A graduated cylinder is filled to a depth of 17.00cm with water (Pwater 1000 kg ). Determine the gauge pressure at the bottom of the graduated cylinder. m³ Pa kg Suppose a student then adds a 20.00cm layer of oil ( Poil-895-) atop the water. What happens to the gauge pressure at the bottom of the container? m3 O Impossible to tell O The gauge pressure decreases with the addition of the oil. O The gauge pressure increases with the addition of the oil. O The gauge pressure stays the same with the addition of the oil.

A graduated cylinder is filled to a depth of 17.00cm with water (Pwater 1000 kg ). Determine the gauge pressure at the bottom of the graduated cylinder. m³ Pa kg Suppose a student then adds a 20.00cm layer of oil ( Poil-895-) atop the water. What happens to the gauge pressure at the bottom of the container? m3 O Impossible to tell O The gauge pressure decreases with the addition of the oil. O The gauge pressure increases with the addition of the oil. O The gauge pressure stays the same with the addition of the oil.

Name: 3.DETAILSkgA graduated cylinder is filled to a depth of 17.00cm with
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: 3.DETAILSkgA graduated cylinder is filled to a depth of 17.00cm with water (Pwater 1000- -). Determine the gauge pressure at the bottom of the graduated cylinder.mPaSuppose a student then adds a 20.00cm layer of oil ( Poil-895 kg) atop the water. Wh

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter12: Fluid Dynamics And Its Biological And Medical Applications

Section: Chapter Questions

Problem 47PE: An oil gusher shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter....

See similar textbooks

Similar questions

You can chew through very tough objects with your incisors because they exert a large force on the small area of a pointed tooth. What pressure in pascals can you create by exerting a force of 500 N with your tooth on an area of 1.00 mm2?
How do you convert pressure units like millimeters of mercury, centimeters of water, and inches of mercury into units like newtons per meter squared without resorting to a table of pressure conversion factors?
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
Does atmospheric pressure add to the gas pressure in a rigid tank? In a toy balloon? When, in general, does atmospheric pressure not affect the total pressure in a fluid?
If the gauge pressure inside a rubber balloon with a 10.0-cm radius is 1.50 cm of water, what is the effective surface tension of the balloon?
Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chunk of iron with a mass of 390.0 g in air is found to have an apparent mass of 350.5 g when completely submerged in an unknown liquid. (a) What mass of fluid does the iron displace? (b) What is the volume of iron, using its density as given Table 14.1? (c) Calculate the fluid's density and identify it.
Suppose you have a wind speed gauge like the pitot tube shown in Figure 14.32. By what factor must wad speed increase to double the value of h in the manometer? Is independent of be moving fluid and be fluid the Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
Two thin-walled drinking glasses having equal base areas bin different shapes, with very different cross-sectional areas above the base, are filled to the same level with water. According to the expression P = P0 + gh, the pressure is the same at the bottom of both glasses. In view of this equality, why does one weigh more than the other?
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
Why is it difficult to swim under water in the Great Salt Lake?
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.