Answered: a For the circuit shown above, what is…

a For the circuit shown above, what is the equivalent capacitance as seen by the a-b terminals .Assume all capacitors are 55 Farads Wai

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: Reler Vas SV figure; Ra www 5 kf O 0.7 V 9.2 V O 19.3 V O 9.9 V value of VCE IS. 470 Boc=25 +² Vec…

A: We need to find out collector to emitter voltage for given circuit.

Q: For a Fixed bias circuit having Rc-2.2KQ, RB-2400, Vcc=12v and current amplification factor is 100…

A: Brief description: For the given BJT we need to calculate the value of collector current in…

Q: PLEASE SHOW YOUR SOLUTION ON A PAPER The i1 is at the 6 ohms and the i2 is at the 8 ohms.

A: In this question , we will find current through 6 ohm and 8 ohm.....

Q: HW1. Find the transfer function H(s) = Figure 1. 192 120.5F 1Η 402 V(t) www lo (s) 1₁ (s) 292 www in…

A: We need to find out the transfer function .

Q: Apply KCL at node Vc(S) ve(s)-/+ vess+ 60)/2 = 1 vc(s)-¹% Vc(S) vc(s)-/s 5S 10 10 3 $5 S vc (S) 1₁ +…

A: All we need is manipulation Just replace the terms, we will get desired terms at both terms.

Q: Refer to the figure; if VCE = 0.2 V, Ic(sat) is: 10 V = 4.7 kn Ra www VINS 1.2 MO O 2.085 mA O 0.05…

A: For given circuit We need to find out saturation current .

Q: (no+23), = (abcdefg), ABCD F 0000 X 0001 a 0010 b 0011 с 0100 0101 0110 0111 1000 1001 g 1010 f 1011…

A: Given data, Number (n)=47 (n+23)10=(abcdefg)2

Q: (+1) i₁ 9 A 1₂ www

A: Solution- i1-i2 = 9 A....................112-V7+9 = V11V11-12-V7 = 97V-132+11V77=918V-132 =…

Q: A4 The circuit showed in Figure A4, is powered by an AC voltage source Vs. Sketch the phasor…

A: Here we discuss about the single phase AC RL parallel circuit.

Q: for square wave PWM inverter, Vdc=100V, L=25mH, R=1002, f-60Hz. draw the spectrum of the output…

A: Square wave inverter is convert the solar DC to AC power. it is a simple to design and high…

Q: for Phase shift PWM inverter, Vdc=100V, L=25mH, R=10ohm, f=60Hz. draw the spectrum of the output…

A: Given : Vdc = 100 V , L = 25 mH , R = 10 Ω , f = 60 Hz Fig shows output voltage &…

Q: Q3: The matrix differential equation of the state variable model of a system has 0 1 -1 A= -8-12 8…

A: Given that state matrix A of a state space model. To find characteristic equation of the transfer…

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: Given figure,

Q: 2. Determine the current flowing in R1, R2, Rg, R4, Rg and Vs. (if Voltage drop across R,=20 V).…

Q: V₁ = 2mV 0.05 με F 10 ΜΩ 330 Ω, +10 V 0.1 με Iass = 6 mA Vp = -3 V + 1.8 ΚΩ 100 με 24 ΚΩ ' 8.2 ΚΩ +…

A: FET refers to field effect transistor, it uses electrical energy to control the flow of current.

Q: Determine the load phase currents and phase voltages for the three-phase circuit in item #1 when the…

A: load phase current and phase voltage is caluclated as

Q: A current source of i(t)= 10sin(377t +30-) A is applied to a single-element load. The resulting…

A: We need to find out element for given current and voltage are

Q: One side of a transformer has 1,800 turns while the other side has 450 turns. The high voltage side…

Q: An unbalanced delta-connected load is supplied from a 400-V, 3-ph, delta-connected alternator…

A: Delta connection is a mesh type connection made to the electrical apparatus and the three phase…

Q: For the following sequence {1.2, -0.2, -0.5, 0.4, 0.89, 1.3…}, Quantize it using a uniform…

A: The quantization is the process of dividing a signal into equi-spaced sections. These sections are…

Q: I'm feeling O run up O run across O run into O run run over and could do with a holiday.

A: Given sentence is I am feeling ................and could do with a holiday.

Q: Consider the following circuit, supplied by a 10VRMS voltage source with a 0° phase shift (i.e.…

A: Consider the following circuit, supplied by a 10VRMS voltage source with a 0° phase shift (i.e.…

Q: Q1. Find the Doppler shift of a Pulse-Doppler radar with a PRF of 2KHz, and operating at 2 GHz. a.…

A: a. The relationship between the PRF and the maximum range is given by the expression as shown below:…

Q: 1.The secondary line to line voltage of a star-delta connected transformer is measured to be400 V.…

A: Given line to line voltage at secondary is 400 V The turn ratio is 2:1

Q: Question 21 Solve for the sinusoidal voltage and currents, v(t) and i(t), on the given circuit. v(t)…

Q: ) List with drawings of the special purpose oscilloscope types, and then list of the differences…

A: Following are the special purpose oscilloscopes. Dual Beam Oscilloscope Dual Trace Oscilloscope…

Q: A circuit element has an impedance of 28 Z-55⁰ m2 when the frequency is 255 Hz. What is the…

Q: Find the total impedance, total current drawn by the system, total power (apparent) delivered by the…

Q: 4) In the figure below, C1 and C2 are very large. Determine the following (a) Quiescent collector…

A: Brief description: For the above given common emitter PNP transistor circuit we need to calculate…

Q: A. Find the following requirements in plotting the root locus. number of branches number of…

Q: EXAMPLE 7 Using the the 42 resistor in Fig. 1( I = 6A / 00 ( توصیه هوا

Q: 15.39 Find the loop gain functions T(s) and T(jw), the frequency of oscillation, and the R₂/R₁…

Q: (t) for tt = 0 10 A 4 Ω the circuit is in steady state t=0 10 mF m 60 www 4H

Q: The two switches in the circuit seen in (Figure 1)operate synchronously. When switch 1 is in…

A: The given circuit is as shown below,

Q: Ⓒ Find the transfer function of digital filter shown k(1) x(n). (E) (3) y(n) Z Y₂ z

A: Brief description: For the above given direct form 1 implementation we need to derive its transfer…

Q: In a balance three-phase system, the source has an abc-phase sequence and is connected in delta. The…

A: Current: It is the time rate of the change of the charges. It flows from high voltage to low voltage…

Q: What is the total impedance of circuit? 240 Ω j95 Ω Α) 227.852 – 18.31° Ω C) 419<0° Ω 784 Ω Β)…

A: In this question we need to find a total impedance of the given circuit.

Q: A uniform line charge of 16 nC/m is located along the line defined by y = -2, z = 5. (a) Find E at…

A: In uniform line charges, charges are uniform along the line axis, they are placed parallel and equal…

Q: A balanced delta-connected load with impedance per phase of 30/30° 2 is connected to an abc-sequence…

A: According to given question ,Given :

Q: Load 1: 200 W, unity power factor Load 2: 1200 W at 0.85 power factor lagging Load 3: 400 W + J100…

Q: Tutorial Problems 1. Derive the Thevenin's hence determine the curr resistor.

Q: Suppose you have a three-phase delta-wye system, which has a line voltage at the 200 Vac source,…

A: Power factor is cosϕ where ϕ is angle between phase voltage and phase current

Q: C- Put TRUE or FALSE for only TWO of the following and say why: ! 1. PCM modulation is very complex…

Q: Q.5 A unity feedback system has G(s) = Find a) Types of the system b) Error constant Kp, K, and Ka…

Q: Four point charges each of 10 μC are placed in free space at the points (1, 0, 0), (−1, 0, 0), (0,…

A: Given 4 point charges each of 10 μC are placed in free space at the points (1, 0, 0), (−1, 0, 0),…

Q: please solve parts d, e and f d in the picture e) The value of K when the root loci intersect…

A: RH criteria help to find the stability of closed loop system with the help of OLTF gain It gives a…

Q: Instructions: Solve the following circuit problems and show your solution. 1. Determine the values…

Q: Given the circuit below and the input voltage is 120 V, 20 Ω 40 Ω 30 Ω Μ www V j10 Ω j30 Ω 98-100)…

Q: Q4.) A CRT has deflecting plats of 2cm longs, and 5mm a part. The screen is 500mm away from the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. A balanced delta-connected lood with impedance per phase of 30<30 ohms is connected to an…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

a
?For the circuit shown above, what is the equivalent capacitance as seen by the a-b terminals
.Assume all capacitors are 55 Farads
.Write your answer in Farads

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Two capacitors A and B having capacitance of 20uF and 30uF respectively are connected in series to a 600v supply. Determine the p.d across each other. If a third capacitor C is connected in parallel with A and it is found that p.d across B is 400v, calculate the capacitance of C and energy stored in it
Two capacitors C1 and C2 are marked ‘200 pF, 500 V’ and ‘300 pF, 900 V’, respectively. If they are connected in series, find the equivalent capacitance. If parallel connection, find the equivalent capacitance again.
Find the equivalent capacitance (μF) seen at the terminals of the circuit below.
3. Solve for the equivalent capacitance and voltage drop across 4.5μF of the circuit below
2. Suppose you want a capacitor bank with a total capacitance of 0.750 F and you possess numerous 1.50 mF capacitors. What is the smallest number you could hook together to achieve your goal, and how would you connect them?
2. Solve for the equivalent capacitance and total charge for the circuit below.
Two capacitors of 200 and 800 nF, respectively are connected in parallel. The combination is then connected in series with another two capacitors of C and 600 nF connected in parallel. If the total capacitance of the set-up is 500 nF, determine the capacitance C.
You are given 10 resistors that are each 30 Ω. Construct a circuit with a resistance of exactly85 Ω. don't use all 15 resistors.a.) Explain process in designing the circuit.b.) Draw a diagram of the circuit,c.) Show that the total resistance for the circuit is 85Ω.d.) Suppose capacitors was given instead. Draw a circuit using 15 or fewer30 μ F capacitors, so that the circuit has a total capacitance of 85μF. Briefly explain the process.e.)Show that the total capacitance is 85μF.
1. In a circuit with a 9V battery and a 25mA lamp, what value resistor should you choose? 2. What is the total capacitance of a two capacitor with a value 2200uf connected in series? 3. What is the total capacitance of a two capacitor with a value 2200uf connected parallel?
Find the equivalent capacitance seen in the terminals of the circuit of the figure