There is a constant current source whose value is 8A now there are three resistors connected to it in parallel, they are resistors A, B, and C, their value is 10, 12, and X ohms respectively. Find the value of resistor C if it draws 2.5A

There is a constant current source whose value is 8A now there are three resistors connected to it in parallel, they are resistors A, B, and C, their value is 10, 12, and X ohms respectively. Find the value of resistor C if it draws 2.5A

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter8: Combination Circuits

Section: Chapter Questions

Problem 1PA: A circuit contains a 1000- and a 300- resistor connected in series with each other. The total...

See similar textbooks

Related questions

Q: R= ??? 2 I= 10A 2 V= 20V 200 Ohms 0.2 Ohms 2 Ohms 20 Ohms

Q: When the electric current through the DC motor is 2.0 A and the torque on the shaft is 0.34 Nm, the ...

Q: Use source transformation to reduce the circuit to a single source. solve for vo

A: A voltage source in series with the resistance or reactance can be transfer into the current in para...

Q: A2 3:2 220V 1k V2 V3 1. What is V1 reading? 2. What is V2 reading? 3. What is V3 reading? 110V 146.6...

A: Rectifier circuit: This is used for converting the AC quantity into the DC quantity.

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A: The solution is given below

Q: Si R 5.5 VO- >WO- 2.5V 3.65 k0 Si Figure A3

Q: 5. A building is to be provided with C.T.S. wiring and the details of load are as given below Locati...

A: CTS wiring is a category of internal wiring which provides the most efficient way of wiring.

Q: to the primary side. Question # 3 The coils of the magnetic circuit shown in the figure are connecte...

Q: Transfer Function

A: Open Loop System-A control system having the input of the system does not depends on the output of t...

Q: What is the Average value of 169sin 377t

A: average value = 1π×∫0TV(t) dt Here given signal is a sine wave , Though it has positive and negativ...

Q: Identify three common simple electrical gadgets/devices at home after which: 1. propose a new/revise...

A: Nowadays, With the evolution of very compact power electronics devices and controllers, we are surro...

Q: Consider an RCL circuit where R = 2, L = C = 1.

Q: Please give the step-by-step solution and the formula used.

Q: 14/ Find the form factor of the following waveform quarter cycle sinusoidal v(t) t2 +(sec) 1 3

A: The solution is given below

Q: 1. The operating voltage of the zener diode in the reverse region. a. forward voltage b. knee voltag...

A: 1. Answer: Breakdown voltage Explanation: a. It is not a valid option, the forward voltage is the vo...

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

Q: 2. A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a maxim...

A: Since you have posted multiple different question. we will solve the first question for you. To get ...

Q: Power consumed by an electrical equipment is 600 watts and voltage rating is 120 volts then find cu...

Q: We know the Fourier coefficients a,, b, of some signal which is being transmitted. The transmitter m...

A: The fourier coefficients are affected by doubling and shifting the modified parameters are written...

Q: Using superposition, find V, in the circuit of Fig. 4.76. Check with PSpice or MultiSim.

Q: I WO 1oads are connected in parallel across a 12,470-V rms source. One load takes 23 kVA at 0.75 lag...

Q: 2/ Calculate the average and r.m.s values of the current waveform given by: i(t) : = 100 + 25 sin 3w...

A: The solution is given below

Q: Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a...

A: I am answering three subparts of this question as per guidelines.

Q: dentify the machines/equipment that requires electricity for specific rice farm production/postprodu...

A: FIND: The machines/equipment that requires electricity for specific rice farm production/postproduct...

Q: y(t) = 50sin(200t + q) ? (w = 2TTF ) 1. How many frequencies make up the signal 2. What is the frequ...

Q: 9. If kr = Eripplerms/Eave, determine kr of the given waveform.

Q: Question No. 2: Let z1 = 2 - j2 and z2 = 2 + j6 (a) Compute the polar form of z1 and z2. (b) Compute...

Q: Identify the DC motor that can be used in Lift. Also, explain the requirement of a DC Motor to be se...

A: DC motor- A DC motor is an machine than converts DC electrical input fed to the armature (assuming t...

Q: 4. Obtain the power factor and the apparent power of a load whose impedance is Z=60+J40 OHMS when th...

Q: A circuit in which the resistance is almost zero ohms is referred to by which of the following terms...

A: This question belongs to circuit theory . It is about behaviour of resistance when value of resistan...

Q: Given the narrow (usable) audio bandwidth of a telephone transmission facility, a nominal SNR of 56 ...

Q: The wistantanerus valkres of furo altemating curpente are grven by i,-voSmiot and i, =10 Sin (ot + )...

A: In this question, Two alternating current is given. Find the sum of the both current using the pha...

Q: The figure above on the left side shows the first quadrant of the J-V and power curves of an ideal a...

A: Given the figure as shown below: A) From the following figure, we need to find Fill Factor for the ...

Q: Use the analytical method, design a

Q: Identify and explain the different notational methods for describing the behavior of gases and circu...

A: The term notational method refers to a process of noting or mentioning something with the help of sp...

Q: Provide a brief (a few phrases) definition and description of each of the following, as well as an e...

A: In consideration of complex system, there are many differential equations. These equations are commo...

Q: 4. Simplify the following Boolean expressions. (a) A.B.C+A.B.C+A.B.C+ A.B.C+A.B.C + Ā.B.C+Ā.B.C +A.B...

A: Given that simplify equation a. A.B.C+A.B.C+A.B.C+A.B.C+A.B.C+A.B.C+A.B.C+A.B.C b.A+B+C.A+B+C.C+D.C+...

Q: 1 kΩ ww 1 V RL Figure 4.55 For Example 4.15. Find the maximum power transferred to RL if the 1-k2 re...

A: In this question, We need to determine the maximum power transfer to the load resistance RL If 1k...

Q: cylindrical copper having a diameter of 0.4 in. has a resistance of 0.00264 Ω. Taking the resistivi...

A: Given thatdiameter d=0.4cmr=d2=0.42=0.2cmR=0.00264ΩResitivity ρ=1.745μΩ-cm

Q: Problem 2 The cylindrical machine the following parameters Lss = 0.15 H L,= 0.06 H %3! Lsr = 0.08cos...

Q: Q1: For the parallel network find the unknown quantities: E, R1, and 13. 12.3 A E R1 R2 20 Ω R: 4Ω 1...

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: (4) 0,lkn 3v 5V DA Vo Paw Vo

A: We need to find out output voltage and we need to draw it .

Q: What is the POS representation equivalent to the SOP Boolean formula shown? Y = ABC + ABC +ĀBC + ABC...

A: Given, Y=AB¯C+AB¯ C¯+A¯ B¯ C¯+A¯ B¯C

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A: In this question we will find minimum and maximum currents of zener diode...

Q: X Y BiD Bo 1 1 1 1 1 1 1 1 1 ㅇ 1 1

A: Given Full subtractor table withX ,Y,Bi are inputs D,B0 are outputs D-difference B0-Borrow o...

Q: Four capacitors are connected in parallel with a battery shown in the figure. Simply the schematic d...

Q: Determine the current through R2 and R3 in Figure 2.

Q: modulated by a 2-kHz sine wave between

Q: 1) 200 HHw Vout Vaut= エ= 7v Vadt Vat= 1.2KL 4.722 200 VA= VA VB V8 =

Q: 1. If ?1 = 30sin (?? + 100 ) and ?2 = 20sin (?? + 500 ), which of these statements is true: (a) ?1 ...

A: Note: As per the policy we can solve only one question at a time, please re-upload the remaining que...

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 93-V source is in series with six resistors having resistances of 4, 8, 15, 19, 25, and 2 ohms. Find the voltage across the 19-ohm resistor. Round your answer to 2 decimal places.
Determine the voltage across R2 in the figure below, if the source is 6V, the Zener is 5.2V, R1= 10k ohms, and R2= 10k ohms.
Two resistors A and B are connected in series with a 220-V DC source. a voltmeter with an internal resistance of 10k Ohms is connected across resistor A, the instrument reads 100V and when connected across resistor B, it reads 80V. Find the value of the two resistances in series. please show complete solution.
A 12v battery of 0.05 ohm resistance and a 12v battery of 0.075 ohm resistance supply power to a 2 ohm resistor, what is the current through load? draw the circuit and apply kirchoffs laws to solve for the unknown.
If the resistors A and B are connected in parallel, the equivalent resistance is15 ohms; A and C, 12 ohms; and B and C, 20 ohms. Find the power absorbedby the series combination of A, B and C if the combination is connected across a 120-V dc source.
A 12 V battery of 0.05-ohm resistance and another battery of 12 V and 0.075-ohm resistance supply power to a 2-ohm resistor. Draw the circuit and apply the Kirchhoff's law to solve the unknown.
A 30-ohm is connected in parallel with a variable resistance R. The parallel combination is then connected in series with a 3-ohm resistor. Find the minimum value of R if the power taken by R is equal to the power taken by the 3-ohm resistor.
Figure shows the arrangement of 3 resistors, which are connected to 3 sources: 70 V, 60 V and 80 V a)Using Kirchhoff’s rules, find the current in each resistor shown in Figure
A 12V battery is connected in a circuit having three series-connected resistors having resistances of 4 ohm, 9 ohm and 11 ohm. Determine the current flowing through, and the p.d. across the 9 ohm resistor. Find also the power dissipated in the 11 ohm resistor.
Two resistors of resistance R and connected in series with each other and in parallel with a cell with emf V. What is the current flowing through one of the resistors? Select one: a. V/2R b. V/R c. 2V/R d. 2VR
The equivalent resistance of four resistors joined in parallel is 30Ω. The currents flowing through them are 0.5,0.4,0.6 and 0.1 A, Find the value of each resistor.
A coil of resistance 16 ohm is connected in parallel with a coil of resistance R₁. This combination is then connected in series with resistances R2 and R3. The whole circuit is then connected to 220 V D.C. supply. What must be the value of R1 so that R₂ and R3 shall dissipate 800 W and 600 W respectively, with 10 A passing through them?