A) Find the equivalent resistance of the combination shown in the figure Req Ω

Q: 11C) The power input to a 3-phase induction motor is 60 kW. The stator loses a total of 1kW. find…

A: The phrase "induction motor" refers to a motor that works on the basis of electromagnetic induction.…

Q: 2. A loop contains three resistors and a battery, whose voltages are 3V, -4V, and 5V, respectively.…

A:

Q: Determine v, and i in the circuit shown in Fig.: 12 V 492 ww + 692 % 2% 4 V

A: Given circuit:

Q: input and output impedance

A:

Q: A) For the circuit in Figure v (r) = 60 sin (41+30°) V ( Determine the; i. ii. iii. Question Three…

A: Given, V(t)=60sin4t+30°V Mutual Coupling=M=2H, Inductance=L1=7H, Inductance=L2=6H Capacitor=C=1F,…

Q: Sine wave is a

A: The correct option along with the explanation is provided in the following section.

Q: In the figure you have a RL circuit with direct current. All resistors have resistance 30.0 , the…

A: Given:-  RL circuit All resistorsR1, R2,R3 =30.0 Ω Inductance L=3.0 H Voltage V=840.0 V At t=0…

Q: For the circuit shown in Fig. determine the unknown voltage drop V₁ 30 V + 2 V W + 1V_ +51

A: Given data, Given circuit diagram,

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes.. 1. An insulator 2. An…

A: The correct option along with the explanation is provided in the following section.

Q: Find Fourier transform of rectangular pulse as shown in Fig. 3.27 x(1) -T A FIG. 3.22 T

A:

Q: A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected…

A:

Q: Two resistors R₁ and R₂ (where R₁ = R₂) are connected in parallel to an ideal battery. Which of the…

A:

Q: The armature resistance of a 250 V D.C. shunt motor is 0.5 Ω. The minimum and maximum current during…

A:

Q: BT1 15+ R8 15k www R1 10k www · R2 30k + V1 www BT2 10 R5 15k W R3 30k V6 www + V3 R6 20k R7 20k 11…

A:

Q: Find the Total Resistance in the circuit if all the 8 resistances are equal to 36Ω and total voltage…

A:

Q: Find the line current, shaft speed, load torque, induced torque and rotor frequency of an induction…

A: The given information about an induction motor is Number of poles P=6. Rated shaft output power…

Q: A. Find the energy stored in the capacitor and inductor in Fig. 3 8 mA 10 nF 3kn 2 MA O 12 V Fig 3…

A:

Q: I have submit my tution work please help me i will give likes

A:

Q: What is the typical value of refractive index for an ethyl alcohol? a. 1 b. 1.36 c. 2.6 d. 3.4

A: The correct option along with the explanation is provided in the following section.

Q: Consider the following circuit diagram. If each battery is labeled 10 V, 3Ω, then what is the strong…

A: The required parameter can be calculated by using the Kirchhoff's voltage law to the circuit.

Q: The spectrum of the sampled signal may be obtained without overlapping only if a. fs ≥ 2fm b. fs fm…

A: Non - overlapping spectrum of the sampled signal

Q: In the circuit of figure Nº A, the secondary voltage Vs is 15 volts rms with a frequency of 60 Hz, R…

A: Given data: Frequency f=60 Hz Resistance R=100 Ω Capacitance C=1000 microfarads Secondary RMS…

Q: The above op-amp acts in a non ideal manner such that R₂ R₁ Av(CL) = 1 1+ Av(OL) 1+R²₁. Given Av(OL)…

A: Given: AVCL=-R2R11+1AVOL1+R2R1

Q: 18. If an AC waveform has a maximum voltage of 24 VAC, what is its peak-to-peak voltage measure? A.…

A: Given: An AC waveform has Maximum voltage, Vm=24 VAC

Q: 1. Two resistors, each of magnitude R1 = 100Ω and R2 = 200Ω If the two resistors are connected to a…

A:

Q: 2. Solve the over-all transfer function T(s) = C(s)/R(s). R(s) 7 15 X3(s) 15 X₂(s) -24 -26 -o X₁(s)…

A:

Q: A plane wave propagate through a lossless medium with = 3 and μ = 1, the magnitude of the magnetic…

A: Given, A plane wave propagate through a lossless medium with, Hz,t=4 cos 4×107t-βz Am εr=3μr=1

Q: 2. When the demand curve is P = -0.5Q+ 12, the Marginal Revenue curve is MR =>

A: Given- P=-5Q+25

Q: a) Simplify the following Boolean expressions using Boolean algebra Y = ABC (BD + CDE) + AC

A: Given, Boolean expression  Y=AB¯CBD+BDE+AC¯

Q: 9. Which of the following is correct about the power consumed by R₁ and R₂ connected in series if…

A: The solution is provided in the following section.

Q: + 100 Ω Μ 20 V3ia Τα t = 0 Χ 100 Ω 0.4 Η 0000 v(t) + - 25 mF

A:

Q: Q2. Consider an ideal low pass filter (LPF) with h[n] con со sin(@con), where cutoff frequency @co=…

A: Given,For a idel low pass filter,h[n] =sinωconπnWhere,ωco=0.5πandx[n]=cos0.25πn

Q: An electrical circuit must contain:       A)  a load, connecting wires, and a fuse   B)  a load,…

A: option b is correct Practical electric circuit requires a source to supply power to the circuit and…

Q: Determine the output voltage for the circuit in the figure for each input voltage waveform. Also,…

A:

Q: 2. Simplify the block diagram below. R(s) S²-45+4 S-2 S³ apples S+2 S²+45+4+ S²-4 C(s)

A: Given: Consider the following system: To find: Simplify the block diagram.

Q: 3. We have two voltages v₁(t) = 15 sin(400nt + 45°) V and v₂(t) = 5 cos(400nt - 30°) V. Determine…

A: NOTE :     As per our company guidelines we are supposed to answer only first three…

Q: Q5) For the pairs of sequences x(n) -2, 1, for n = 0, 1, 2 for n = 3,4 0 elsewhere, and h(n) = :{…

A: Given:- xn=-2,       for n=0,1,21,          for n=3,40,        elsewherehn=2,         for n=0-1,…

Q: A low pass filter is a. Passes the frequencies lower than the specified cut off frequency b. Rejects…

A: The correct option along with the explanation is provided in the following section.

Q: uestion 1 The output of 555 timer is given above. a) What is the mode settings. It is in b) From the…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: 7.2Ω THE 6V 8 Ω R₂ 12 Ω R3

A:

Q: The total current through the supply?

A: Given here a electrical circuit and asked to find the total current through the supply.   In the…

Q: Calculate the power factor of the entire circuit of Fig. 11.19 as seen by the source. What is the…

A:

Q: The cutoff frequency, in Hz, for a low pass filter with R = 105 kiloOhms, and C = 20 nanoFarads is…

A: Given: A low pass filter has R=105 kΩC=20 nF

Q: Calculate the average power absorbed by each of the five elements in the circuit of Fig. 11.6. 40/0°…

A: Given: Circuit diagram:

Q: 6. How many cycles will an AC signal make in 2 seconds if its frequency is 100 Hz?

A: The correct option along with the explanation is provided in the following section.

Q: Question 23 When calculating the voltage of an FFT peak of a sinusoidal signal, would it match the…

A: Frequency response represents how the output gain or phase responds for a single frequency over a…

Q: 1. Design a solar cell (4A, 50V) which will provide 1000 W. And how to minimize it (using diode) ?

A:

Q: What is the voltage across R1 in this

A: We know that  According to Kirchoffs voltage Law(KVL) The algebraic sum of voltage across each…

Q: Let us discuss the Eigenfunction property of LTI systems. Discuss when the eigenfunction property is…

A: In response to the given problem, we have to give     - description about eigenfunction property of…

Q: Twelve resistors form the edges of a cube as shown in the figure. If the potential difference…

A: Given circuit,

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.