A Galvanometer has an intermal resistance of 120 ohm with a maximum allowed current of 250 LA. Ifyou want to modify the G into an ammeter with a full scale deflection of 50 mA, what is the value of theshunt resistor?a. 0.603 2b. 24000 2c. 23880 2d. 0.420 2Draw the circuit of a modified ammeter below.

The expression to calculate shunt resistance is S=IgGI-Ig

À Galvanometer has an internal resistance of 120 ohm with a maximum allowed current of 250 µA. If ou want to modify the G into an ammeter with a full scałe deflection of 50 mA, what is the value of the hunt resistor? a. 0.603 2 b. 24000 2 c. 23880 2 d. 0.420 2

À Galvanometer has an internal resistance of 120 ohm with a maximum allowed current of 250 µA. If ou want to modify the G into an ammeter with a full scałe deflection of 50 mA, what is the value of the hunt resistor? a. 0.603 2 b. 24000 2 c. 23880 2 d. 0.420 2

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 66PE: Integrated Concepts (a) An aluminum power transmission line has a resistance of 0.0580/km. What is...

See similar textbooks

Similar questions

The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
Integrated Concepts (a) An immersion heater utilizing 120 V can raise the temperature of a 1.00 102 -g aluminum cup containing 350 g of water from 20.0°C to 95.0°C in 2.00 min. Find its resistance, assuming it is constant during the process. (b) A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A solid metal cylinder has a certain resistance. It is then heated and carefully stretched to form a longer, thinner cylinder. After it cools, will its resistance be the same as, greater than, or less than what it was before? Explain our choice.
. The generator at a large power plant has an output of 1,000,000 kW at 24,000 V. (a) If it were a DC generator, what would he the current in it? (b) What is its energy output each day—in joules and in kilowatt—hours? (c) If this energy is sold at a price of 10 cents per kilowatt-hour, how much revenue does the power plant generate each day?
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
(a) Haw much power is dissipated in a short circuit of 240-V AC through a resistance of 0.250 ? (b) What current flows?
Integrated Concepts (a) An aluminum power transmission line has a resistance of 0.0580/km. What is its mass per kilometer? (b) What is the mass per kilometer of a copper line having the same resistance? A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.
The hot resistance of a flashlight bulb is 2.30 , and it is run by a 1.58-V alkaline cell having a 0.100-O internal resistance. (a) What current flows? (b) Calculate the power supplied to the bulb using I2Rbulh? (c). power the same as calculated using V2Rbulb?
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
A multi loop circuit has four resistors, all of 2.5 MΩ, and two 12 V batteries asshown. What are the currents thru the resistors in this circuit? Explicitly statetheir directions.
0.73 amps flow thru a 15 Ω resistor. How muxh voltage does the resistor use ? How much power is used?