A force P= 46 N is applied to the claw hammer shown. What force Q is exerted on the nail? -P- 284 mm 1 58 mm PROB. 6.43 Q

Q: Problem 1: The circuit shown in the figure is in a dark room. When the bright light is turned on,…

A: SCR (Silicon controlled rectifier ) or Thyristor is a semi-controlled power switch in which its on…

Q: 2. Determine the current in the 2 ohm resistance by Thevenin's and Norton's Theorems.

A: The required current can be calculated by using the thevenin's and norton's equivalent and the same…

Q: Consider the following two discrete-time systems: (a) y(n) = x(n) + nx(n+1) (b) y(n) = -nx(-n) Fo…

A: As per Bartleby guidelines we need to answer the first question only. Kindly repost the question (b)…

Q: 외 Calculate the energy considered in the signs fuse uit in both time domain and Frequency domain

A:

Q: 02. Determine the back e.m.f. when giving an output of 7.46 kW at 85 percent efficiency. S

A:

Q: Calculate the voltage output by the secondary winding of a transformer if the primary voltage is 230…

A: We need to find out the secondary Voltage for given transformer .

Q: Given the closed-loop system in the figure with C(s) = K and G(s) = (s+2)(s+5) interval of the…

A: The closed loop system is shown below, Where,Cs=KGs=1s+2s+5

Q: What is the angle at which the thyristor operates as a diode in a unified half-wave three-phas…

A:

Q: The frequency (in Hz) of the power wave associated with an electromagnetic wave having an E field as…

A: Given- Electric field- E=e-zδcosωt-zδ, To Find- The frequency of the power wave.

Q: 1. DA = y + XA DB= DB+ XX 7=6B

A: Given, State equations are  DA = X'Y + XA DB = X'B + XA Z = X.B We need to draw the state diagram.

Q: Exampleu Find F[et sin(wot) u(t)]

A:

Q: 1. A 14 V battery pushes a current of 0.51 A through a resistor, how much power does it consume?

A: Given data:- Battery voltage = 14 V current through battery  =0.51A Find:- Power=?

Q: 1) Write brief notes on Full Adder.

A:

Q: find the exponential Fourier series, then sketch E(v)- 1. V 0.01 0-02 0.03 t

A:

Q: For Equal Rise time and Fall time the size of PMOS transistor 'B' in the following circuit should…

A: Here sizing can be done with reference to the CMOS inverter. In general, The size of CMOS inverter…

Q: (MCQ): The Pull down network in CMOS logic is made up of:       a.  PMOS Transistor with grounded…

A: Given The Pull down network in CMOS logic is made up of:       a. PMOS Transistor with grounded gate…

Q: Ex calculate the energy considered in the signal f(t) = at ult in both time domain and e Frecency…

A:

Q: Vin o Vcc T RB Co www iB Vcc T RL + UBE ic Q₁ RE i E ο UOUT

A:

Q: What is the maximum period for which a thyristor can operate in a unified three-phase controller?

A:

Q: Hello there. To start off, I AM BLIND AND CAN NOT READ IMAGES YOU MAY ATTEMPT TO RESPOND WITH.…

A:

Q: Q2: A 7.2 Zener is used in circuit below, and the load current is to vary from 12-100 mA find the…

A: Given: The zener voltage is 7.2 V The constant input voltage is 12 V. The minimum value of current…

Q: Find the magnitude and phase angle of the following transfer function.

A: Find the magnitude and phase angle of the following transfer function. Gs=15s+3s+2s2s-1s2+2s+8 put…

Q: 1. The characteristics of a BJT are shown below. What is ß for the transistor? Consider the circuit…

A:

Q: (d) If x(n) in part (c) is passed through an ideal D/A converter, what is the reconstructed signal…

A:

Q: Please describe what SR, JK, D,T flip-flops are.

A: To describe: SR, JK, D and T flip-flops.

Q: The auto-correlation function a(t) associated with the signal x(t) is given as y(t) x(t) * x*(-t). -…

A: Given, Auto correlation of signal x(t) is y(t). i.e y(t) = x(t) * x*(-t) We need to determine the…

Q: Define Root Locus for dynamic control systems. Write the complete process with all steps to…

A: A root locus is a graphical approach where the roots of the Characteristic equation (1+G(s) H(s)=0)…

Q: Find :- Vrms Udt lov 4K442 Si Vers lov प्रै र 2 K

A:

Q: Find the magnitude and phase angle of the following transfer function.

A: It is given that: Gs=5s+1s+4ss+0.1s+3,

Q: 2. In the circuit below, assume R1=R2 = 1k0 and Rg = Rf = 10kQ Vcc= -VEE = 20V Vo a. Find the…

A:

Q: Write the process and steps to design lead and leg compensator for steady state analysis of dynamic…

A: Type of control system Closed-loop control system  The more accurate response even in the case on…

Q: Problem 9. An alternating voltage is given by v=282.8 sin 314t volts. Find (a) the rms voltage, (b)…

A: Alternating voltage v = 282.8 sin314t volts

Q: 1. Solve the total or equivalent resistance: Rea Μ 4Ω 8 Ω Μ 6Ω Μ 1Ω 2 Ω 3 Ω 5 Ω

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Given a Silicon PUT used in a relaxation oscillator with the following parameters: VBB-10 V. R-18k,…

A:

Q: A permanent magnet DC motor has the Torque-Speed characteristics shown in the above figure for a…

A: Given information about a permanent magnet DC motor is Ts=175 N. R=1400 Ω. ke=13 V/(rad/sec). kt=190…

Q: Problem 2 For the periodic signal given below, calculate the following by using Fourier series…

A:

Q: 4a) Calculate the inductive reactance X₁ for the circuit in Figure 4 with L = 100 mH, assuming f =…

A:

Q: Use the Laplace Domain approach to find the system response u(t) = 3e^-t and x(0) [1 -2].

A: Q

Q: ideal Opamp the input resistance

A: For an ideal Op-amp the input resistance is considered: high infinity low zero Answer: input…

Q: The circuit in Figure 18-2 is modified by changing R2 to 560 ohms. Both switches are closed. 1.…

A: The voltage across the parallel circuit remains the same and the current will be different. current…

Q: Problem 11 4.26. (a) Compute the convolution of each of the following pairs of signals x(t) and h(t)…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: 7.76 The current source in the network in Fig. P7.76a is defined in Fig. P7.76b. The initial voltage…

A: The circuit can be analysed by considering the state of the circuit at t<0, t between 0 to 4.5…

Q: A thyristor string is formed in series and parallel connections. The thyristors used have voltage…

A: Given- A thyristor string- Voltage  rating=2 KV, Current rating=1.5 kA String ratings 10 KV & 6…

Q: A circuit with an impedance of Z = 3 + j4 ohms and an applied phasor voltage v = 100 cis(30 deg),…

A:

Q: Problem 9. An alternating voltage is given by 282.8 sin 314t volts. Find (a) the rms voltage, b) the…

A:

Q: In theory, the circuit has a resistance value assigned ONLY to the resistors. In  reality, however,…

A: There are three passive elements in the circuits, namely resistor, inductor and capacitor.

Q: 2) G(s) = 10 (s+0.5) (s+2)² S³ (s+3)(s+5)

A: Given We need to find the magnitude and phase of the given transfer function.

Q: 5 3 y(n) = y(n − 1) + y(n − 2) + x(n) (a) Determine the total response y(n), n ≥ 0 when the input…

A:

Q: 3Ω + Vx 4Α t=0 18 Ω For the circuit, Determine the value of VouT(t) for t > 0. 12 Ω 0.5.Vx + + VOUT…

A:

Q: QUESTION 4 If the maximum energy stom 270 0210 850

A: Given data, Energy E= 3 mJ. Circuit diagram is given as

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.