A given load takes 40 kVA at 50% lagging power factor, while another load is connected in parallel across the same source takes 80kVA at 86.7% lagging power factor. Find the apparent power

Q: Q3/ The main shortcoming of Permanent magnet DC motor is Cheap cost limited speed regularisation…

A:

Q: A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing…

A: In this question,   We need to Find the emf induced in each phase winding and the terminal voltage?…

Q: Consider a cellular system with operating frequencies around fc = 900 MHz, cells of radius100 m, and…

A: We need to find transmitted power for given system .

Q: 3. Find the equivalent inductance at the terminals of the circuit in the given figure. * 6 mH 8 mH…

A: The solution is given below

Q: 2. For each of the circuits shown in Fig. 4.20, a. find the equivalent resistance seen by the…

A:

Q: Hau/ Frad the fransker tunchion Vics)NG) for the Circuit shown below s- 152 1H 1H

A:

Q: R1=202 LOV R23D300 R3=500 L2 R4=200 Porales

A:

Q: Q.3 For Resistance temperature detectors (RTDS) I) What's the principle of operation for Resistance…

A:

Q: 2. In the circuit below, the small-signal transconductance of Q2 falls as Vinl-Vin2 rises because…

A: The Expression for transconductance in a BJT network can be given by : gm = IcVt Where, Ic =…

Q: 8.3.9 For the RLC circuit shown in the image below, if R1 = 2 S2 and R2 = 10 S2, c = 0.10 F, and the…

A: We need to find voltage across resistor in given circuit.

Q: Ex 1: Consider the system defined by 2 + и y = [1 1] Is the system completely state controllable and…

A: In this question,   We need to check the  given system is controllable and observable?

Q: Consider the linear source follower circuit below. Let VTH = 4 V , k = 1 mA/y2 and Vpp = 20 V. VDD…

A: Given that; VTH=4Vk=1mAV2VDD=20VID2=2mA

Q: How many amps would a 7.6 Kv primary draw if the secondary is drawing 200 amps at 240 volts?

A:

Q: 17.2 The Fourier transform of f(t) is shown in Fig. P172. a) Find f(t). b) Evaluate f(0). c) Sketch…

A:

Q: 5. In the circuit below, find v,(t), i,(t), and q,(t). Assume i(f) = 101(1) mA with t in ms. For…

A:

Q: 1- Use the node-voltage method to find the v. in Figure shown. 25 V 20 N (+ - 2A ( 50N 3150 N 355 0

A:

Q: An electro-magnet draws 3 kW of active power and 4 kvar of reactive power. a.) calculate the…

A:

Q: By algebraic manipulation, reduce the given Boolean expression to its simplest form and express your…

A: Given Boolean expression: Y=A'+CA'+C'A+B+C'D

Q: 12. What is the magnitude of the electric field between parallel plates with 25 V of potential…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: Q2: a. By means of the Nyquist stability criterion (Polar plot) determine whether the unity feed…

A:

Q: 8. Junction 9. Loop 10. Circuit

A: 8. Junction : Junction in an electrical circuit is the point where a number of conductors or may be…

Q: In a phosphorus-doped silicon layer with impurity concentration of 107/cm³, find the hole and…

A: Given, Impurity concentration in phosphorous doped silicon layer, ND=1017cm3 Energy gap of silicon,…

Q: A cantered en:Polar rect aug ular pulce gCt) A. Fourier Transform f gCt) is GGO =ACçiac ft) an for…

A: The solution is given below

Q: Homework 2 In Fig. Below, the switch has been closed for a long time and is opened at t-0. Find i…

A: In this question,   We need to determine the voltage and current as shown in the circuit.  We know…

Q: For Figure 3, Vec +15 V Re 2.2 kn R1 22 kn Vim R2 4.7 kn RE 1.0 kfN FIGURE 3

A: AC analysis circuit: Due to the complexity to calculate all parameter, AC and DC analysis is…

Q: Explain how ACG works!

A: ACG (ALTERNATING CURRENT GENERATOR) STARTER: 1. It uses the very same AC generator that generates…

Q: The following test results of a single-phase step-down transformer which were measured at primary…

A: 7. It is given that: Open-circuit test: VOC=415 V; IOC=0.22 A; POC=7.64 W; Vo=240 VShort-circuit…

Q: Determine VcB in the transistor circuit shown. The transistor is of silicon and has B = 140. RC 802…

A: Given, The transistor is of Si diode. β=140

Q: 10 8. -T= 85 4 2 > t.s -2 4.

A:

Q: Determine İL(t) for t > 0 for the circuit. Answer: (1 – e-0.6t) A 2i, 1Ω 2.5 u(t)A iE (t) 5H

A:

Q: B. Parallel Connected Resistances Resistances (in Ohms) Voltages (in Volts) Current (in Amperes)…

A: Observation and analysis for parallel connected resistors: For parallel connected resistors,…

Q: One leg of a radio-tuned circuit has a capacitance of one times ten to the minus nine farad. It is…

A:

Q: pecify all reactance in.u.. Take Sp = 100 MVA, V = 33 kV %3D M.) 40 MVA, x-0.20 pu Xr1 T, T7 30 kV…

A:

Q: BLOCK DIA (d) 10s +1 T(s) = s( - 2s + 10) Ans. unstable, unstable (e) 4(s + 2)s? (s +6) T(4) Ans.…

A:

Q: An AC current has an rms value of 3.8 A. Determine the peak value of the current (in A).

A:

Q: Balanced A-connected load (1525°Q/ph), is connected with another load balanced Y-connected…

A:

Q: Example Sketch the root loci for the system. K(s+ 1) (s+3.6)

A: In this question,   We need to draw the root locus of the given system.

Q: H.W.leFind the laplace ransformsof the fallawing funclionS (6) sinh? at

A:

Q: Law of Energy Conversion A. Connection of Power Plant to Consumers Energy converted from electrical…

A: The solution is given below

Q: A current sheet k= 1oaz A/m lies inx=5m plane- asecand sheet K=-10az Anties in X=-5m plane find H at…

A: We need to find magnetic field for current sheet at different point .

Q: Consider the following block diagram. a. Find the poles and zeros of the open-loop transfer function…

A: Given here a block diagram and asked to find the open-loop poles and zeros. And the closed-loop…

Q: Problem 1: Given the electric field E = 2xa_ -4ya (V/m), find the work done in moving a point charge…

A:

Q: please draw in paper The band stop filter block diagram

A:

Q: B. Resistors in Parallel R1 (Q) R2 (Q) R3 (2) RT (Ω) Vrotal= 50 V Current (I) 20 40 120 katal = V1=…

A:

Q: Determine the Laplace transform, plot the pole-zero locations and the associated region of conver-…

A:

Q: Find Theu Equnvalenm Vallage & I pedinee vid Drowe your Lirauit m 0.22 19 y

A:

Q: 4. A battery has an EMF of 24.0 V and an internal resistance of 'r'. Its terminals are connected to…

A:

Q: A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing…

A: In this question,   We need to determine the emf induced in each phase winding and the terminal…

Q: EXAMPLE Determine the low and high-cutoff frequencies for the fig as shown the below using following…

A: The frequency response of FET amplifier can be obtained by considering the RC network in the…

Q: Determine the reverse voltage and reverse current for the diode in Figure 2 below for each of the…

A: We need to find out current and voltage for given circuit for different case .

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).