A fan is listed having the  following performance with standard air: Volume discharge : 120m3 /s Speed : 7.0rps Static Pressure : 310mm water gage BP Required : 620kW The system duct will remain the same and  the fan will discharge the same volume of  120m3 /s of air at 93o C and a barometric  pressure of 735mm of Hg, when its speed is  7.0rps. Find the brake power input of the fan  and the static pressure required.   Provide solutions and schematic diagram.

Q: The Otawa power plant in Japan delivers 100 MW of power when the flow rate is 220 m^3/s and the…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 2 m below the pump center…

A:

Q: The characteristic given below refers to a main fan running at 8 rev/s and moving air with a density…

A: Given: The fan running speed, N = 8 rev/s The density of air, ρ = 1 kg/m^3 The mine resistance, R =…

Q: 11. A fan is designed to operate at a rotative speed of 20 rps. At the design conditions the airflow…

A: GivenRelative speed ω1=20rpsAir temp T1=20°C  =293KAir flow rate Q1=20m3/sStatic pressure rise…

Q: A pump impeller rotating at 1400 rpm has an outside radius of 21 cm, the vane outlet angle β2 is…

A:

Q: A fan is listed having the following performance with standard air: Volume discharge: 120cu.m/s…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 1 m below the pump center…

A:

Q: consumption, 4.05 kg; Calorific value of oil, 43000 kj/kg; het brake load 579N; Mean brake diameter,…

A: ρme=Mean Effective Pressure=275 kN/m2=275×103 N/m2Nc=Speed=360 rpmdc=Cylinder Diameter=0.20…

Q: A fan delivers 5.1 m^3/sec at a static pressure of 6.167 cm of water when operating at a speed of…

A:

Q: A pump draws water from an 8 in. suction pipe and discharges through a 6 in. pipe in which the…

A:

Q: The compressor design specifications are as follows: Clearance volume of 65 cm3 The bore of cylinder…

A: (4) The efficiency of the compressor can be increased by the following ways Since the isothermal…

Q: conditions are 101.3 kPa and 15°C. The clearance volume is 6% of the stroke volume and the…

A:

Q: A pump draws water from an 8 in. suction pipe and discharges through a 6 in. pipe in which the…

A:

Q: A pump delivers 10 liters/min with a pressure rise of 80 bar. The shaft speed is 1420 rev/min and…

A: Given: The value of discharge through the pump is, Q=10 Lmin. The speed of the shaft is, N=1420…

Q: A 5 in. x 4 in. double-acting simplex power pump is used to deliver water at 68oF. The pump operates…

A: Given data for double acting power pumpStroke length(L) = 5 inDiameter(D) = 4 inTemperature of…

Q: The discharge through pump is 0.04 cu. m per sec and velocity of flow is constant and equal tp 2m/s.…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 1 m below the pump center…

A: Given:  Centrifugal Pump Q = 0.56 m3/s d1 = 400 mm d2 = 250 mm hL = 4 m

Q: A single-stage, single-acting air compressor with runs at 600 r/min. It has a polytropic index of…

A: Given data as per question volume flow rate =0.72 m3/min Final pressure =660 kpa clearance volume…

Q: A gear pump has a 80-mm outside diameter, a 55-mm inside diameter, and a 25-mm width. If the actual…

A:

Q: A 6 kilowatt pump discharges 10 kilogram per second when the pump impeller diameter is 45 centimetre…

A:

Q: The following information were given for a single-stage, single-acting air compressor: Speed: 430…

A:

Q: A centrifugal pump operating at 900 rpm and delivering 30 L/s of water has a specific speed of 760.…

A: Given data as per question Specific speed =760 Absolute pressure = 0.6 kg/cm2 Diameter near…

Q: A single acting reciprocating compressor runs at 360 rev/min and takes in air at SSL conditions and…

A: Norte: According to Bartleby's guidelines first three subparts are solved. please upload other parts…

Q: A 5 in. x 4 in. double-acting simplex power pump is used to deliver water at 68 F. The pump operates…

A: Given: A double acting simplex pump of dimension 5 in. x 4 in. Speed of the pump is 750 rpm. Head…

Q: 2. A centrifugal pump installation has been designed to discharge 0.126 ?3/? of brine (sp.gr. =…

A: Given Data The discharge through the pump is:Q1=0.126 m3/s The specific gravity of brine is:S.G=1.2…

Q: Verify that S defined by (6.19) is dimensionless. What are the advantages of presenting performance…

A:

Q: A pump impeller rotating at 1400 rpm has an outside radius of 21 cm, the vane outlet angle β2 is…

A: Given DataN=1400 rpmr2=0.21mβ2=158°Cr2=4m/s

Q: A centrifugal pump is used to lift water from a water reservoir with level 2 m below the pump center…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 3 m below the pump center…

A: Level of lower reservoir from pump center line, H1=3 mLevel of upper reservoir from pump center…

Q: an is listed as having the following performances with standard air: Volume discharge — 120 m 3/s…

A:

Q: ind the pressure in cm of water

A: Given: Q1=5.226 m3/s P1=h1=6.895 cm N1=450.941 rpm P1=3.97 kW Q2=9.15 m3/s To determine:  The…

Q: A single-acting reciprocating pump, rnning at 50 r.p.m. delivers 0.00736 m/s of water. The diameter…

A:

Q: A Kaplan turbine develops 1500 kW under a head of 6 m. The turbine is set 2.7 m above the tailrace…

A:

Q: A centrifugal pump installation draws water from an underground well whose free surface is 50 m…

A: Given Data The suction head is : Hs=50+6=56 m  Diameter of suction pipe is : ds=150 mm=0.15 m…

Q: A centrifugal pump when tested with Brine of density 1190 kg per cubic meter discharged 60 liter…

A: Operating pressure = 300 kPa Volumetric flow rate = 60 lt/s = 60*10-3 m3/s Brine density = 1190…

Q: 1. For a given pump, the diameter, the gauge pressures at the inlet and outlet are −30 ×…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A double acting reciprocating pump, running at 100 RPM delivers 0.03 m^3/sec of water. The diameter…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 3 m below the pump center…

A: P1=1 bar,P2=4 barhL=4 J/N=4 m,Q=1.28 m3/sec,d1=400 mm=0.4 m,d2=250 mm=0.25 m, The pump diagram is as…

Q: 2. A pump 260mm suction pipe and a 150mm discharge pipe is used to deliver 58L/s of water. The…

A: Suction pipe diameter, d1=260 mm=0.26 mDischarge pipe diameter, d2=150 mm=0.15 mWater flow rate,…

Q: A single-stage, single-acting air compressor with runs at 600 r/min. It has a polytropic index of…

A: Given:Volume flow rate, V˙=0.72 m3/min,Volume of air taken, V1=0.72600  m3N=600 r/minV1=0.0012…

Q: A centrifugal pump is used to lift water from a water reservoir with level 2 m below the pump center…

A:

Q: 9. A certain fan delivers 12,000 cfm at a static pressure of 1 in water gauge when operating at a…

A: Given Flow rate at stage 1 = 12000 cfm RPM rate at stage 1 = 400 rpm Power at stage 1 = 4 hp Flow…

Q: The Otawa power plant in Japan delivers 100 MW of power when the flow rate is 220 m^3/s and the…

A:

Q: Q2) Pelton wheel A) Power produced by a Pelton wheel is (596.8 10'Watt) under a head of (150 m) with…

A: Given that velocity ratio=0.46 , head=150 m , power produced=596.8 KW , N=360 rpm=6 rps ; overall…

Q: centrifugal pump installation has been designed to discharge 0.126 m^3/s of  brine (sp.gr. = 1.2).…

A:

Q: A centrifugal pump is used to lift water from a water reservoir with level 2 m below the pump center…

A:

Q: 2. A pump is required to draw 50 of water from reservoir A, with static suction lift of 4.5 m to…

A:

Q: A centrifugal pump has a suction pipe with a diameter of 100 mm, and a delivery pipe with a…

A:

Q: 700 gpm of water are being discharged by a centrifugal pump 5 ft above the pump inlet. The inlet…

A:

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.