A large soil sample obtained from a borrow pit has a wet mass of 26.50 kg and an in-situ volume of 0.013 m³ occupied by the sample. A small portion of the sample weighing 135 g is then delivered to the laboratory to determine the water content. After drying in the oven, the soil sample became 117 g in mass. Determine the ff: a. Water content b. Dry unit weight of the soil c. Degree of saturation

A large soil sample obtained from a borrow pit has a wet mass of 26.50 kg and an in-situ volume of 0.013 m³ occupied by the sample. A small portion of the sample weighing 135 g is then delivered to the laboratory to determine the water content. After drying in the oven, the soil sample became 117 g in mass. Determine the ff: a. Water content b. Dry unit weight of the soil c. Degree of saturation

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter3: Weight–volume Relationships

Section: Chapter Questions

Problem 3.10P

See similar textbooks

Similar questions

Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory evaluation. The tube sample has a diameter of 71 mm, length of 558 mm, and a moist weight of 42.5 x 10-3 If the oven-dried weight was 37.85 x 10-3 kN, and Gs = 2.69, calculate the following: Moist unit weight Field moisture content Dry unit weight Void ratio Degree of saturation
A large soil sample obtained from a borrow pit has a wet mass of 26.50 kg. The in-place volume occupied by the sample is 0.013 m³.A small portion of the sample is used to determine the water content, the wet mass is 135 g and after drying in the oven, the mass is 117 g. A. Determine the soil water content. B. Determine the soil wet density for conditions at the borrow pit. C. Determine the soil dry density for conditions at the borrow pit.
A soil sample in its natural state has a weight of 2.30kg and a volume of 1.15x10^-3 m^3. Under an over dried state, the dry weight of the sample is 2.035 kg. Gs=2.7 Determine the degree of saturation and the air content
A soil with a volume of 163cm^3 is sampled from a field. It weighs 221g. Then, the sample was saturated until the pores were filled and now weighs 273g. The sample was drained and weighed 236g. The sample then sat out for about 2 weeks until at equilibrium and weighed 206g. After oven drying the sample, it finally weighed 202g. What is the percent moisture content by mass (theta g) at field capacity %?
Results from a liquid limit test conducted on a soil are given below. a. Determine the liquid limit of the soil. b. If it is known that the PI = 6.5, what would be the plastic limit of the soil? c. Determine the liquidity index of the soil if win situ = 23.8%
A soil sample has a volume of 29cm^3 and a mass of 45.5 g in its natural state in the field. After drying the mass of the sample reduced to 32g. if specific gravity of solids is 2.66. find a) water content b)Vs, Va, Vw c)void ratio d) Vw in 1m3 if the soil was fully saturated
A soil with a volume of 163cm^3 is sampled from a field. It weighs 221g. Then, the sample was saturated until the pores were filled and now weighs 273g. The sample was drained and weighed 236g. The sample then sat out for about 2 weeks until at equilibrium and weighed 206g. After oven drying the sample, it finally weighed 202g. What is the percent moisture content by volume (theta v) at saturation %?
The field density of a soil sample is 1900 kg/m3 and the density of its solid particles is 2700 kg/m3. Compute the dry density, the void ratio and degree of saturation if the sample has a water content of 11.5%
An undisturbed specimen of soil has a volume of 300 cm3 and weighs 498 g. After over drying for 24 hours, its weight is reduced to 456 g. Assume G= 2.70 . Determine the degree of saturation in percent. a. 9.21 b. 31.9 c. 43.8 d. 78
The following are the observed lab values for determining the maximum dry unit weight of the soil. (See table below) Determine the optimum moisture content in percent (3 decimals) Determine the maximum dry unit weight, in kN/m3 (round off to the nearest 10th) How much water (in kg) must be added per m3 of soil to achieve maximum dry unit weight if initially the moisture content of the in-situ soil before testing was 6%?
The wet mass of a sample of a saturated soil is 520 grams. The dry mass, after oven-drying, is 400 grams. Determine the following: a. Water content b. Void ratio, c. Saturated unit weight d. Effective unit weight.
For a given soil sample, it has a sp.gr. of 2.74, moisture content of 16.6% and a moist unit weight of 20.6 KN/cu.m.a) Compute the porosity of the soil sample.b) Compute the buoyant unit weight of the soil sample.c) Compute the weight of water in KN to be added per cu.m. of soil for 90% degree of saturation.