A dielectric of permittivity 3.3x10-11 F/m completely fills the volume between two capacitor plates. For t> 0 the electric flux through the dielectric is (7700 V m/s³ )-t³. The dielectric is ideal and nonmagnetic; the conduction current in the dielectric is zero. Part A At what time does the displacement current in the dielectric equal 20 μA ? Express your answer in seconds. Π| ΑΣΦ ? Submit Request Answer S

A dielectric of permittivity 3.3x10-11 F/m completely fills the volume between two capacitor plates. For t> 0 the electric flux through the dielectric is (7700 V m/s³ )-t³. The dielectric is ideal and nonmagnetic; the conduction current in the dielectric is zero. Part A At what time does the displacement current in the dielectric equal 20 μA ? Express your answer in seconds. Π| ΑΣΦ ? Submit Request Answer S

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 106CP: A parallel-plate capacitor with plate separation d is connected to a source of emf that places a...

See similar textbooks

Similar questions

A parallel-plate capacitor with plate separation d is connected to a source of emf that places a time-dependent voltage V(t) across its circular plates of radius r0and area (a) Write an expression for the time rate of change of energy inside the capacitor in terms of V(t) and dV(t)/ dt. (b) Assuming that V(t) is increasing with time, identify the directions of the elecuic field lines inside the capacitor and of the magnetic field lines at the edge of the region between the plates, and then the direction of the Poynting vector S at this location. (c) Obtain expressions for the time dependence of E(t), for B(t) from the displacement current, and for the magnitude of the Poynting vector at the edge of the region between the plates. (d) From S , obtain an expression In terms of ‘(t) and dV(t)/dt for the rate at which electromagnetic field energy the region between the plates. (e) Compare the results of pails (a) and (d) and explain the relationship between them.
An automobile with a radio antenna 1.0 m long travels at 100.0 km/h in a location where theEarth’s horizontal magnetic field is 5.5105T . What is the maximum possible emf induced in the antenna due to this motion?
On its highest power setting, a microwave oven increases the temperature of 0.400 kg of spaghetti by 45.0°C in 120 s. (a) What was the rate of energy absorption by the spaghetti, given that its specific heat is 3.76103J/kg.C ? Assume the spaghetti is perfectly absorbing. (b) Find the average intensity of the microwaves, given that they are absorbed over a circular area 20.0 cm in diameter. (C) What is the peak electric field strength of the microwave? (d) What is its peak magnetic field strength?
If electric and magnetic field strengths vary sinusoidally in time at frequency 1.00 GHz, being zero at t=0, then E=E0sin2ft. (a) When are the field strengths next equal to zero? (b) 4Jhen do they reach their most negative value? (c) How much time is needed for them to complete one cycle?
A pickup truck has a width of 79.8 in. If it is traveling north at 37 m/s through a magnetic field with vertical component of 35 μT, what magnitude emf is induced between the driver and passenger sides of the truck?
A pickup truck has a width of 78.4 in. If it is traveling north at 40 m/s through a magnetic field with vertical component of 33 ?T, what magnitude emf is induced between the driver and passenger sides of the truck? _______mV
What inductance must be connected to a 17 pF capacitor in an oscillator capable of generating 550 nm (i.e., visible) electromagnetic waves? Comment on your answer.
What is the total energy transported per hour along a narrow cylindrical laser beam 1.80 mm in diameter, whose B-field has an rms strength of 1.10×10−101.10×10−10 T ?
A constant electric flux of 1800 Volt-meters passes through the center of a loop of wire whose diameter is 0.2 meters. What is the magnitude in Tesla of the magnetic field induced at the wire?
Suppose a conducting rod (mass m, resistance R) rests on two frictionless and resistanceless parallel rails a distance l apart in a uniform magnetic field B (⊥ to the rails and to the rod) as in the figure. At t = 0 the rod is at rest and a source of emf is connected to the points a and b. Find a formula for the net electric field in the moving rod as a function of time for the case, when the source puts out a constant current I. Find a formula for the net electric field in the moving rod as a function of time for the case when the source puts out a constant emf E0.
A spatially uniform magnetic field is restricted in a circular region of spacewith radius of 2.5 cm and has a constant direction; see figure below. If themagnetic field varies with time t as B(t) = (25 mT/s^2)t^2, what is the magnitude of the induced electric field at a distance of 4.00 cm from the center of the magnetic field region at t = 2 s?