Answered: A distance on an old property…

A distance on an old property description is recorded as 1.5 chains. This is equal to (a)15ft (b)150ft (c)15 meters (d) 66ft (e) 33ft (f) 66 meters (g) 33 meters (h) 13.5 ft. (i) none of these

Architectural Drafting and Design (MindTap Course List)

7th Edition

ISBN:9781285165738

Author:Alan Jefferis, David A. Madsen, David P. Madsen

Publisher:Alan Jefferis, David A. Madsen, David P. Madsen

Chapter7: Construction Procedures

Section: Chapter Questions

Problem 7.5Q

See similar textbooks

Related questions

Q: 12 kN 14 kN 16 E B D

Q: 1, determine the beam deflection vc at point C.

Q: 3. The tank in the figure is filled to its top with gasoline. If the truck has a constant…

A: To find out the pressure at point A, B, C and D within tank. Given data, Acceleration = 4 m/s²…

Q: A hollow, metal circular pipe ABC (see figure) supports a load P, = 113.2 kips acting at the top. P…

Q: 3. The acceleration of a particle traveling along a straight line may be described by the equation…

Q: Given the tabulated measurement of the closed traverse as shown. Determine the missing data. Line…

Q: Using the Moment Distribution Method (MDM) Solve for the Support Reactions w (kN/m) Given that „A EI…

Q: A calibration test of a 0.00785 m2 circular sharp-edged orifice in a vertical side of a large tank…

Q: Given the following adjusted technical description, solve the AREA using Double Parallel Distance…

Q: Jarice memal y amely's 3) Solue far ali grece tions, 2 oulese tue Fined Vhy, By, Qy O.SL 0.SL

Q: A pipe system, connecting two reservoirs whose difference in water surface elevation is h= 43 m,…

Q: An infinite slope of granular soil has a slope of 29 degrees. The soil has a dry unit weight of…

Q: Problems to be solved during week 11: Question 9 (T1-T4) T1. Water is being pumped at 8.85 I/s by a…

Q: Steel joists are manufactured in different series to account for which of the following?…

A: Steel joists- Steel joists are an open web, lightweight metal trusses with matching hooks and a…

Q: Situation 7 - A long footing 2 m wide is buried at a depth of 1 m. Water table is located 0.40 m…

Q: An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per…

A: Given; Diameter of nozzle=5"=5×0.0254m=0.127m Velocity of water flowing out = 5m/s Rate at which…

Q: The simply supported beam consists of a W460 x 82 structural steel wide-flange shape [E = 200 GPa; I…

A: Find Deflection at C = ? Given data LAB = LBC = 3.6 m LCD = 1.7 m E = 200 GPa = 2 × 105 N/mm2 I =…

Q: KINDLY OBTAIN THE RIGHT ANSWER AND EXPLAIN Refer to Figure. Given that B =1 m, L = 3 m, and Q = 110…

A: Given - Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure…

Q: 5-5 Determine the maximum concentrated Toad at midspan that can be supported by a W360x134 section…

A: Given:- The maximum concentrated load is applied at the midspan of the W360×134 section The steel…

Q: Bar AB is supported by a frictionless surface at A and a 5/8 inch diameter pin at B. The pin at B is…

Q: 3 m L

Q: A 4m 3m

Q: What is the measure of position? What is the measure of variation? How do you find the measure of…

A: 1. What is the measure of position? A measure of position is very helpful in determining the…

Q: For the loading shown, use the double-integration method to determine (a) the equation of the…

Q: 10. A deed describes a trapezoid shaped parcel, but is missing the last call to the point of…

A: Closed traverse A closed traverse is a set of linked lines, the lengths, and bearings of which are…

Q: For the frame below, if the axial force in column AE is 9.18 k, what is the approximate axial force…

A: Option (b) is the most correct answer.

Q: A retaining wall is to be constructed shown below. It has the following information: Soil Parameters…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: What is the fixed end moment FEMAB for the beam with a settlement of 25 mm at support C: 20 kN/m 60…

A: Given data in question Span member length UDL Point load To find out Fixed end moment in AB

Q: Three pipes are connected in series. The first pipe has a diameter of 500 mm and a length of 600 m.…

Q: w (kN/m) A 1.5EI D El TTTT.

A: Can you please provide the figure correctly

Q: Why is it important to develop a farmstead

A: Farmers in India typically live in Villages found some separation away from their farms. Previously,…

Q: All members shown are made with 1 inch diameter steel bar with a circular cross-section and Young's…

A: E = 29 x 103 ksi

Q: For the loading shown, use the double-integration method to determine (a) the equation of the…

A: The double integration method is a powerful tool in solving deflection and slope of a beam at any…

Q: Question 22 Form the given beam loaded has shown, Ely = MAx + RĄ2² – ¿P(x – )² +C1 - Ely =D 글MA교2 +…

Q: 6. Timber floor: The cross-section of the beam is 8x22cm (bxh), axial spacings 0,60 m. Timber class…

Q: A line was measured with a 30-m steel tape and its measured direction with the use of compass was S…

A: Answer Let us first calculate the sag correction based on the given data. Calculation of Sag…

Q: Use the principal of superposition.

Q: For the beam below, determine the maximum negative shear at point D due to a concentrated live load…

A: Given data in question Span member length Dead and live load To find out Maximum negative shear…

Q: Item Answer Length of connecting line Bearing of connecting line Length of BC Bearing of DA

Q: Given the following adjusted technical description, solve the AREA using Double Parallel Distance…

Q: A 3 meter thick clay layer (pore water flowing in both directions) saturated with water loaded with…

A: The answer is found to be Coefficient of consolidation Cv=0.01272 m^2/day For explanation please…

Q: A circular steel rod of diameter d is subjected to a tensile force P = 3.5 kN (see figure). P = 3.5…

Q: A line was measured with a 30-m steel tape and its measured din W. The tape is standardized at 20-C…

Q: Determine the ultimate bearing capacity, in kPa. Round off to two decimal places.

Q: H 0000 B D 4 m 4 m 4 m

Q: Given the following Northing and Easting, use the COORDINATE METHOD to solve for the area of this…

A: Plot the given coordinates Area calculation: Calculation of distance, Latitude, Departure of AB…

Q: a. Use Porter's 5 forces model and analyse the business unit of an Australian-based multinational…

A: (b) Human Resource- From recruiting and hiring to professional development and retirement benefits,…

Q: 8. Compute for the following and show the tabulated solutions: Azimuth LINES Length (S) AB 1020.87…

A: Solution Line Length Azimuth Latitude departure Correction Adjusted Adjusted Length Adjusted…

Q: Determine the support reactions on the pin and roller as shown in the figure below. Simplify your…

Q: Josh threw the marble vertically upward with a speed of 70 ft/s from a bridge. On the way down, the…

Concept explainers

Surveys of public lands

A survey is a method used to determine the relative positions of various objects on the land by measuring the horizontal distances between them. Briefly, a survey is a process of accumulation of data of various details related to land. The main objective of surveying land is to prepare maps to a suitable scale. Various types of maps such as topographical maps, cadastral maps, engineering maps, military maps, contour maps, geological maps, archaeological maps, and so on can be prepared by surveying.

Question

A distance on an old property description is recorded as 1.5 chains. This is equal to (a)15ft (b)150ft (c)15 meters (d) 66ft (e) 33ft (f) 66 meters (g) 33 meters (h) 13.5 ft. (i) none of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the length of the drawbridge, r, is 25 meters, and the point P is 16 meters above the roadway, what is the distance d ?
Q1.) Consider a triangular shaped pasture for which a perimeter fence must be built. The length of the side A is 300m +- 2%, the length of side B is 400m +- 3%, and the length of side C is 500m +- 0.5%. What is the nominal value of the measure in meters? What length of fencing must be purchased in meters?
What is the total length of the course AB if the rear tapeman holds exactly 5 pebbles and 3 pins after measuring the course AB and the partial length is 4.1 m? Assume that one tape length is equivalent to 10 m.
Calculate the bearing of a line joining the SW corner of the NE ¼, of the NE ¼ of Section 29 and the SW corner of the NE ¼, of the SW ¼, of Section 11, both in the same township. (provide a sketch to support your answer)
A surveyor measured the road frontage of a parcel of land and obtained a distance of 306.93ft Based on this result, the distance must be between what two values?
Find the limit, if none, kindly write DNE. lim of (3x-8)^5 over (2x^2+2x-5)(x^3-6x) as x approaches to + infinity.
The length of a water course passing through the fields was measured with 30 m steel tape and the measured length was equal to 4 Gunter’s chain and 2 Revenue chains. Later on, it was found that the tape was approximately half link of Gunter’sChain too long. Find the true length of the line in meters.
1 pls!!!
What is the total length of the course AB if the rear tapeman holds exactly 5 pebbles and 3 pins after measuring the course AB and the partial length is 4.1 m? Assume that one tape length is equivalent to 10 m. USE STORED VALUES
3 DECIMAL PLACES ASAP
R= 60
a civil engineer, shows a technical description of the lot with field notes below: Find the bearing of the line 3-4. Find the azimuth from south of the line 2-3. Find the distance of the line 1-2. Find the area of the lot in acres using DPD-DPA method. ( Find the area of the lot in square meters using coordinate method. *units are in meters.