A DC generator delivers a 30-A current to a load at 120 V by consuming 4500 J/s of mechanical energy. Determine the efficiency of the generator.

Q: Given the flux density D = (6/r) cos(2θ) aθ C/m2, use two different methods to find the total charge…

A: The solution is given below  Basic problem on charge

Q: 7. Determine the value of R and current through it in figure 4, if the current through branch AO is…

A: Since you have asked multiple questions , we will solve the first question for you . If you want any…

Q: Calculate VCE- Please show complete solution Rc 1.2 kn C2 HE 10 μΕ B - 45 10 μΕ Re 100 kn VEE - -9 V…

A:

Q: A 4 1 4-pole, 3-phase, 50 Hz, slip-ring induction motor hort-circuited. The rotor resistance is 0.1…

A:

Q: TUTORIAL PROBLEMS 1. A (medium) single phase transmission line 100 km long has the following…

A:

Q: N.m, 1333r.p.m] The resistance and standstill reactance of each phase of a 3-phase induction motor…

A: First calculate slip.in terms of synchronous speed and then find slip at pull out torque. From slip…

Q: A 275mH inductor with a quality measure of 6 and a 1502 resistor are series connected to a 120V,…

A: Given a series RL circuit, Inductance, L = 275 mH Quality measure, Q = 6 Resistance, R = 150 ohm…

Q: The current gain of an amplifier is 500, the load resistance is 100Ω, and the input resistance of the…

A:

Q: Consider the circuit shown in Figure Q1(d), calculate the equivalent inductance, Leq at terminal…

A:

Q: 2. A full wave rectifier is used to convert 400 Hz ac tode Desi a full-wave rectifier power supply…

A:

Q: A blown-fuse visual indicator uses a a. Light-emitting diode • b. none of these c. Zener diode • C.…

A: Consider the fuse blown indicator is used to determine the condition of the fuse.

Q: A buck converter has an input current o 24 A while requrd ouput curent is 6 A Whatwil e he uy yde of…

A: Given: A buck converter has, Input current, Iin=2.4 A Output current, Iop=6 A

Q: For the circuit in Fig. 2,determine: (a) the voltage across each capacitor, (b) the energv stored in…

A: Given, We have circuit, We have to find the voltages across each resistor. And energies. Please find…

Q: A parallel RLC circuit has the following component values: R = 33.33 ohms, L= 4 H, and C= 2.5 mF,…

A: In this question we will write about parallel RLC circuit oscillation frequency....

Q: 2. A 3-phase transmissIOll Tme, 0-2 2 Resistance/phase/km Reactance/phase/km Shunt…

A:

Q: 9. The transfer function C(s)/R(s) for the following block diagram is R(s) 1 C(s) s+2 s+3 O 24/(s2 +…

A: In this question we will find transfer function of given systems...

Q: In the circuit of Fig. 2.75, calculate V¡ and V2. -구v + + 10 V V2

A: This problem is from kcl and kvl  The solution is given below

Q: A 16+100kW,230V, shunt generator has Ra = O.07 π and Rf = 77.5 - 16 π. The generator has a total…

A:

Q: The voltage in Fig. 5 is applied across a 30uF capacitor. Draw the current waveform through it. (1)…

A: This question belongs to circuit theory . It is based on the concept of drawing current waveform…

Q: 1- How does a diode wo a voltage regulator? 2- What is a Zener breakdown? 3- What happens to the…

A: In this question we will write about how diode work as a voltage regulator.....

Q: The current in a 20 mH inductor has the waveform shown in Figure Q1(c). Draw the waveform for the…

A: We need to find out voltage across inductor

Q: 5-21. Determine the net receiver gain for an AM receiver with the following gains and Gains: RF…

A: In this question  Gains and losses for AM receiver is given....We have to find out net receiver…

Q: Home Work 5 Find t 0.5 ms 160 2 40 2 20 mH ww ww

A: In this question,  We need to determine the time constant for the given circuit.  For RL circuit,…

Q: What does the negative sign in the voltage gain of the common-emitter fixed-bias configuration indie…

A: Option a is correct

Q: A Short shunt compound generator delivers a load current of (16)A at 400V.  Armature resistance 0.08…

A:

Q: A 4-pole, 3-phase, 50 Hz induction motor at standstill has 120 V induced across its star-connected…

A:

Q: Explain disadvantages of ASK modulation system.

A: In this question we will write disadvantages of ASK modi karoon system......

Q: The cylindrical surface ρ = 8 cm contains the surface charge density, ρS = 5e−15|z| nC/m2. What is…

A: In this question cylindrical surface with surface charge density is given...We have to find out to

Q: "Resistors in Series and Parallel" PART1: The Resistors in Series Objective: To analyze the…

A:

Q: Find 1=0 4 H ww ell 24 V 42 ww

A: Please refer the attached images for the complete answer..

Q: Two resistors are connected in parallel with a total resistance of 50 Q and a total noise voltage of…

A: Please refer the attached images for the complete answer..

Q: S2 R2 Key Space X6 X4. x5 5V_1W V2 24V 5V 1W 5V 1W 47

A: KCL- Kirchhoff's Current Law. It suggests that the sum of all the incoming current is equal to the…

Q: Find the total real power dissipation in a balanced wye-delta system. Load impedance is 5kN270° and…

A: It is given that: Vp=320 VZ△=5∠70° KΩ=5×103 ∠70° Ω

Q: Q.5 The inputs to a full adder are A = 1, B = 0, Cin = 1. The outputs are ( a) Σ-0, Cout1 ( ) Σ = 1,…

A:

Q: Re=3k RE =1k Rz =lok RL= 100k Ri =1k Vec = 20V %3D Vcc R. Re Vo C2 hfe = h Fe = l00 hre = hoe = 0…

A:

Q: a) The house circuit diagram is shown in the figure below, where ⨷ represents a lightbulb of…

A: A circuit diagram is shown in the question. ⊗ is a lightbulb in the circuit has a resistance of r'…

Q: A B Y 1. D ABCD 00|0 X YZ 1 1 1 1 1 1 1 1 1 1 1 Write the expressions for the outputvariables 1 1 X…

A: A logic gate circuit along with its truth table is given in the question. We need to give the…

Q: ww www Calculate equivalent resistance across terminals A and B. A ww www 52 w- 32 5Ω 4 21 ww

A: Given, We have a circuit. We have to find the equivalent resistance. Please find the below…

Q: ?What is the relationship between gain, feedback and Deviation? 4:42 PM /

A: This question belongs to feedback systems

Q: 1.Determine the expressran Pv of with each

A:

Q: Q3: The output for the following clipping circuit is shown below. the average value and me Fi…

A: Brief description:  Diode is an ideal diode. Clipper circuits are used to remove some part of the…

Q: The impulse response of the system y[n]=x[n-1]+x[n-4] is O h(n]= [0 1 0 1] O h(n]= [1 1 0 0 1] O…

A: Given data, yn=xn-1+xn-4

Q: Q. In the circuit shown below, measurement indicates VB to be +1.0 V and V, to be +1.7 V. What are a…

A:

Q: A 2N6755 Harris n-channel MOSFET has a de supply voltage of 60-V, a

A:

Q: The graph in Figure Q1(a) shows the variations of charge, q versus the potential difference, V for…

A: This question belongs to circuit theory . It is based on the concept of relation among capacitance ,…

Q: Define AC Generator - Why does DC excitation is used rather than AC excitation? - How does number…

A:

Q: The figure below shows the small signal equivalent circuit of a transistor amplifier. The transistor…

A:

Q: The voltage across a 5 mF capacitor is shown in Figure Q1(b). (1) Draw the current waveform through…

A:

Q: Find the phasor voltage V, in the circuit shown in the following Figure. Assume an ideal transformer…

A:

Q: What type of diode is commonly used in electronic tuners in TVs? a. Schottky • b. LED O . varactor •…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.