A heat engine using lake water at 12oC as source and the surrounding atmosphere at 2oC as sink executes 1080 cycles per min. If amount of heat supplied per cycle is 57 J, what is the output of the engine?

A heat engine using lake water at 12oC as source and the surrounding atmosphere at 2oC as sink executes 1080 cycles per min. If amount of heat supplied per cycle is 57 J, what is the output of the engine?

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 2RQ: The operating condition for the single compressor in a household refrigerator is the lowest box...

See similar textbooks

Related questions

Q: 3. A Carnot cycle operates between sources and sink temperatures of 260°C and - 17.8°C. If the…

A: Calculated to efficiency of system,net work transfer and heat rejected to sink.

Q: A refrigerator use 134a as the working fluid and operates on an ideal vapor- compression cycle…

Q: a. A heat pump is required to maintain a house at 18oC. i. If the outside temperature is -5oC, what…

Q: Refrigerant 134a enters the compressor of a refrigerator as superheated vapor at 0.20 MPa and -5 ° C…

A: The above question is based on vapor compression of refrigeration system.

Q: Example 25.6 A refrigerator operating on a standard vapour compression cycle has a coefficient of…

A: Given: The COP of refrigerator, COP = 6.5 The compressor power, W = 50 kW The condenser temperature,…

Q: simple-cycle gas turbine plant has compressor and turbine efficiencies of 0.88 and 0.91,…

Q: Q.3 A Carnot cycle heat pump operates with R134a as the refrigerant. The condenser and evaporator…

A: GivenHeat pump working on carnot cyclerefrigerent R134aTc=50oC=323KTe=10oC=283Km=0.3kg/s

Q: A 287-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

Q: 4. A reversed Carnot cycle is used for refrigeration and rejects 1000kW of heat at 67C while…

Q: n a test of cycle steam power plant, the measured rate of the steam supply was 7.1kg / s when the…

A: Given that, Mass flow rate of steam, m˙=7.1 kg/sec,Work output from turbine, W=5000 kW,Feed water…

Q: A refrigerator uses R22 as the working fluid. And it operates a vapor compression refrigeration…

Q: For the given reverse Brayton cycle, the COP of the heat pump is h(kJ/kg)+ 500 2 320 1 300 210…

Q: An ideal vapor compression cycle operates between the temperature limits of -5 °C and 30 °C and uses…

Q: 4) A closed system that is based on the Carnot heat engine cycle uses 60 g of water vapor (steam) as…

Q: A refrigerator uses refrigerant 134a as the working fluid and operates on an ideal vapor-…

Q: Fill in the blanks: A reversed Carnot cycle requires 3 Hp and extracts energy from a lake to heat a…

A: Apply the concept of heat pump to solve this problem

Q: A heat pump installation is proposed for a home heating unit with an output rated at 30 kW. The…

A: Given data Writing values from steam table.

Q: 3-A refrigerator operates on the compression ideal vapor refrigeration cycle with R-134a as the…

A: The enthalpy of the saturated liquid at 800 kPa can be determined from the standard table.

Q: Determine for the cycle: a) the mass fraction of steam diverted to the closed heater after the first…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: A reversed Carnot cycle delivers 60 x10' kJ\min to conditioned space when used as heat pump. If the…

Q: A steam power plant operates on the Rankine cycle. The steam enters the turbine at 7 Mpa and 550…

A: The correct answer is option (d) 46.54 Mw Given Turbine temperature = 550 C Turbine pressure = 7…

Q: 6-A heat engine receives 6kW from 250°C source and reject heat at 30°C. Examine each of three cases…

A: Heat input, Qin= 6 kW= 6000 W Source temperature, T1= 250∘C= 250+ 273 K= 523 K Sink temperature, T2=…

Q: A regenerative cycle operates with steam supplied at 30 bar and 300 °C, and the condenser pressure…

A: Given Data The steam pressure is: P1=30 bar The steam temperature is: T1=300°C The pressure at…

Q: Show the P-h diagram and your solutions. 1. A simple vapor compression cycle using R-134 refrigerant…

A: Given that , R-134aSimple vapour compression cycle , Capacity=30TOREvaporator…

Q: A dry and saturated steam supplied in a power plant is at 1500 kPa. Determine the efficiencies of…

A: Given: The condition of the steam is dry saturated. Boiler pressure or turbine inlet…

Q: EXAMPLE 9 Steam is generated in the boiler of a cogeneration plant at 10 MPa and 450°C at a steady…

Q: A 299-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

A: Answer: The power output of the turbine is 302.3185 MW.

Q: A 286-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

Q: The thermal efficiency and power output of a solar pond power plant are to be determined. The…

A: A rankine cycle is a modified version of carnot cycle on which power plant works. It's consists of…

Q: A 259-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

Q: A Carnot Refrigerator cycle absorbs heat at 270K and rejects it at 300K. If the cycle is absorbing…

Q: A Rankine cycle with a water boiler at 3.0 MPa. The cycle has the highest and lowest temperatures of…

Q: A 258-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

Q: 3. A REVERSED CARNOT CYCLE IS USED FOR REFRIGERATION AND REJECTS 200 000 Btu/min OF HEAT AT 152.6F…

A: GIVEN DATA- Q2=200000 Btu/min TH=152.6'F TL=450.6'R WE HAVE TO FIND COP , CAPACITY , WORK

Q: A heat pump operates with Qin = 100kJ and Qout=250kJ. The cycle work is

A: Given data: Qin=100 kJQOut=250 kJ Need to determine the cycle work.

Q: Write legibly, provide manual step by step solution, and diagram for below given problem. In an…

Q: Consider a regenerative vapor power cycle with two feedwater heaters, a closed one and an open one,…

Q: A simple-cycle gas turbine plant has compressor and turbine efficiencies of 0.88 and 0.91,…

Q: A steam cycle to be installed between a geothermal at 255 ° C and a lake at 15 ° C will have 90MW…

A: Consider the diagram shown below for the given system. Here, 90 MW of heat is supplied and 30 MW of…

Q: A Rankine cycle with a water boiler at 3.0 MPa. The cycle has the highest and lowest temperatures of…

Q: Determine the rate of heat addition into an ideal Rankine cycle, in kJ/kg, for the following…

Q: A simple vapor compression cycle develops 15 tons of refrigeration using ammonia as refrigerant and…

Q: Heat leaks from the air in a kitchen through the walls of a refrigerator into the refrigerated cold…

A: Given: Cooling load QL=0.3kWEvaporator pressure = 1.2barCondenser pressure= 9bar

Q: A heat pump operating according to the reverse Carnot cycle will have heat at 20 C draws heat from…

Q: A 283-MW steam power plant operates on the Rankine cycle but with turbine and pump efficiencies of…

A: GivenP1=10000 kPa=10MpaT1=550oCP2=50kPaηP=ηT=90%Power=282 MW

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The operating condition for the single compressor in a household refrigerator is the lowest box temperature, which is typically A. 0F B. -20F C. 20F D. 40F
What is the best coefficient of performance for a heat pump that has a hot reservoir temperature of 50.0ºC and a cold reservoir temperature of −20.0ºC? (b) How much heat transfer occurs into the warm environment if 3.60 × 107 J of work (10.0 kW · h) is put into it? (c) If the cost of this work input is 10.0 cents/kW · h, how does its cost compare with the direct heat transfer achieved by burning natural gas at a cost of 85.0 cents per therm. (A therm is a common unit of energy for natural gas and equals 1.055 × 108 J.)
A split air conditioner is used to heat an office in winter and cool it in summer.For this purpose, a split air conditioner with a cooling power of 1200 Btuh (3.5 kw) is used for the office. The power drawn by the split air conditioner is 1.2 kw accordingly. a) COP value b) If the outdoor temperature of the air conditioner is kept 22 C in summer, calculate the limit values for heating and cooling COP if the outdoor temperature in summer is 42C and the outside temperature in winter is -6C
A heat engine is assumed to operate on a Carnot cycle. It receives 900kJheat from a high temperature reservoir at 550oC and rejects heat to a lowtemperature reservoir at 30oC.a. Calculate the thermal efficiency of the cycle.b. What is QH and QL?c. What is the net work produced by this cycle?d. Does this process violate Kelvin-Plank statement? Explain.e. An inventor claimed that he built a heat engine operating between the same reservoirs that give a thermal efficiency of 80%.Comments about his claim.f. Draw this process on a Ts diagram with proper labelling.g. If the cycle is reversed and operated as a heat pump, calculate itsperformance.
What is the highest possible theoretical efficiency of a heat engine operating with a hot reservoir of furnacegases at 2000°C when the cooling water available is at 10°C ?
Steam turbine receives steam at 9.5 MPa, 540°C and the condenser at 0.01 MPa. Steam are extracted at 3 MPa, 1.8 MPa, and 0.6 MPa. Determine the following: 1. Degree superheat at point 2 2. Quality of steam at point 4 3. Mass extracted in kg/hr for each feedwater open heater and the remaining mass that enters the condenser assuming 20,000 kg/hr of throttle flow 4. Work net in kW 5. Cycle thermal efficiency
. A carnot heat engine with thermal efficiency of 70% is supplied with heat at a rate of 800 kJ/min. If it is coupled to a carnot heat pump to deliver 1800 kJ/min of heating, determine the COP and temperature outside the house if it is maintained at 24C
A 3 Megawatt steam power plant operates at a steam engine pressure of 220 psia, 550 °F and at exhayst pressure of 5 psia. The steam consumption is 62,700 lb/hr. Calculate the indicated engine efficiency if the combined electrical and mechanical efficiency is 70%
A heat engine is operating on a Carnot cycle and has a thermal efficiency of 55 percent. The waste heat from this engine is rejected to a nearby lake at 60°C at a rate of 900 kJ/min. Determine the power output of the engine
Derive an expression for the COP of a completely reversible refrigerator in terms of the thermal energy reservoir temperatures, TL and TH.
Refrigerator 1 simulates an ideal refrigerator and therefore operates on a Carnot cycle using R-134a as the refrigerant at a flow rate of 1.4 kg/sec. The condensing and evaporating temperatures are 30 °C and -10 °C, respectively. To assess the performance of Refrigerator 1, you must submit the report. of the project with the following information: Enthalpies corresponding to the states indicated in the cycle (1, 2, 3 and 4); 1.a. The cooling rate (QL); 1.b. The work provided to the fluid by the compressor; 1.c. The work generated by the turbine; 1.d. The condenser heat rejection rate (QH); 1e. The coefficient of performance of the cycle;
Refrigerator 1 simulates an ideal refrigerator and therefore operates on a Carnot cycle using R-134a as the refrigerant at a flow rate of 1.4 kg/sec. The condensing and evaporating temperatures are 30 °C and -10 °C, respectively. To assess the performance of Refrigerator 1, you must submit the report. of the project with the following information: Enthalpies corresponding to the states indicated in the cycle (1, 2, 3 and 4); 1.a. The cooling rate (QL);Response 1.b. The work provided to the fluid by the compressor;Response 1.c. The work generated by the turbine;Response 1.d. The condenser heat rejection rate (QH);Response 1 and. The coefficient of performance of the cycle;Response