A Cylindrical tank 87 cm in diameter and 144 cm high is filled with a liquid. The tank and the liquid weighed 494 kg. The weight o the empty tank is 39 kg. What is the unit weight of the liquid in kN/m3. Round your answer to 2 decimal places.

A Cylindrical tank 87 cm in diameter and 144 cm high is filled with a liquid. The tank and the liquid weighed 494 kg. The weight o the empty tank is 39 kg. What is the unit weight of the liquid in kN/m3. Round your answer to 2 decimal places.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 26P: SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the...

See similar textbooks

Related questions

Q: A Pelton wheel is to be designed for a pitch diameter of 1 m and jet diameter of 0.1 m. The number…

A: Given- Pitch diameter D=1 m Jet diameter d=0.1 m Number of buckets=?

Q: Earth is required to be excavated from borrow pits for building an embankment. The wet unit weight…

A: Given, Wet unit weight of soil field soil, γb = 18 kN/m3 Water content of field soil, wb = 8% Dry…

Q: The bottom plate of a barge's hull (Figure below) is curved with the radius of 1.75 m. When the…

Q: When modelling software-intensive systems, what perspectives must to be taken into account in the…

A: When modeling software-intensive systems, several perspectives must be taken into account in the…

Q: the mid span. shown in Fig. i need clear ans by hand and solve very very fast in 20 min and thank…

Q: 6.8 A cable supports a uniformly distributed load in Figure P6.8. Find the horizontal reaction at…

Q: A soil has a bulk density of 22 kN/m³, water content 10%, the dry density of soil is - 1. 18.6 kN/m³…

A: Given Unit weight=22 kN/m3 water content w=10% Dry density=?

Q: For a road with a distance = 3 km. Calculate (TMS) AND (SMS) for the following traffic. car Time…

Q: The following are the results of a sieve analysis: a. Determine the percent finer than each sieve…

A: Given U.S. sieve no Mass of soil retained (g) 4 0 10 44 20 56 40 82 60 51 80 106…

Q: Prove that: (2): Ysat = (a) )(G 1+ wsat) Yw 1+wsat Gs

Q: Shown below are the results of water quality analyses of the Thames River in London. If the water is…

Q: 5/138 Determine the weight w per unit length of the 30-ft steel beam which will produce a maximum…

A: Given:- The length of the steel beam = 30 ft The maximum tension in the cable = 1500 lb To…

Q: A steel cable of 2 cm diameter is used to lift a board 500 kg. Given that the length of the cable is…

A: Given data- A steel cable- Diameter d=2 cm, Load P=500π kg, Length of cable L=10 m=1000 cm, Young's…

Q: Determine the moment of inertia of the shaded area about the x-axis. OK 6" 16"

Q: Lecture 2 A triangular roof frame consists of a horizontal tie rod and two rafters at inclined at…

A: To find thrust in rafter ,tension in tie rod and support reaction

Q: An I-section with two cover plates is used as tension member and is subjected to a load of 120 t…

Q: The friction angle of a soil layer is 37 degrees and the cohesion is 5 Kpa. The lateral earth…

Q: Find the moment at A, moment at B and reaction at C using Moment Distribution Method. (Use 4 decimal…

A: Answer We can determine the Moments at A, B and reaction at C using Moment distribution method…

Q: segment The following figure shows si(t) and s2(t), the speed of two vehicles over a three-mile of a…

Q: For the beam and loading shown, determine the deflection at point C in inches. Indicate the negative…

Q: The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate…

A: Answer We can either relocate the centreline of the curve to above the property lot or below the…

Q: Pure Torsion Question 13 A shaft of 2 m diameter is used to transmit 120 W of power at 180 rpm, the…

A: Given Shaft diameter d=2 m, Power P=120 W, N=180 rpm Shear stress=?

Q: A barrage on a major river in the Gangetic plains has been designed for a flood discharge 7000 m³/s.…

A: Given- Flood discharge Q=7000 m3/s, Waterway length L=360 m, It is needed to find the looseness…

Q: Problem 4. Determine the horizontal and vertical reactions at A and C of the two-member frame. 3…

A: Given : Required : Horizontal and vertical reaction at A and C

Q: At a station, Storm I of 5 hour duration with intensity 2 cm/h resulted in a runoff of 4 cm and…

A: Given- Storm-II Duration=8 hours Runoff =8.4 cm Intensity=?

Q: 1. You need a cylinder that can contain an amount of liquid. Measure the maximum amount of water…

Q: The Mohr's circle for a plane stress is a circle of radius R with its center at +-ono-axis. What is…

A: Given data- Mohr' s circle for a plane stress is given- Radius =R,Center C=+R2R=100 MPa, To Find-…

Q: Question 9: ( a 100-ft cut steel tape is used to check the layout of a building wall. The rear…

A: Given, Length of tape = 100 ft To find : Measured distance

Q: A simply supported beam 6m long is composed of two C 200x28 channels (use uniform weight of the beam…

A: Given:- Length of simply supported beam, L = 6 m = 6000 mm Section of the beam is made of two C 200…

Q: A 20 mm diameter circular rod carries a pull parallel to the centroidal axis at a distance from it.…

Q: COURSE AB 8886 BC CD DA DISTANCE 120m ? 100m 80m 43. The length and bearing of BC 44. The area of…

A: here question contain multiple question so As per our guidelines i will answer only first question

Q: Question # 01 A w=2 S mmmm 4 l B 8 8 4 Draw shear and bending moment diagrams for the following…

A: Given: Required : Shear force and bending moment diagram

Q: For an earth retaining structure shown in figure below, construct earth pressure diagram for active…

Q: Design spectra are based on the response spectrum for a single representative earthquake at the…

A: Design spectra is used to design a new structure based on response spectrums of an earthquake in…

Q: Question 10: ( 1 a level is set up midway between two stakes as shown in the figure below. The two…

A: Data given Distance between stakes = 200 ft Level midway Reading on stake A = 8.72 ft Reading on…

Q: The 616-N force is applied to the 106-kg block, which is stationary before the force is applied.…

A: Given, P = 616N uS= 0.66 uk= 0.48 W= mg= 106×9.81=1039.86N Free Body Diagram:-

Q: Which one is incorrect about assumptions made that are inherent to the unit hydrograph: Rainfall…

A: Given Data : ● Assumptions made that are inherent to the unit hydrograph: TO Determine: Wrong…

Q: 2. Three cables are connected at A, where the forces P and Q are applied as shown. Know- ing that…

Q: A wastewater sample was diluted 10% with tap water for conducting BOD Test. The DO content in…

A: Given data in question Initial DO of sample 1.2 mg/l Initial DO of water 6 mg/l Final DO of sample…

Q: Question 1 The table below shows twelve spot speed values measured at a specific point on an urban…

Q: True or False: Obsidian (A.K.A volcanic glass) is a mineral.

A: Introduction- Obsidian (A.K.A volcanic glass)- It is an igneous rock that forms as natural glass…

Q: You have been asked to obtain an object/structure/component that has failed (It may come from your…

Q: A Triangular masonry (specific gravity = 2.5) dam with with height 50 m and base 30 m retains water…

A: Water lateral pressure is give overturning moment to the dam. Weight of gravity dam is given…

Q: An accidental or compensating error can be eliminated by proper procedures. True False

A: Accidental or Compensating Error- It is that type of error which happens by mistake due to several…

Q: Bond, Anchorage and Development Length Question 1: How much shall be the development length of 25 mm…

A: Given- 25 mm diameter deformed barFe415 steel in tension,Design bond stress in tension=2.24 N/mm2

Q: A bracket of negligible weight is loaded with a force P of 3 kN. For interconnection purposes the…

Q: The uniform beam has a mass of 50 kg per meter of length. Determine the reactions at the supports.…

Q: Problem # 3: For the given beam, use 150 pcf concrete: Consider two possible load combinations: a.…

A: Given: Load conditions: U=1.2D+1.6L U=1.4D Loads: WD=3.7 kip/ft + self weight WL=0.75 kip/ft…

Q: A reservoir with a live storage of 250 million cubic metre irrigate 40000 hectares (1 hecatre = 104…

A: Given Data Live storage of reservoir = 250 million cubic metre Live storage filled two time. Area…

Q: A 4.5 % grade intersects a - 2.6% grade at station 1 +990 of elevation 42.30 m. Design a vertical…

A: Given data, Design speed (V) = 56kph G= 4.5%= 0.045 n= 4.5-(-2.6) = 7.1% h1=1.37m h2= 0.1m f= 0.13…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Round your answer to 2 decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?
A hollow cylinder 2.46-m in diameter and 7-m long weighs 3,159 N. How many cubic meters (m3) of metal weighing 112 kN/m3 must be placed inside the cylinder such that 2.9 m. of the cylinder is protruding above the liquid surface? The hollow cylinder is submerged in a liquid that has a specific gravity of 2.3. Round off to four decimal places.
A cylindrical container with a diameter of 1.0 m and a height of 2.0 m weighs 294N. If the container is filled with a liquid, the whole weighs 14.70 KN. Determine the density of the liquid.
1) 10 cu.m. OF Kerosene oil weighs 8000kg. Calculate its specific weight, density and specific gravity. 2) If an object has a mass of 45 kg. At sea level, what will be its weight at a point where the acceleration due to gravity is 9.75 m/s^2? 3) What is the value of the surface tension of a small drop of water 0.5mm in diameter which is in contact with air if the pressure within the droplet is 400Pa? 4) A reservoir of glycerin has a mass of 1,200 kg and a volume of 0.952 cu.m. determine the ff. a.) weight of glycerin b.) specific weight of glycerin c.) specific gravity of glycerin 5.) Find the capillary rise in a tube for a water glass interface (teta) = 0° if the tube radius is 1mm and the density is 1000 kg/m³. Surface tension of water is 0.0728 N/m.
determine the density(lb/ft3) of a cubical body whose side is equal to 1.19 in and has a mass of 3.15 lbs
Suppose that one such tank is cylinder shaped, 50ft high with a radius of 20ft. If we assume that water is pumped out of the tank via a pipe directly on top of the tank and that the tank is filled to a depth of 30ft, how much work (in ft-lbs) would be done by a pump to empty the tank? You may take the density of water to be 62.4 lbs/ft3
The outside diameter of a right circular cylindrical tank is 3,000 mm and its height is 6,000 mm. If the thickness of the tank is ¼ inch, calculate the capacity in gallons.
A 1.50-kg steel ball is dropped from a plane to an ocean. If the velocity of the ball just before reaching the water is 11 m/s and if the resistance in the water is 2.8v, what is the distance travelled by the object after 3.3 seconds? Answer in four decimal places. differential equation
If the specific gravity of the unknown fluid is 12.56 what is its specific weight in lb/ft³?
An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION 1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place
Calculate the mass (kg) of a fluid having a volume of 2 m^3 and unit weight of 11.2 kN/m^3.
A cylindrical container with a diameter of 1.0 m and a height of 2.0 m weighs 294N. If the container is filled with a liquid, the whole weighs 14.70 KN. Determine the specific weight of the liquid.