A drainage pipe beneath a dam has clogged with sand whose coefficient of permeability is found to be 8.0 meters per day. The average difference in headwater and tailwater elevation is 21.6 meters and it has been observed that there is a flow of 162 liters per day through the pipe. The pipe is 96.3 meters long and has a cross-section area of 180 sq. cm. What length of the pipe is filled with sand

A drainage pipe beneath a dam has clogged with sand whose coefficient of permeability is found to be 8.0 meters per day. The average difference in headwater and tailwater elevation is 21.6 meters and it has been observed that there is a flow of 162 liters per day through the pipe. The pipe is 96.3 meters long and has a cross-section area of 180 sq. cm. What length of the pipe is filled with sand

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.22P: Refer to Figure 7.24. The following data were collected during the field permeability measurement of...

See similar textbooks

Similar questions

Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
A 500 m long levee made of compacted clay impoundswater in a reservoir as shown in attached Figure There is a 1 mthick (measured in the direction perpendicular to the seam)sand seam continuing along the entire length of the levee, at10° inclination to the horizontal, which connects the reservoirand the ditch. The hydraulic conductivity of the sand is2.6 X 10-3 cm/s. Determine the volume of water that flowsinto the ditch every day.
For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under the Dam. X = 4, Y = 8. Note 1: Point A is located in the middle point of the equipotential lines. Point B is located in the middle point of the flow lines.Note 2: Assume e=0.8 (void ratio) and k=10^-3 cm/s (coeff. of permeability).Note 3: Datum is located at the bottom level of the water (right side of Dam).Note 4: Remember, the figure is drawn to scale. So, use the value of 2X+Y to estimate any dimension that you consider necessary.
A confined aquifer underlies an unconfined aquifer as shown. Compute the equivalent horizontal coeff. of permebility Compute the hydraulic gradient Compute the flow rate from one stream to another per meter width
The figure below represents a system with flow in the horizontal direction. Find the value of each pressure charge, level charge, and total charge in A, B, C, D, E, F, G, plus the real and approximate velocity of water flow plotting all of the above, given that soil porosity = 0.33 and transmittance coefficient = 0.50 cm/sec
Soil has interconnected voids through which water can flow from points of high energy to point of low energy. It is necessary for estimating the quantity of underground seepage under various hydraulic conditions. Based on that statement; (i) Briefly explain the discharge velocity of water. (ii) If discharge velocity of water through a soil is 24 cm/hr and soil porosity is 30%, determine the seepage velocity of the water.
Find the rate of flow in m^3/sec/m (at right angles to the cross-section shown in Figure 7.33) through the permeable soil layer. Given: H 4 m, H1 2 m, h 2.75 m, S 30 m, a 14°, and k 0.075 cm/sec.
the cross section of a levee, shown below, which is 650 m long and is underlain by a 2.5-m-thick permeable sand layer. It was observed that the quantity of water flowing through the sand layer into the collection ditch is 13.5 m3 /hr. What is the hydraulic conductivity of the sand layer?
Refer to Figure 6.14. Find the flow rate in m3 /s/m length (at right angles to the crosssection shown) through the permeable soil layer given H = 3 m, H1 = 2.5 m, h = 2.8 m, L = 25 m, a = 10°, and k = 0.04 cm/s.
Refer to Problem 8.4. Using the flow net drawn, calculate the hydraulic uplift force at the base of the hydraulic structure per meter length (measured along the axis of the structure).8.24 For the hydraulic structure shown in Figure 8.24, draw a flow net for flow through the permeable layer and calculate the seepage loss in m3/day/m.
Q- The wetted perimeter and cross-sectional area of a channel is 5 m and 9 sq. m respectively. What ois the hydraulic radius of the channel?
The section of a concrete gravity dam with its flow net diagram is shown in Pigure 10.38. The coefficient of permeability of the soil (anistropic) in the vertical and horizontal directions are 0.25 m/day and 0.58 m/day, respectively. The length of dam perpendicular to the paper is 120 m. 1. Determine the number of pressure drops 2. Determine the seepage loss 3. Determine the total amount of water percolated in one year.