Answered: A fluid is weighted in a laboratory. It…

A fluid is weighted in a laboratory. It is found that 6 LITERS of the fluid weight 37 N. What is the fluid density in kg/m3? Is it likely water or gasoline?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: If the system is released from rest, determine the speeds of both masses after B has moved 1.7 m.…

Q: A centrifugal pump developing 9 ft head at 1200 rpm is driven by a 3 hp motor. Impeller diameter is…

Q: Compute the normal acceleration when the boy reaches the bottom of the profile. (m/s^2)

Q: A square steel alloy plate 400 mm on a side has a 90-mm-diameter circular hole at its center. The…

Q: A container with an internal volume of 2.94 m³ is occupied by a ten kg steam at 0.88 MPa with an…

Q: Q2: Find the general solution for the following first order D.Es? a) y'2ry = 1 e) 2-y= e

Q: Determine the maximum acceleration that the 12 kg rear wheel drive go-cart can achieve (the front…

Q: Which statement is most accurate regarding the two materials represented in the given stress-strain…

Q: A piston-cylinder device contains 10.0 lb, of water initially at 225 psia and 25.59 ft. Now 4000 Btu…

A: Mass of water, m= 10 lbm Initial pressure, P1= 225 psia Initial volume, V1= 25.59 ft3 Heat input, Q=…

Q: 9. Determine the first two harmonics of the Fourier series for the periodic function with period 2n…

Q: A fluid is pumped at a rate of 0.00156 m/s through a 0.025-m-diameter pipe to fill.a water tank as…

A: Given Data The discharge is:Q=0.00156 m3/s The diameter of the pipe is:d=0.025 m The density of the…

Q: A block sits on a plane, and there is friction between the block and the plane. The plane is…

A: Graphical representation of forces may be applied externally, reactions ( normal force, tension,…

Q: A man launches his boat from point on a bank of a straight river, 3 km wide, and wants to reach…

Q: ohn’s automobile has a three-liter SI-V6 engine that operates on a four-stroke cycle at 3600 RPM.…

A: Given Dataτ=205N-mN=3600rpmC.R=9.5l=16.6cmηm=85%Vd=3L=0.003m3 ***As per our company policy we are…

Q: A Toyota V6 square gasoline engine operating at 3250 rpm has an indicated power of 123.2 kW. The…

Q: 4-A 50-kg copper block initially at 80°C is dropped into an insulated tank that contains 120 L of…

A: Given Data: Mass of copper, mc= 50 kg The volume of water, V=120 L

Q: A double-pipe heat exchanger (tubes are concentric with very thin walls) has a length of 5 m while…

Q: There are 1.5 kgm of gas for which R=0.377kJ/kg-K and k=1.3 that undergo an isometric process from…

Q: Q=2000J Vour =? m (kg/s) D=0.1m air Air at (5.25x10^2) K flows out of a circular pipe at 101325 Pa…

A: Calculate the inlet velocity. mi˙=ρAvimi˙=ρπ4di2vi0.0093=1.2π40.12vivi=0.9867 m/s

Q: Six years ago, an 80-kW diesel-electric set cost $160,000. The cost index for this class of…

Q: 4. If the maximum force that any member can support is 8 kN in tension and 6 kN in compression,…

Q: PROBLEM 1: A proton travels with a speed of 5.02 X 10^6 m/s at an angle of 60° with the direction of…

Q: A student built a contraption. The student has a 40 kg weight that they need to attach to one of the…

A: This question is based on the concept of kinetic acceleration

Q: P9-3 The composite shaft, consisting of aluminium, copper, and steel sections, is subjected to the…

A: GIVEN DATA- FOR ALUMINIUM A=58mm2 , E=70GPa FOR COPPER A=77mm2 , E=126GPa FOR ALUMINIUM A=39mm2 ,…

Q: 1. A piston-cylinder device contains 10.0 lbm of water initially at 225 psia and 25.59 ft. Now 4000…

Q: Required information Know that oall = 151 MPa and Tall = 100 MPa. | 275 kN B D. 275 kN 3.6 m 1.5 m…

Q: The drinking fountain is designed such that the nozzle is located from the edge of the basin as…

Q: Cyllndrical tanks are filled with a liquid as shown below. a) ( Calculate the time to completely…

Q: Water at 20∘C flows through the 20-mm-diameter galvanized iron pipe such that it discharges at C…

Q: 4. A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 m³. Find the glycerin's…

Q: Find the general solution for the following first order D.Es? b) x*dy + (y? - xy)dx 0 d) (x + xy -…

Q: A spur gear is available having a diametral pitch of 4 teeth/in, a 2 inch face, 20 teeth, and a…

A: Give data:The yield strength of the gear is given as Sy = 30 kpsiFor AISI 1020, the value of…

Q: Determine the magnitude of the pin force at A Assume W = 900 Ib, a = 5.8 ft, b = 3.9 ft, r = 9 in.

A: Consider the free body diagram for the bar CBA. Also,

Q: A hollow shaft carries a torque 3.4 kN-m at a shearing stress of 55 MPa. The outside diameter is…

A: Determine the inside diameter in mm.

Q: Two cars moving on the same direction have a velocity of 90 ft/sec. Car A is 100 feet behind car B.…

A: Given data the velocity of cars A and B are 90 ft/sec To determine required acceleration of…

Q: The adiabatic efficiencies of the compressor and turbine used in an air-standard Brayton cycle are…

Q: A thin triangular plate ABC forms a right angle at point A. During deformation, point A moves…

Q: this racing event was designed so that riders jump off the slope at 20°. During a race it was…

Q: A line shaft is to transmit 200 hp at 900 rpm. If the line shaft is connected to a 2” counter shaft…

A: Given Data: Diameter of the countershaft, d=2 inch

Q: 1. A piston-cylinder device contains 10.0 lbm of water initially at 225 psia and 25.59 ft. Now 4000…

Q: The velocity ratio (v1/v2) of an isentropic flow through a supersonic wind tunnel is 0.615. if the…

Q: Round everything to four decimal places. When an air conditioner is reversed it can operate as a…

Q: A 28mm diameter round steel bar is 0.4m long. It is placed concentrically within a bras tube which…

A: Given Data The diameter of steel bar is:dsteel=28 mm=0.028m The length of steel bar is:L=0.4 m The…

Q: Determine the change in length of the 20 mm diameter rod AD, subjected to the indicated forces (E =…

A: To find Change in length.

Q: אוKLZמוש 3. A square aluminum bar is to support a load of 40 kN on a length of 3 m. Assuming pinned…

A: Given Force, F = 40 kN Length, L = 3 m E = 70 GPa Find Length, b

Q: Q2 .. h, are 12m. The pump efficiency is 79%, and the pump is driven by an electric motor. A pump…

Q: A single-cylinder engine head experiences forces that range from 0 to 4000 lb each cycle. The piston…

Q: Water flows through a pipe at a velocity of 1 m/s. The pipe has a relative roughness of 0.001 and…

A: Given: V= 1m/sRelative roughness εd=0.001diameter d= 100 mmν=10-6 m2/s To find: Point 1 and 2

Q: 17- Two rigid tanks are connected by a valve. Tank A is insulated and contains 0.2 m3 of steam at…

Q: Current Attempt m ogress For what value M of the clockwise couple will the horizontal component A,…

Question

A fluid is weighted in a laboratory. It is found that 6
LITERS of the fluid weight 37 N. What is the fluid
density in kg/m3? Is it likely water or gasoline?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the oil is898 kg/m 3 ?
A Russian submarine crashs, loses control and runs aground at the bottom of the sea. The pressure,at atm, to which the submarine gets subject ed when it ran aground at a depth of 100 meters is?(For seawater take that density is worth 1000 kg/m³)
When we in the United States say a car’s tire is fi lled “to32 lb,” we mean that its internal pressure is 32 lbf/in 2 abovethe ambient atmosphere. If the tire is at sea level, has avolume of 3.0 ft 3 , and is at 75 ° F, estimate the total weightof air, in lbf, inside the tire.
The system in Fig. is open to 1 atm on the rightside. ( a ) If L = 120 cm, what is the air pressure in containerA ? ( b ) Conversely, if p A = 135 kPa, what is thelength L ?
A milkshake has fairly similar density to that of water (m s = 1200 kg/m3) but is far more viscous ( = 1kg/ms) (a) Say you try to drink a milkshake through a straw that is 30 cm long and 5 mm in diameter. Your lungs are capable of creating a vacuum pressure of 3000 Pa. (Vacuum pressure just means a pressure below that of the atmosphere, so plung = patm 3000 Pa.) You Önd that if you place the straw just at the surface of the liquid, you are unable to suck the milkshake through the straw, but if you push the straw deeper into the shake, you can. To what depth, d, would you need to push the straw in order to just start to sip the milkshake?(b) Suppose you push the straw to a depth of 10 cm and suck with a suction pressure of 3000 N/m2. What volume áow rate of milkshake can you produce through the straw
Find the unit weight of helium at a temperature of 5 °C and apressure of 174 kPa gage, if atmospheric pressure is 101.92 kPa.(R = 3042 J/kg* °K)
A hemispherical container, 26 inches in diameter, is filledwith a liquid at 20 ° C and weighed. The liquid weight isfound to be 1617 ounces. ( a ) What is the density of thefluid, in kg/m 3 ? ( b ) What fluid might this be? Assume standardgravity, g = 9.807 m/s 2 .
What is the Helmholtz absolute viscosity of water at 670°R? What is the weight in lbf of a liquid that has a mass of 30lbm on earth with g=32.174ft/s2? Weight in lbf if the g=29ft/s2?
In a fluid rotated as a solid about a vertical axis with angular velocity ω, the pressure rise p in a radial direction depends upon speed ω, radius r, and fluid density ρ. Obtain the form of equation for p=?
Q2: The function relates the different variables in a capillary rise of a liquid is given by: h = f (d, g, ?, ?, ∅) where; h= capillary rise, d= tube diameter, ? = mass density, ? = surface tension; ∅ = contact angle Find a non-dimensionless expression relates h with the other given variables by using Buckingham theorem
A solid ball is floating at a boundary between water and mercury, with 56 % of the ball volume in water. Ball diameter is 1.2 m, water density is 1000 kg/m3 and mercury density is 13560 kg/m3. What is the density of the ball? Round off the answer to an integer in kg/m3, but enter the answer without the unit.
The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?