Answered: A magnetic field strength of 5000A/m is…

A magnetic field strength of 5000A/m is applied to a circular magnetic circuit of mean diameter 250 mm. If the coil has 500 turns, find the current in the coil. Express your answer in Amperes.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Related questions

Q: Does maximum power transfer imply maximum efficiency of power transfer? Explain

A: In this question we will write that maximum power imply maximum efficiency or not....

Q: Q7: Derive an expression for the frequency of oscillation and the minimum gain, if the RL network is…

A: A Phase shift oscillator is a circuit that produces a sine wave as an output. It is connected to an…

Q: With a 1-MHz carrier, if the LSB extends down to 990 kHz, then the USB will extend up to.

A: Given with a 1 MHz carrier , if the LSB extends down to 990 KHz , then we have to determine the the…

Q: following equation by using gates: Q1/Design the Y= (A + B). (A.B). (A+B)

Q: Q.22: 380V, 3-, 4-wire CBA system with A-connected load (3+j4,3-14,5) ohm. Find the line currents…

A: Delta Connections: In a three-phase electrical system, a delta connection is formed by three…

Q: Present actual applications related to the use of the DC motor in the setup of the robotic system…

A: A DC motor is a Electric device which converts the electrical energy into physical motion. The…

Q: Solve for the following: VCE at Q-point saturation current, Ic(sat) midband voltage gain, Avmid =…

A: DC analysis of the amplifier The Thevenin equivalent circuit of the amplifier will be…

Q: 4Ω 60 V +1. Το 10 Ω www aΩ DA 310 ΦΩ

A: The solution is given below. .

Q: The transition table that represents the sequential circuit is given as

Q: The deep well pump motor is 50 hp, 3-phase, 4-poles, 230 volts, 60 Hz induction motor, operating at…

A: In this question 3 phase induction motor is given.....We have to find out current at which the motor…

Q: Q1/ In the circuit shown below, the zener diode used has the following specifications : Vz= 12 volt,…

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: Phase sequence:- Three phase sequence have same magnitude and phase difference by each other by 120…

Q: T B-two transformers A and B are connected in parallel to a load ot (2+j1.5). Their impedances in…

Q: An AM transmitter antenna current is measured with no modulation and found to be 2.6 amperes. With…

Q: 3- A 3-phas step-down transformer is connected to 6600V mains, and takes 10A. Calculate the…

Q: 5V 2 ΚΩ 2.2 ΚΩ + 1.8 ΚΩ - Vout

Q: For the combinational network of BJT and JFET, determine the base current l 16 V 2210 40 1.2 IDSS=6…

Q: Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and…

Q: Q2/ Find the state-space representation of the electrical network shown in Figure 3.8. The output is…

A: To find the state space representation of the electrical network

Q: The efficiency of 100 kW, 600V, 3 phase synchronous motor is 90%. When the pf is 0.9 leading, what…

Q: The sequence components of phase a current are: zero sequence= 0.47 + j1.49 positive sequence= 18.4…

Q: • Choose the correct answer for the power of element 2 and identify if the power is consumed or…

Q: A balanced delta-connected load with impedance per phase of 30/30° is connected to an abc-sequence…

Q: lov I, tila 19 fic 1₂ 30 www ilit RV (ia 25-2 b 120-2 502 THI $100_2 d 47 H Is C 15V DIV

Q: Solve for Vo 4/-90° V

Q: A synchronous generator has a constant mechanical input power of Po. In the fault followed by the…

A: Given A1=1.6 A2=0.4

Q: A single-pole causal LTI system has the following impulse response given below. h(n) n Which option…

Q: 1- The low voltage winding is wound under the high voltage winding. Why.

A: As per Bartleby policy we can answer only one question at a time. I am answering first ques for you.…

Q: Find the all-day efficiency of a 1500kVA transformer whose copper losses and iron losses at fu load…

Q: Question 6 a) Describe with the aid of suitable diagrams, the three types of stable output response…

A: The three types of stable output response to a step input produced by a second order system are (1)…

Q: A carrier is modulated by three audio tones. If the modulation indexes for the tones are 0.3, 0.4,…

Q: 1 [.T[Sincrot] fourier transform

Q: H. w: find (VS), Io= 2 mA in the circuit infig Kirchhoffs Law? 1 KM ли 2K₁10Ka Vs t быка VI.

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

Q: Each phase of a star connected load consists of a resistance of 100 2 in parallel with a capacitance…

Q: Question 1 1- Apply DeMorgan's theorems to the expressions XY(Z+W) 2- Apply DeMorgan's theorems to…

A: As per the guidelines of bartleyby I need to answer first question only so kindly repost other…

Q: Calculate V2 using node analysis for the following circuit. circuit sources are voltage the…

Q: For the circuit below, find the value of ZT 8Ω -j12Ω Ε = j16 Ω Ε 20 Ω 10 Ω www j15 ΩΣ -j16Ω Στ www…

Q: 12. Evaluate * y"+y' = 0; y(0) = 0, y '(0) = 1 cost + sint t + cost + sint A) B) 1- e-t t-e-t O D)…

A: Given

Q: - The low voltage winding is wound under the high voltage winding. Why. - What are the differences…

Q: VIVA QUESTIONS: 1. What is rectifier? 2. What is filter? 3. Define Ripple factor? 4. How capacitor…

Q: B-two transformers A and B are connected in parallel to a load ot (2+j1.5). Their impeda in…

A: In this question we will find terminal voltage ,power output and power factor of parallel connected…

Q: 1- What is Breakdown voltage?

Q: A balanced A load has phase impedance of 2702-57° and phase voltage of 208 V. Take Vab as reference…

Q: 1) A A- A bank consisting of three 20-kVA, 2300/230-V transformers supplies 40 kVA. If one…

A: In this question open delta connection is given....We have to find out kVA load supplied by each…

Q: the sequence currents of phase a current are as folle Zero sequence current = 14.13 17.34 positive…

A: In this question we have given symmetric components of phase a current . We have to find phase a…

Q: نقطتان (2) * To check the O/P of the carrier :generator on Function Generator. O Oscilloscope. O

Q: With a 1-MHz carrier if the ISB extends down to 990 kHz then the USB will extend up to

A: We need to find out the upper side band frequency

Q: question 1:- Apply Routh Criterion to check the Stability of 5+5+25+25² +35+15=0. 54 Ans. unstable…

A: We need to check whether the given system is stable or not .

Q: 1-transfer function of DC series motors (step by step ). 2-block diagram of DC series motors la L It…

Question

A magnetic field strength of 5000A/m is applied to a circular magnetic circuit of mean diameter 250 mm. If the coil has 500 turns, find the current in the coil. Express your answer in Amperes.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the magnetic field in the center of the coil, which has threelayers of 600 turns each, the length of the coil is 0.5 m and circulates a3.2 A current
A coil of resistance 100W is placed in a magnetic field of 1mW. The coil has 100 turns and a galvanometer of 400W resistance is connected in series with it. Find the average emf and the current if the coil is move in 1/10th second from the given field to a field of 0.2mWb.
Determine the emf inducted in a coil that rotates its 1250 r/min. The coil has 60 windings and a length and width of 0.7 and 0.6 respectively. The pole shoe has an area and area of 0.4 meters squared and it moves through a magnetic flux of 36 mWb
In the below magnetic circuit, the induction field in the air gap is desired to be $ 0.6 $ T. Calculate the current $ I $. BH curve of the material is at the bottom of the page.$ l = 1.5 $ m, $ d = 1 $ mm, $ N = 203 $, $ \mu_0 = 1/800000 $.
A magnetic circuit consists of silicon steel of 3000 permeability and an air gap. The length of the steel core is 10cm and the air gap is 2 cm. Both have the same cross-section of 1.5 sq.cm. A current of 1/4 A flows through the windings to produce 2351 maxwells flux. How many turns are there in the coil? Answer: ______ turns
A magnetic field strength of 5000A/m is applied to a circular magnetic circuit of mean diameter 250 mm. If the coil has 500 turns, find the magnitude of the magnetic field. Express your answer in mT.
PLSS ANSWER WITHIN 5MINS Calculate the current flowing in a 50 mH - inductor if the energy stored in its magnetic field is 280 µJ.
A 460-turns square wire coil rotates about a vertical axis at 2690 rev per min as in FIGURE 5. The side of the square wire is 3.3 m each. The horizontal component of the Earth's magnetic field at the location of the loop is 37 µT. (i) Calculate the maximum emf induced in the coil by the Earth's magnetic field. (ii) Find the time for the coil to make 3 complete rotations. (iii) Sketch a graph of emf against time.
16/ A single phase supply can be generated when three coils are placed 120° apart and the whole is rotated in a uniform magnetic field. Select one: True False
A circular coil of wire with 7 loops and a radius of 0.041 m is placed inside a solenoid. The coil is aligned so that the normal to the coil is parallel to the magnetic field in the solenoid. The solenoid consists of 40000 loops of wire and is 0.18 m long. Initially a current of 0.5 A runs through the solenoid. The current is increased to 4.5 A over a period of 4.1 s. What is the initial magnitude of the magnetic field inside the solenoid?
A coil consists of 1000 turns of wire uniformly wound on a non-magnetic ring of mean dimeter 40 cm and cross-sectional area 20 cm^2. Calculate (a) the stored energy in the magnetic field when the coil is carrying a current of 15 A, (b) the e.m.f. induced in the coil if this current is completely interrupted in 0.01 second. Answer is 0.225 J, 3V. Show solution.
A length of stiff copper wire is made into a rectangle measuring 24 cm by 10 cm. It is rotated at a uniform speed of 600 rpm about one of its longer sides as axis, this side lying on and at right angle to a uniform magnetic field of 0.5T calculate the induced voltage in the coil. * Draw the diagram