A long thin solenoid of length I and cross-sectional area A contains N₁ closely packed turns of wire. Wrapped tightly around it is an insulated coil of N₂ turns(Figure 1). Figure < 1 of 1 Part A Assume all the flux from coil 1 (the solenoid) passes through coil 2, and calculate the mutual inductance. Express your answer in terms of the variables N₁, N2, A, I, and appropriate constants. M = Submit IVE ΑΣΦ Provide Feedback Request Answer ?

A long thin solenoid of length I and cross-sectional area A contains N₁ closely packed turns of wire. Wrapped tightly around it is an insulated coil of N₂ turns(Figure 1). Figure < 1 of 1 Part A Assume all the flux from coil 1 (the solenoid) passes through coil 2, and calculate the mutual inductance. Express your answer in terms of the variables N₁, N2, A, I, and appropriate constants. M = Submit IVE ΑΣΦ Provide Feedback Request Answer ?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 13.9CYU: Check Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire...

See similar textbooks

Similar questions

The current in the long, straight wire shown in the accompanying figure is given by, where I=I0sint I0=15Aand=120rad/s. What is she current induced in the rectangular loop at (a) t = 0 and (b) t=2.1103s The resistance of loop is 2.0 .
Check Your UnderstAnding Verify the directions of the induced cuffents in Figure Figure 133 (a)Qosig the switch of ciicuit 1 produces ashort4ived cuicenz surge in circuit2 (b) If the switch remains closed, no current is observed in cituit 1 (c) Opening the switch again produces a short-lived cuirent in circuit 2 but in the opposite direclion fiom before.
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
The circular conducting loops shown in the accompanying figure are parallel, perpendicular to the plane of the page, and coaxial. (a) When the switch S is dosed, what is the direction of the cun’ent induced in D? (b) When the switch is opened, what is the direction of the current induced in loop D?
In an oscillating RLC circuit, R=5.0 ,. L=5.0mH , and C = 500 F . What is the angular frequency of the oscillations?
The north pole of a mag’iet is moved toward a copper loop, as shown below. If you are looking at the loop from above the magnet, will you say the induced convent is circulating c1ockise or counterclockwise?
Assume a large flat loop with a radius of 10 cm and a small loop with a radius of 1 cm at the center and in the plane of the large loop. What is their mutual inductance in Henry? If the current varies at a rate of 50 Amp/sec in one loop, what will be the electromotive force induced in the other loop?
Determine the mutual inductance between a toroidal coil of N1 turns with square cross section (inner and outer radii, b and a, respectively, and height h) as shown and a second, small toroidal coil of radius r (i.e, radius of the cross-section) and N2 turns that is coaxial with the first coil and fully enclosed within it. Assume that r<<a, b.
An engineer proposes to store 75 kJof energy by flowing 1.5 kA of current through a superconductingsolenoid that forms an inductor. (a) What is the required inductance L? (b) If the solenoid is to have a radius of 1.2 m and bewound with no more than 5 turns per meter, what length mustthe solenoid have?
DERIVE THE MAGNITUDE OF THE INDUCED EMF GIVEN THAT THE STRAIGHT LINE CONDUCTOR CARRIES CURRENT i THAT INCREASES AT A RATE OF di/dt
Please just help with this question: What would be the terminal velocity of the rod if all the conditions of part (b) of the problem where held, except there was also friction with a kinetic coefficient of ?k=0.0215? (Note: I believe the answer for b) is the induced current of 0.049 A if it helps)
Check Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?