in the rod at x=L/2 ? d)what is the electric field magnitude E, in units of V/m, in the rod at x=L/2 ?
A DC current I flows in a long solenoidwith n coil-turns per unit length. Thecore is made of iron with permeability µ , and has a cross section area S.Determine the force acting on the coreif it is withdrawn to the position shownin figure.
Explain the modifciation to be made to the schering bridge for the following situations: i) Hihg dissipation factor test objects II) High capacitance test objects Explain in easy language so i can understand
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.
H:10) Connect a battery to a solenoidA cylindrical solenoid 40 cm long with a radius of 2 mm has 300 tightly-wound turns of wire uniformly distributed along its length (see the figure). Around the middle of the solenoid is a two-turn rectangular loop 3 cm by 2 cm made of resistive wire having a resistance of 195 ohms. One microsecond after connecting the loose wire to the battery to form a series circuit with the battery and a 20 resistor, what is the magnitude of the current in the rectangular loop and its direction (clockwise or counter-clockwise in the diagram)? (The battery has an emf of 9 V.) ................A clockwise counter clockwise
Two very long parallel conducting wires carry currents I1 = 1 A, I2 = 2 A in opposite directions. They hang horizontally from pylons by pairs of insulating cables, each of length a = 1 m, and are a distance d << a apart. The wires have mass m per unit length and the cables make angle theta to the vertical. Find theta. Show solving
A 30-volt electromotive force is applied to an ??-series circuit in which the inductance is 0.1 henry and the resistance is 50 ohms. Find the current ?(?) if ?(0) = 0. Determine the current as ? → ∞.
a)i2(t)=? b)Calculate the complex power on the inductance?