A masonry dam has a coefficient of permeability in the vertical and horizontal directions of Kz=4m/day and Kx=5m/day, respectively. The difference in the head is 18m and the distance between the base of the dam and the downstream water surface is 18m. Assume z=35m and width of dam = 40m. a. Determine the seepage flow (m3/day). b. Determine the uplift pressure (kPa) at A. c. Determine the uplift force (kN) acting in the dam. Assume that the uplift pressure under the dam varies uniformly

A masonry dam has a coefficient of permeability in the vertical and horizontal directions of Kz=4m/day and Kx=5m/day, respectively. The difference in the head is 18m and the distance between the base of the dam and the downstream water surface is 18m. Assume z=35m and width of dam = 40m. a. Determine the seepage flow (m3/day). b. Determine the uplift pressure (kPa) at A. c. Determine the uplift force (kN) acting in the dam. Assume that the uplift pressure under the dam varies uniformly

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A masonry dam has a coefficient of permeability in the vertical and horizontal directions of Kz=4m/day and Kx=5m/day, respectively. The difference in the head is 18m and the distance between the base of the dam and the downstream water surface is 18m. Assume z=35m and width of dam = 40m. a. Determine the seepage flow (m3/day) b Determine the uplift pressure (kpa) at A. c. Determine the uplift force (x10^3 kN) acting in the dam. Assume that the uplift pressure under the dam varies uniformly.
Use 10 kN/m3 for unit weight of water. For a concrete structure that retains water, a flow net is sketched as shown in Figure H8-3. Noting the marked location of the Datum, answer the following: Mark on the figure all boundary Also mark the type of each boundary. Calculate the uplift pressures at points A, B, C, D, E, and F. Calculate the factor of safety against The seepage loss (q) per day per meter length of the (i.e. q in m3/day/m) if the permeability of the soil is k = 10-4 m/sec.
The dam shown has a base of which 2m below the ground surface. The pressure distribution diagram at the base of the dam can be obtained from the equipotential lines as follows: k=4.5 m/day. if H=6m determine the seepage through the foundation.
Determine the pressure intensity on the base of the Dam shown. Consider without hydrostatic uplift. Unit weight of concrete is 24 kN/m^3.
CALCULATION USING DARCY'S LAW An aquifer system is formed by two horizontal layers. Two piezometers were installed for monitoring, the distance between them is 885m. The upper layer (A) has a thickness of 39m and K = 1.3 x 10-5 m/s and the lower layer (B) has a thickness of 25m and K = 2.7 x 10-6 m/s. THE hydraulic load in the PZA is 60m and in the PZB it is 40m. Calculate the flow and the transmissivity of each layer.
A circular door having a diam. of 3m closes a horizontal duct from a small diam. as shown. The center of the door is 4.5m below the dam’s water level. Assuming the unit weight of water is 9.79 kN/m3. Compute the hydrostatic force acting on the door.
Illustrated laboratory setup includes a column of homogenous soil with a square cross-section area of 25 cm2. A constant head difference is applied for the setup. Assume continuous, steady-state flow in a fully saturated medium, and all head loss occurs in the soil. Points A, B, and C are located as shown in the figure. The saturated unit weight of sand is 18 kN/m3. a) Determine the elevation, pressure and total head at Points A and B.b) Determine the hydraulic gradient.c) Determine the total amount of flow per minute if k = 10 cm/mind) Show the direction and calculate the seepage force acting on plane x-x.e) Calculate the effective stress along the plane parallel to the direction of flow assuming that the total stress along that direction is 25 kPa at Point C.
A horizontal column of 100 cm length and 10 cm height is packed with a uniform soil with a saturated hydraulic conductivity of 4×10–5 cm/s. Then, the uppermost 1.0 cm is replaced with a soil with a saturated hydraulic conductivity of 2.2×10–7 cm/s. Therefore, the horizontal column has two horizontal layers. The pressure head is 20 cm at the left end (X = 0 cm; inflow boundary) of the column and 150 cm at the right end (X = 100 cm; outflow boundary). Flow is horizontal and steady state. For horizontal flow, the pressure head is the only driving force (gravitational head = 0). The volumetric water content of both soils is equal to the porosity and is 0.45 cm3/cm3. (A) Determine the effective saturated hydraulic conductivity of the layered soil column. (B) Calculate the Darcy’s flux through the layered soil column. (C) Calculate the Darcy’s flux in the top and bottom layers of the soil column.
A rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is accelerated horizontally at 2.5 m/s2 in the direction of its length. A. Determine the net force due to water acting on each end of tank. B. Determine the minumum pressure intensities at bottom C. Determine the slope of the free surface
The water table is located at a depth of 4.0 m below the ground surface in a deposit of sand 16.0 m thick (Fig. 1). The sand is saturated above the water table. The total unit weight of the sand is 25 kN/m3. Calculate the (a) the total pressure, (b) the pore water pressure and (c) the effective pressure at depths 0, 4.0, 10.0, and 16.0 m from the ground surface, and draw the pressure distribution diagram.
A masonry dam has a trapezoidal cross-section 25 m high, crest width of 3 m and base length 18 m. The upstream face slopes down 12 m in 25 m and the downstream faces slopes down in 3 m in 25 meters. If the water at the upstream face stands flushed with the crest and assuming no hydrostatic pressure uplift. Compute the location point along the base (measured from the toe) where the resultant force intersects it. The specific gravity of concrete is 2.40
hydrology engineering Q.2. The formation of length 6.4km between two stream A and B IS made up of two layers, the bottom layer is previous with a thickness of 8m and hydraulic conductivity of 36m/day .the upper layer is impervious .find the discharge from stream A to stream B if the depth of water in them are 16m and 13.5m respectively .