A PMMC instrument has internal resistance of 0.8 kΩ and gives full scale deflection for 33 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 75 V will be __________________ ohms

A PMMC instrument has internal resistance of 0.8 kΩ and gives full scale deflection for 33 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 75 V will be __________________ ohms

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2P: The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where...

See similar textbooks

Related questions

Q: Using the diagram below and the component photos from page 4, draw the realistic experimental setup…

A: Measuring an unknown resistance using a galvanometer or a Wheatstone bridge is a very popular…

Q: Explain the working principle and operation of any one types of solar collectors.

Q: Current is the flow of charges in a directed path. When we connect your mobile phone charger to the…

A: A mobile has a battery of small and finite voltage. The charge stored by the battery is like 10000…

Q: Kindly put the given and solution. Given: VS1: -1 volts VS2: 24 volts B=beta: 150 RE: 330 ohms RC:…

A: We will apply KVL in base emitter loop to find emitter current and than collector current. Now we…

Q: In household wiring, usually 12-gauge copper wire (diameter 12 mm) is used. A light bulb is…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 13. At what amperage differences will a GFCI trip? 14. What do DC and AC stand for? 15. True or…

A: (13) GFCI detects the differential current between hot and neutral wire conductor if differential…

Q: Q2: Does ‘a three digit color coding of resistor values’ limit producible resistor value ranges?…

A: Yes color coding of resistor values limit the resistor value range. In color coding of three digit…

Q: A) What is an emf of self-induction? a) when there is an induced emf in a circuit due to a change of…

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: A PMMC instrument has internal resistance of 0.51 kN and gives full scale deflection for 41 mA. The…

A: The solution can be achieved as follows.

Q: We measure and record the instantaneous voltage between the two wires of a power transmission line…

A: When the length of the transmission line is less than 80 km, the transmission line act as the…

Q: Describe how electrical engineering and electrical engineering technology differ and are the same…

A: Aim - To describe how electrical engineering and electrical engineering technology differ and are…

Q: A STRAIN GAUGE IS HAVING ORIGINAL RESISTANCE OF 300 OHMS AND GAUGE FACTOR TO BE IF THE VARIATION OF…

Q: 3.0 V across the cable, and a current of 50 A in the circuit. Draw the circuit diagram, representing…

A: Given: Battery emf, E=12 V Terminal voltage of battery, V=11.4 V Circuit current, I=50 A Voltage…

Q: Consider an electronic device that monitors the temperature of exhaled air by a patient. The circuit…

Q: What is the differences between real circuits and the simulated ones, please elaborate.

A: Simulation is define as the mathematical model or representation of a device which gives a very…

Q: What is the (Methods) to calculate the value of resistance?? and how we can using the multimeter…

Q: A potcntiometer with a uniform resistance per unit length of track is to ,I have a track length of…

A: Given, Track length = 100 mm Measuring instrument resistance = 10 kohm The maximum error is not to…

Q: Suppose we include the lead resistance in the calculation of temperature for a class A RTD. If R3 =…

A: RTDs are thermometers consist metals of which it resistance increase with temperature.

Q: A PMMC instrument has internal resistance of 0.66 k2 and gives full scale deflection for 30 mA. The…

Q: 6. BJT is more linear than FET. Why? Explain 7. what is vas (off)? How could it effects the…

A: In this question we will write how BJT is more linear than FET... Note :- as per our guideline , I…

Q: 4. A tank is initially filled with 300 gallon of salt solution containing 1 kg of salt per gallon. A…

Q: Explain the relationships between PV cells, modules, panels, and arrays.

A: According to the question, Explain the relationships between PV cells, modules, panels, and arrays.

Q: Q/ Give an example with real application about the interface between computer and electrical devices…

A: Interface It means that the interaction and connection of information transfer between the computer…

Q: In what situation we cannot select both current and voltage references randomly? Why?

Q: y=A/B+/c

A: The given logic expression is Y=AB¯+C¯

Q: Write the features of Air circuit breaker and mention its application.

A: Circuit Breaker: It is an electrical switch that operates automatically. It protects an electrical…

Q: With reference to energy conversion process, write the difference between Solar Power Tower system…

Q: For the circuit below, (Assume B = 90) %3D PART A) Determine the value of VR that results in VCE =…

Q: Country Area (km²) Daily sun hours Energy consumption (MWh/year) United States 9 826 675 4.0 3 886…

A: A photovoltaic system, also PV system or solar power system, is an electric power system designed to…

Q: Inspect one electrical component made by polymer-based materials, such as light switches, and…

A: There are many fields in which polymer-based materials are used in electrical components. Some of…

Q: Q5 / The resistance of a platirum thermometer wire measured at 50C°, 200C° and 500C° is 14,20322 ,…

Q: Consider the circuits A and B from the experimental details. If you were to put a lightbulb in the…

Q: Problem 3: A factory manufactures a specific copper part. It is found at a certain temperature the…

Q: Discuss the principles that underpin the design and installation requirements of lighting…

A: To get the best overall result from a lighting installation, avoid the temptation to jump right into…

Q: Write the application of extra high tension that have rating 66KV and what used for?

A: On the basis of voltage ratings , the underground cables are classified into five parts out of which…

Q: , explain the FET types , working principles, structure and applications.

A: There are three terminals present in FET such as drain, source, and gate. FET stands for the…

Q: The student engineer of a campus radio station wishes to verify the effectiveness of the lightning…

A: Given data: The unknown resistance between point C and E is: Rx. The unknown resistance between…

Q: EXPLAIN THE CIRCUIT AND IT'S APPLICATION IN ESSAY FORM

A: In this question, We need to explain the circuit and its application.

Q: The terms "open-circuit", “short circuit" and “dead short" are used in speaking electricity. Answer…

A: 1 a). The value of the resistance of an open circuit is very high resistance ( nearly infinity). b).…

Q: Complete the following statement about multimeters using the following words. Words: Accuracy,…

A: Complete statement is given below, A digital multimeter (DMM) can measure many more things than…

Q: NOTE 1: Watch your signs for NMOS and PMOS current conventions! NOTE 2: Assume all NMOS and PMOS are…

A: The given circuit is as shown below,

Q: Explain in sentence what is meant by effective current and effective voltage.

A: Effective Current The value of an alternating or otherwise variable current in a circuit that…

Q: What causes the normal heating in electronic devices? Not things that cause an anormal disfunction…

A: Normal heating in electronic devices is caused by various reason. One reason is leakage current. Due…

Q: Why PMMC Voltmeters can not be used to measure higher voltages directly? a. because the size of the…

Q: 1) what is the potential transformer used for in power substation? 2) what is process leads to…

A: 1) A potential transformer is a voltage step down transformer whose main function is to step down…

Q: 1. Write the answer for the following questions. a) Define Potential Gradient

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A string of 8 suspension insulators is to be fitted with a grading ring. If the pin to earth capacitances are all equal to C, find the values of line to pin capacitances that would give a uniform voltage distribution over the string.
What is the size in square milimeter (mm2) is the cable of 250 MCM size? Calculate the temperature coefficient of resistance of aluminum at 300C and uses it to find the resistance of an aluminum wire at 700C if the wire has a resistance of 40 Ω at 300
In a design task, a wire of 2000 m requires to exhibit a voltage drop of 2.5 Vwhen 3.2 A of current passes though it. Based on the Table Q1 (b) below, inyour opinion, which of the wire is the most suitable for aviation when the fuelsaving is another factor to be considered as well.
. a) Calculate and plot the current flowing through the pn junctions of device #2 on your 3311 wafer as a function of voltage over the range of -3 volts to plus 1.5 (or so) volts on a linear scale. b) plot the I-V curve for the forward voltage on a log scale. c) What voltages correspond to 10 A/cm2, 100 A/cm2, 1000 A/cm2, 10,000 A/cm2 and 100,000 A/cm2? d) What is the current and current density when the applied voltage is equal to the built-in voltage? e) what are your thoughts on applying a voltage greater than the built-in voltage to a pn junction diode?
A Victoria plaza sub-station supplies 60kW to a load over 250 ft, 100mm2 , two conductors copper feeder, the resistance of which is 0.078 ohm per 100 ft. The bus bar voltage is maintained constant at 600V.Determine the load current
1. What is meant by difference in potential? Show that it is possible for two or more emf's to exist within a circuit without there being any difference of potential between the circuit terminals. 2. If the assumed direction of a current in a network is in error, how is this fact indicated in the result?
Consider a gravity-driven LED bulb that provides 16 lumens of lighting. The device uses a 10-kg sandbag that is raised by human power to a 2-m height. For continuous lighting, the bag needs to be raised every 20 minutes. Using an efficacy of 150 lumens per watt for the LED bulb, determine (a) the velocity of the sandbag as it descends and (b) the overall efficiency of the device.
If a cell has an E.M.F of E volts, an internal resistance of r ohms and supplies A current I ampere to a load, the terminal p.d. V volts is given by....
Answer the following questions in five sentences. 1. Give nanotechnology products. Identify 5 examples and choose one that is the moat fascinating. 2. What are the alternative definitions of nanotechnology and environment. How could these differences in definitions change the conversation or perception about the interaction of nanotechnology and the environment? 3. What can be done to reduce uncertainty in developing new nanotechnology products? What are some of the ethical implications that should be considered?
An aluminum wire replaces a copper wire with the same value of resistance. If the crosssectional area of the copper wire is 500 CM, find the cross sectional area of the aluminumwire in SM.
A) What is an emf of self-induction? a) when there is an induced emf in a circuit due to a change of current in the circuit itself b) when there is an induced emf in a circuit due to a change of current in an adjacent circuit (one within magnetic reach) B) Under what conditions of current flow is a self-induced ernf produced? a) whenever the circuit is energized b) whenever the circuit is de-energized c) whenever the amount of current flow in the circuit varies d) all of the above C) What is the direction of a self-induced emf in relation to any change in current? a) the same direction as the current flow that caused it b) the opposite direction as the current flow that caused it c) may be either "a" or "b" d) neither "a" nor "b" D). In an inductive circuit, does the inductance have any effect on the flow of a steady current? a) yes b) no
Write the application of extra high tension that have rating 66KV and what used for?