A cyclotron with dee radius 50.7 cm is operated at an oscillator frequency of 11.8 MHz to accelerate protons. (a) What magnitude B of magnetic field is required to achieve resonance? (b) At that field magnitude, what is the kinetic energy of a proton emerging from the cyclotron? Suppose, instead, that B =1.54 T. (c) What oscillator frequency is required to achieve resonance now? (d) At that frequency, what is the kinetic energy of an emerging proton? (a) Number i Units (b) Number i Units (c) Number i Units

A cyclotron with dee radius 50.7 cm is operated at an oscillator frequency of 11.8 MHz to accelerate protons. (a) What magnitude B of magnetic field is required to achieve resonance? (b) At that field magnitude, what is the kinetic energy of a proton emerging from the cyclotron? Suppose, instead, that B =1.54 T. (c) What oscillator frequency is required to achieve resonance now? (d) At that frequency, what is the kinetic energy of an emerging proton? (a) Number i Units (b) Number i Units (c) Number i Units

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The PCB monopole antenna shown in figure below is required to be designed for Bluetooth Low Energy wireless mouse operating at 2.45 GHz. What should be the length of the antenna trace in mm. Assume the substrate of the PCB is foam (dielectric constant = 1)
1.) Find the distance from a transmit antenna (gain = 27 dB) with 10 Watt input power at which the power density is 5 mW/m². Assume free-space propagation. 2.) The power density is 4 mW/m² at some distance R from an isotropic antenna. The isotropic antenna is replaced with a different antenna and the power density measured is now 60 mW/m² at the same distance R. What is the gain (in dB) of the second antenna? 3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles. Step by step and easy to understand and clear please. thanks
Design a rectangular microstrip patch antenna, based on the dominant mode, that can be mounted on the roof of a car to be used for satellite cellular telephone. The designed center frequency is 1.6 GHz, the dielectric constant of the substrate is 10.2 (i.e., RT/duroid), and the thickness of the substrate is 0.127 cm. Determine the (a) dimensions of the rectangular patch (in cm) (b) resonant input impedance, assuming no coupling between the two radiating slots (c) mutual conductance between the two radiating slots of the patch (d) resonant input impedance, taking into account coupling (e) position of the feed to match the patch antenna to a 75-ohm line
An extremely fast photodiode can be designed to achieve bandwidth of 158 GHz. Assuming that the bandwidth is limited by carrier transit time, calculate the required depletion region if the electron and hole saturation velocities = 0.85 x10^5ms-1. Express your answer in the unit of μm.
The Voyager 1 spacecraft, now in interstellar space, radios data back to Earth using a 22.4-W transmitter. A high-gain antenna focuses a narrow beam of radio waves toward Earth, making the transmitter equivalent to one that, if it were broadcasting in all directions, would have 50,000 times the power of the actual transmitter. In the current epoch, the Deep Space Network antennas that receive Voyager’s broadcasts detect Voyager signals with electric-field amplitudes of 3.9 pV/m. How far away is Voyager?
Please I need a complete solution to this. Thanks! Determine the single-pulse received power level from a target having the following parameters: transmitter peak power = 30 kW frequency = 8.6 GHz Antenna gain = 29 dB Target RCS = 5 dBsm Target range = 40 km
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.
A microwave link includes two sites that are 10 km apart and uses a center frequency of 9 GHz. On either transmitter or receiver side, a 100-m transmission line that has an attenuation per unit length of 0.01 dB/m is connected to an amplifier and a parabolic reflector antenna. Other losses caused by connectors and insertions incurred on one side amounts to 3 dB. Antenna has a power gain of 20 dB. If the output of the transmitter amplifier is 30 dBm, what is the received signal level (in dBm) at the input of the receiver amplifier?
A certain antenna has a gain of 7 dB with respect to an isotropic radiator. (a) what is the effective area if it operates at 20 GHz? (b) How much power would it absorb from a signal with field strength of 50 μV/m?
An FM broadcast transmitter has a bandwidth of 164 kHz and deviation ratio of 15. Suppose the carrier frequency is 98.7 MHz, what the maximum allowable modulating frequency (in kHz)?
Using the results of either a Root locus plot or a Bode plot, state if the attitude dynamics of the spacecraft in Question , could be asymptotically stabilised or not, without any compensation? a.Yes b.No
wireless communication For an earth station receiver with an equivalent input temperature of 200 K, a noise bandwidthof 20 MHz, a receive antenna gain of 50 dB, and a carrier frequency of 12 GHz, determine thefollowing: G/Te, N0, and N.