A given load takes 40 kVA at 50 % lagging power factor while another load connected in parallel across the same source takes 80 kVA at 86.7% lagging power factor. Find the apparent power

Q: Q8-Review the car-caravan example in Section 1.6. Again assume a propagation speed of 100 km/hour. S...

A: The propagation and reflection of plane waves, such as pressure waves (P-waves) and shear waves (SH ...

Q: 10 Ω 24 2 50 Ω ww 25 2 15 V 20 Ω 30 2 60 Q 20 Q ww ww

A:

Q: Vc Given: vCC = + 15.00 v RC VBB = + 5.00 V VBE = 0.72 V RB VBB VB = 1.20 V RC = 3.20 kOhm RE BDc = ...

A: Brief description : In the given question they have mentioned a bipolar junction transistor common e...

Q: How many turns is required for a coil with a diameter of 48 mm to induce 12 v of electricity when th...

A: Here, we have given a coil with a diameter as described above in the problem. we have to calculate t...

Q: IR R 220 2 Vz = 20 V IZM = 60 mA RL21.2 k2 V,

A: The minimum value of the Vi will be corresponding to the minimum voltage required to turn ON the Zen...

Q: Consider a continuous-time LTI system with impulse response

A:

Q: CO sensitivily in KIt. 7-26 A VCO has an unmodulated carrier frequency of 100 MHz and sensitivity of...

A:

Q: Find the vector component of G = 0.1a, +0.2a, +0.3a, that is perpendicular to F = 10a, - bay + 5a, b...

A:

Q: 3Ω 42 40V I3 450 64V 22 1.50

A:

Q: draw the cmos diagram for the following equation ((A +B)’+C)’ * (D’ E’ +F

A:

Q: 40/60° V V1 4Ω 30/0° V j4 2 j1 N 2Ω Calculate V1 and V2 in the circuit shown.

A: This question belongs to circuit theory . It is based on the concept of nodal analysis in the circui...

Q: Five dry cells having emfs of 2.30, 2.40, 2.35, 2.60, 2.25 Volts and resistances of 0.40, 0.20, 0.35...

A: It is given that: E.M.F of five dry cells: 2.30 V, 2.40 V, 2.35 V, 2.60 V, 2.25 V. Resistances of fi...

Q: -10-22 eV Conduction band Band gap Ey blence band "Bands" are composed of closely spaced orbitals a ...

A:

Q: 5ix 15 kQ 20 kQ + vị- 8 mA 10 kQ (+- 60 V

A: By applying KCL we get the required solution. Kirchoff current law states that sum of incoming curre...

Q: OCTAVE: Perform the following: c = a + b, d = a + b; What does semicolon do? Note: a and b in define...

A: Given, c= a + b, d = a + b;

Q: Write solutions neatly so I can understand. Thankyou very much! guaranteed thumbs up !!!!

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: Determine the limits of region of operations of M1

A:

Q: Five devices are connected as shown in Figure 1. The current i+(t) and voltage vs(t) are plotted in ...

A: Five devices are connected as shown below: The current i1(t) and voltage v3(t) are plotted in the f...

Q: Explain Transducer classification adding EXAMPLE to each category.

A: Transducer - A transducer is a machine that, when activated, converts one form of energy to another....

Q: The voltage applied in DC circuit having a power of 26 watts and a total resistance of 4 ohms is?

A:

Q: Consider closed loop transfer function is, C(s) s+1 R(s) s² +(3+K)s+K Calculate the value of K such ...

A: Closed loop transfer function is given, Ts=s+1s2+3+ks+k The open loop transfer function is given by ...

Q: Jury' method.

A:

Q: Q3 Given z,=(3+j4)² and z,= 2.5jej40x a. Find z¡+Z2 b. Find the magnitude and phase of z,z2

A: Given Z1=(3+j4)2 Z2=2.5ej40π

Q: Use Thevinins Theorem to find the current flow through the load resistor

A: This question belongs to circuit theory . It is based on the concept of Thevenin's theorem . Theveni...

Q: 7-18 A baschand signal having components from near de to 8 kHz is used to frequency modulate a high-...

A:

Q: ib and ve

A: The given circuit is shown below: VCC=16 VVEE=6 VVBE=0.71 VVC=5.97 VRB=125 ΩRC=3.2 kΩRE=1.7kΩ

Q: The following system of equations was generated by applying the mesh current law to the circuit in t...

A:

Q: Problem 26: Use mesh analysis to find the current through the resistor. R5 3 0 R3 R2. 10 Ω Ri 4 0 R6...

A: Using mesh analysis to calculate current in each loop concept

Q: Determine I1 and Vo for the parallel diode circuit in below figure. 0.33 k2 E - 10 V D Si D Si 5.

A:

Q: . A conductor whose diameter is 0.175 inches has a resistance of 0.5 ohms. The wire is drawn through...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 41. Two ac sources feed a common variable resistive load as shown in figure. Under the maximum power...

A:

Q: 1. Identify the different symbols seen in the schematic diagram. Write it in a piece of paper and ca...

A: The given circuit is as shown below, We need to identify the symbols in the circuit and make a bloc...

Q: 60 V 10 N 20 N ww 16 N

A:

Q: A capacitor consists of two parallel plates in air with a distance of 0.8cm between them. The area o...

A:

Q: Problem 10.  Given a piece of Si doped with B to a level of 1015 atoms/cm3,  (a) what carrier moves ...

A:

Q: Two pipes, A and B, contain a fluid flowing under pressure and are connected by a differential gage ...

A:

Q: An aluminum wire 7.5 m long is connected in parallel with a copper wire 6 m long. When a current of ...

A: It is Given that: Length of alminium wire LA=7.5mLength of copper wire LC=6mTotal current=5ACurrent ...

Q: LVDT has the following

A:

Q: Problem 1 What elevation or height of a column of mercury will cause a pressure of 667.08 kPag?

A: Given, Gauge pressure (Pg) = 667.08kPag i.e kilo Pascal gauge  

Q: 4. Solve for the zero-input, zero-state responses, and the total response of the system shown below....

A: Given: Inital conditions, y-t=1y-2=1 and  xn=3un To find: Zero-input, zero-state response  

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for...

A:

Q: 6/0° A -j2 N 6Ω j4 2 30/30° V 8Ω Find I, in Fig. using mesh analysis. Answer: 3.582/65.45° A. (+1)

A: Here, we have an electrical network having resistor, capacitor and inductor.  So, we will first assu...

Q: 100 V 10Ω 5 V 560 N 8 V (a) (b)

A: Silicon diode have forward voltage drop is 0.7V.

Q: *25. For the network of Fig. 12.80, the switch is closed at t = 0 s. a. Determine v1 at t = 25 ms. b...

A:

Q: 7-11 A90-MHz carrier is to be frequency modulaled by a 2-kHz tone. The maximum frequency deviation i...

A: Brief description : Modulation technique is one of the major advantage which is exist in the communi...

Q: Find the value of current Imax or the Total current Si Si 4.7 k2 68 k2

A: Given circuit diagram

Q: equivalent electronic circuits of: - AND GATE - OR GATE - NOR GATE - XOR GATE - XNOR GATE -NOT...

A:

Q: station is delivering its full output. 3. A 65,000 kW steam power station uses coal of calorific val...

A: 3) Given data : Power, P= 65,000 kWLoad Factor = 40% = 0.4

Q: Find the number of electrons that must be added to a spherical conductor of radius 10cm to produce ...

A: I am attaching detailed solution image of this question.

Q: Draw the CMOS diagram for the following equation: ((A B)' + C) ' * (D' E' + F)'

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.