A cut is to be made in a soil for a canal having side slopes of 11/2: 1 to a depth of 8 m below the ground surface. The soil has cohesion of 15 kN/m², p' = 10°, void ratio of 0.86 and specific gravity of 2.67. If the Taylor's stability number is 0.17 and canal flows full then the factor of safety is

A cut is to be made in a soil for a canal having side slopes of 11/2: 1 to a depth of 8 m below the ground surface. The soil has cohesion of 15 kN/m², p' = 10°, void ratio of 0.86 and specific gravity of 2.67. If the Taylor's stability number is 0.17 and canal flows full then the factor of safety is

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter13: Slope Stability

Section: Chapter Questions

Problem 13.29CTP

See similar textbooks

Similar questions

A vertical cut is to be made in a purely cohesive clay deposit (c'=30kPa, φ'=0deg, γ=16kN/m3). Find the maximum height of the cut which can be temporarily supported. From the stability chart, the stability number can be used as 0.261.
A trapezoidal channel section having base 8m, depth 4m and the hydraulic radius is 2.36m. the side slope is
A rectangular channel 5.8 m wide by 1.4 m deep was laid to have a hydraulic slope of 0.001. Using n = 0.013. (a) What is its yield in cubic meter per second? (b) What savings in earth excavation could be realized by using most economical proportion? (c) What savings in lining per meter length could be realized by using most economical proportion?
1. Side slopes for rock fill 1V:2H. Calculate the minimum crest width of a breakwater using B = 3*kΔ*(W/γa)1/3 . Given data: Stone weight = (8) t, Specific weight = 2,7 t/m3, Layer thickness coefficient =1,00 and Porosity percentage = 37 2. For cubed shaped stone (or concrete), determine dimension of the stone for weight: W = (10+a) t, specific weight: γa = 2,4 t/m3
An embankment for road traffic is required to be constructed with the followingdimensions :Top width = 8 m, height = 4 m, side slopes= I V : 1.5 HorThe unit weight of soil under the worst condition is 21 kN/m3. The surcharge load on theroad surface may be taken as 50 kN/m2. Compute the vertical pressure at a depth of 6 mbelow the ground surface at the following locations:(i) On the central longitudinal plane of the embankment,(ii) Below the toes of the embankm
A rectangular channel 5.8 m wide by 1.4 m deep was laid to have a hydraulic slope of 0.001. Using n = 0.013. 1. What is its yield in cubic meter per second? 2. What savings in earth excavation could be realized by using most economical proportion? 3. What savings in lining per meter length could be realized by using most economical proportion?
An embankment is to be constructed for a certain project, as such filling materials are required to be excavated from borrow pits. The moist unit weight of the undisturbed soil is 20 kN/m3 and its water content is 10%. In order to build a 5 m high embankment with top width 2 m and side slopes 1:1, estimate the quantity of earth required to be excavated per meter length of embankment. The dry unit weight required in the embankment is 17 kN/m3 with a moisture content of 12%. Assume the specific gravity of solids as 2.65.
A canal having side slopes 1:1 is proposed to be constructed in a cohesive soil to a depth of 10m below the ground surface. The soil properties are ϕu = 15⁰, Cu = 12 kPa, e = 1.00, Gs = 2.65. If Taylors stability number, Sn = 0.08 and if the canal flows full, the factor of safety with respect to cohesion failure against the failure of canal bank slopes will be most nearly equal to?
A trapezoidal channel has a base of 2 m and 45-degree walls. A smooth asphalt lining is used and the channel slopes at 2.5%. If the water speed is measured at 10 m3/s, what is the water depth in the channel?
A trapezoidal embankment for a highway of 30m wide at the top,1.5m in compacted thickness with a side slope of 1:3 is to be constructed from a silty sandy GRAVEL trucked from a borrow pit. The water content in the borrow pit is 15% and its void ratio is 0.69. Truck of 15m3 capacity will be used to carry the soil from the borrow pit at the void ratio of 0.80 and at the same moisture content as the borrow pit materials. The specification requires the embankment to be compacted at a dry unit weight of 18kN/m3. Specific gravity of the soil is 2.7 and unit weight of water is 9.8kN/m3. Determine, for 500m length of embankment, the number of trips of each truck assuming 20 trucks are allocated for this activity.
An embankment for a highway 30 m wide and 1.5 m in compacted thickness is to be constructed from sandy soil trucked from a borrow pit. The water content of the sandy soil in a borrow pit is 15% and its void ratio is 0.69. The swell index is 1.2. The specification requires the embankment to be compacted to a dry unit weight of 18kN/m^3. Determine, for a 1-km length of embankment, the ff;(d) Volume of the borrow pit material required considering swell. (e) The number of truckloads of sandy soil required for the construction. The full capacity of each truck is 22.2m3, and local government regulations require a maximum capacity of 90%. (f) The weight of dry soil in one truckload.
A cut is made into a homogeneous soil as depicted in the figure below, at an angle of 60° with the horizontal. Calculate the resisting shear force in kN along the failure plane given that the shear force applied by the overlying soil wedge is 120 kN. The failure plane is at an angle of 40° from the horizontal direction and the ground water level is below this plane. Assume drained conditions for this question.