A mass-spring system with damping consists of a 6-kg mass, a spring with spring constant 4 N/m, a frictional component with damping constant 3 N-sec/m, and an external force given by f(t) = 10 cos (9t) N. Using an 18-92 resistor, construct an RLC series circuit that is the analog of this mechanical system in the sense that the two systems are governed by the same differential equation. Identify the inductance, capacitance, and voltage source required for the RLC circuit. L= henry, C = farad, and E(t) = volt

A mass-spring system with damping consists of a 6-kg mass, a spring with spring constant 4 N/m, a frictional component with damping constant 3 N-sec/m, and an external force given by f(t) = 10 cos (9t) N. Using an 18-92 resistor, construct an RLC series circuit that is the analog of this mechanical system in the sense that the two systems are governed by the same differential equation. Identify the inductance, capacitance, and voltage source required for the RLC circuit. L= henry, C = farad, and E(t) = volt

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 14.11CYU: Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under...

See similar textbooks

Similar questions

Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
The dynamic power of a processor was reduced ONLY by reducing the voltage and not the frequency of the clock, by a factor of 0.5625. What is the ratio of the new voltage to that of the old voltage at which the processor was being run?
A 0.50 kg body oscillates in SHM on a spring that, when extended 2.0 mm from its equilibrium position, has an 8.0 N restoring force.What are (a) the angular frequency of oscillation, (b) the period of oscillation, and (c) the capacitance of an LC circuit with the same period if L is 5.0 H?
An L-R-C series circuit has L = 0.800 H and C = 9.00 μF. Calculate the angular frequency of oscillation for the circuit when R = 0. What value of R gives critical damping? What is the oscillation frequency ω′ when R has half of the value that produces critical damping?
In Figure 31.15 let R=7.60 Ohms, L=2.20mH, and C=1.80 MicroFarad. a) Calculate the frequency of the damped oscillation of the circuit when the switch is thrown to position b. (b) What is the critical resistance for damped oscillations?
which of the following oscillations in an rlc series circuit is characterized nu a decreasing amplitude that is also oscillating? a. overdamped b. simple harmonic c. critically damped d. underdamped
What effect does the value of R in the circuit have on the resonant curve in the following figure?
Analyze the following series circuit which contains a resistor of 1O Q and a capacitor. It is connected to a source of 220 V, 50 Hz. If r.m.s current in the circuit is 2A, calculate the reactance (Xc) of the capacitor. [Ans: X = 109.540]
The purpose is to determine the current, and sometimes the phase difference between the voltage source and the current.In this case, determine the current amplitude (I0) when the circuit elements are these: ℰ₀ = 182 volts, ω = 2.71 rad/s, R = 87 Ω, L = 11 Henries, C = 0.039 Farads.
What is the period of oscillation of an LC circuit consisting of an ideal 2.0-mH inductor and a 20-µF capacitor?
Is it possible to use a voltmeter to measure non-sinusoidal AC voltage? Is it possible to use an oscilloscope (CRO)?