A DC generator supplies current to 40 lamps with a power of each 60 Watts each. Calculate the current IL. Calculate the magnitude of the voltage generated by the generator in problem 1, if Ra = 0.1 Ohm and Rsh = 50 Ohm

Q: 1. In the following diagram, you have the architecture of the Intel 8086 questions: Briefly the foll...

A: Given: In the following diagram, the architecture of the Intel 8086 microprocessor is shown: To fin...

Q: The PTs of a 220 kV transmission line have ratio of 132.76 kV / 66.375 V and are connected wye-wye. ...

A:

Q: Design an op-amp circuit to yield the relationship shown in each equation. Vo = V1 + 10V2 – 3...

A: a) Assuming, Rmin=Rf=6kΩ Inverting input V1 and V2 using inverting amplifier: Taking Rin=Rf, The ou...

Q: How far is it from A (100, 30°, 60°) to B (40, 75°, 125°)?

A:

Q: 3) The region where an amplifier is operating in a linear format is represented by: a) The positive ...

A: 3) The region where an amplifier is operating in a linear format is represented by:       4) For osc...

Q: Q2) Design a quarter-wave transformer to match a 100 load with a transmission line with a characteri...

A: Given, Load impedance (ZL) = 100 ohm Characteristic impedance (Zo) = 50 ohm Frequency = 10 GHz  

Q: Find and plot y(t) = x(t) * h(t) h()

A: In this question,  We need to determine the output y(t) if x(t) and h(t) is given.  We are solving t...

Q: A rectangular waveguide with dimensions a = 1.5 cm, b = 0.8 cm is filled with a dielectric with µ = ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: 1.8 The power delivered to an element is p = 12 sin 4t W and the voltage is v = 4 sin 2t V. Find the...

A: The solution is given below 

Q: Two units, connected in parallel, are energized by an a-c source. If the component currents are 15 a...

A:

Q: please help me with this question

A:

Q: 6. Determine V, and I, for the networks of Fig. 2.135. 5V 12 ka Si 22ka 4.7 Aa (h)

A: The Diode current: This is a current which flows in the diode when the diode is ON. In off condition...

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v 1 0.5 0.06 0.3

A:

Q: There is a constant current source whose value is 8A now there are three resistors connected to it i...

A: Voltage across the parallel connected elements is same.  Using above condition and using KCL at node...

Q: Question No. 4: For the below circuit, assume that: V1(t) = 20 sin(wt+30°) V2(t) = 10 cos(wt+30°) V3...

A:

Q: A2 3:2 220V 1k V2 V3 1. What is V1 reading? 2. What is V2 reading? 3. What is V3 reading? 110V 146.6...

A: Rectifier circuit: This is used for converting the AC quantity into the DC quantity.

Q: Question No. 2: Let z1 = 1 + j3 and z2 = -3 + j6. (a) Compute the polar form of z1 and z2. (b) Compu...

A:

Q: Explain why Silicon and Germanium are the most common semiconductor materials used in Electronics De...

A: The solution is given below 

Q: F1Β (A' + AC) F2 = (A+ C')(B + B'C') A В F1 F2

A:

Q: Three impedance Z1=1-j4, z2=-6. and z3 = 4 +j3 respectively are connected in series parallel. Z1 is ...

A:

Q: Find the Thévenin and Norton equivalents for the ab two-terminal circuit. Then, calculate the voltag...

A: Solution- 1. Vth Calculation-         Apply KCL at node VA, 2.5 =VA10×1000+VA-1500i20.5×10002500 =V...

Q: Question 4-) The linear electron-concentration profile shown in the figure below has been establishe...

A: The given electron concentration profile is shown below: It is given that: no=1017 /cm3W=4 μm=4×10-...

Q: An N-channel JFET has IDSS = 16 mA and VP= -6 volts. Calculate the drain current and VDS (sat) when ...

A: JFET An N-Channel JFET consists of electrons as the charge carrier that constitutes the current flow...

Q: 3. Vp and Ip Ip + E 10V 2.4KO (a) +

A: We need to find out voltage and current for given circuit

Q: (B): Apply Mesh analysis method to find the current i in figure (2.2). 20 Q 8 V i 2Ω 6Ω iz iz 10 2 1...

A: Given circuit,

Q: Given the graph of the cosine function f (x) = cos x, evaluate the following limits: 27 37 1. lim co...

A:

Q: [21] To reduce the resistance of a conductor, its temperature should be * increased decreased not en...

A:

Q: Q3- The overshot of the step response of a second order feedback system is 30% and settling time is ...

A:

Q: 3nu(-n) 0.1nu(-n) + 2nu(-n) Determine if stable system or not using infinite geometric series formul...

A: If the GM series converge to a finite value then the system is stable otherwise Unstable.  

Q: 7. A 50 uFarad is connected in series with a coil having 50 ohms resistance and a 150 mH inductance....

A:

Q: . There is a wire that is cut and its resistance is 12.5 ohms, if the wire is 560m long and its resi...

A:

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 cos(wt+30°) V2(t) = 10 sin(wt+60°) V3...

A: In this question,  We need to write the polar representation.  Polar form is representation by rms v...

Q: incult shown in tigure for the Coupled below, detexmine the value of current Î and Ig ssume V=loo.

A: The given circuit is shown below: V=100 V

Q: A series LC circuit has L = 100 pH, C= 2500 microfarad and Q= 70. Find (a) resonant frequency (b) ha...

A:

Q: 5. A generating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor...

A:

Q: For the circuit below calculate Zin in rectangular form if w = 100 rad/s L=0.04H R=10 V out C=0.25F

A:

Q: The potential transformer of a line has a ratio 132,000/66. These are connected wye-delta. The voltm...

A: Writing the expression of turn ratio for wye-delta connection. TR=NPNS=VP3VS                        ...

Q: Derive the simplified POS expression for the function F (A,B,C,D,E)=summation of minterms  (0,2,4,6,...

A: Kamp-Kamp / Karnaugh maps are Boolean algebra simplification techniques. Using maps expressions can ...

Q: 32.) Apply Kirchhoff's current law and voltage law to the circuit shown below to identify the branch...

A:

Q: Make a Wiring Diagram of Two – Station Start Stop Motor Control.

A: Start Stop Motor Control- In the simplest form, it is a circuit designed to supply power to, and rem...

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: The NTSC stands for National Television system Committee and the NTSC Signal is used in television s...

Q: 1. The unbalanced A-load below is supplied by balanced line-to-line voltages of 240 V in the positiv...

A: In this question Unbalanced three phase Delta load is given.  Find the line currents?  If line volta...

Q: Identify and explain the different notational methods for describing the behavior of gases and circu...

A: The term notational method refers to a process of noting or mentioning something with the help of sp...

Q: c) For the circuit in Figure 2.3, solve for Vo, Ip, and the power dissipated in the diode. The diode...

A:

Q: A pulse radar system has the following specifications/parameters: PT=100 kW ; Receiver sensitivity=1...

A: Given parameters: PT=1000KWReceiver Sensitivity=1μWσ=1 m2fc=1 GHzςp=2KHz   First we will calculate t...

Q: Determine the following: a. re b. Zi c. Zo where ro is infinite d. Av where ro is infinite

A:

Q: 3. A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing p...

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are peri...

Q: Transfer Function

A: Open Loop System-A control system having the input of the system does not depends on the output of t...

Q: Given the points T (5, 20°, 120°) to P (2, 80°, 30°): find the unit vector in spherical coordinates ...

A:

Q: A step in a space vehicle checkout depends on four sensors (A,B,C,D) . Every circuit is functioning ...

A: This question belongs to digital electronics . It is based on the designing of function according to...