A material has a dry mass of 115 g, volume in natural state is 55cm3, volume in absolute compact state is 35 cm3 and volume in oven dry state is 30 cm3. Calculate the following in kg/m3: A. Density and Apparent density B. Bulk Density C. Solidity and Porosity

A material has a dry mass of 115 g, volume in natural state is 55cm3, volume in absolute compact state is 35 cm3 and volume in oven dry state is 30 cm3. Calculate the following in kg/m3: A. Density and Apparent density B. Bulk Density C. Solidity and Porosity

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter6: Fundamental Dimensions And Units

Section: Chapter Questions

Problem 23P

See similar textbooks

Related questions

Q: An iceberg floats in sea water with 14% of its volume projecting above the sea surface. If the…

A: Volume above sea surface = 14% specific weight of sea water = 10400 N/m3 It has been asked in the…

Q: Find the change in volume of 1 cu.m. of water when subjected to a pressure increase of 14 MPa when…

A: Bulk modulus of elasticity, Change in pressure and Volume of water have been given and it has been…

Q: Darcy' Law A fluid's viscosity and unit weight are reduced to 60% and 80%, due to increase in…

A: Due to an increase in temperature, a fluid's viscosity and unit weight are reduced to 60% and 80%.

Q: I. A sphere contracts in volume by 0.01% when taken to the bottom of sea I km deep. Find the bulk…

A: bulk modulus = 1013 Nm2explanation is given in below step

Q: The specific weight of an object is 2230 N/m3. Compute its specific volume.

Q: 1 kg of water has a bulk modulus of 2.4 GPa. Determine the percentage reduction in volume if the…

Q: Dutflow is not equal to the value of q in volume per time unit. O True D False

A: Given data in question Outflow Discharge q To find out True or false

Q: A stone weigh 468 N in air. When submerged in water it weighs 298 N. Which of the following most…

Q: 3. An amount of glycerin has a volume of 1.0 m when the pressure is 120 kPa. If the pressure is…

Q: Calculate of the porosity of a cubic packing model of uniform spheres？

A: Given data in question Cubical packing Uniform spheres To find out Porosity Note V = total volume…

Q: c) Illustrate the results of the viscosity test of the above motor oil then fit the viscosity…

A: Step 1

Q: According to Darcy's law for flow through porous media, the velocity is proportional to

A: The flow water through soil is governed by Darcy law . Darcy established that the flow occurring…

Q: Ships and sailing vessels often carry lead ballast in various forms, such as bricks, to keep the…

Q: Part A Determine the mass moment of inertia of the thin plate about an axis perpendicular to the…

Q: A stone weight W___N in air , when submerged in water, the stone lost 40% of its weights a-What is…

Q: A liquid has a specific weight of 41.5 lbs/ft3. How much will a cylinder that measures 18” tall and…

A: The specific weight of liquid = 41.5 lbs/ft3 Height of cylinder = 18" = 1.5 ft Diameter of cylinder…

Q: A solid rectangular silver metal with a height of 0.48 m and a total mass of 82.83 kg has the…

Q: The specific weight of glycerin is 78.6 Ib/ft'. Compute its density and specific gravity. What is…

A: Glycerin is the colorless, odorless, viscous liquid that is non toxic and have sweet taste. It is a…

Q: (b) Fill the Principal SI Unit as shown in Table Q1. Table Q1 Unit Meter per second square Quantity…

Q: When a pressure of 20.7 MN/m is applied to 100 litres of a liquid its volume decreases by I litre.…

A: Given data : Initial volume (V)=100 litre Decrease in volume (dV)=1 litre Pressure applied (dP)=20.7…

Q: Discuss about the following: centroid of a system of particles centroid of area centroid of…

Q: Some physical state properties are calculated following the practical measurement of other. For…

Q: Two sets of size analysis results are available for a given material. From a Gaudin-Schuhmann plot,…

A: Case a and b Size vs mass% is given So we will first calculate% retained

Q: A metal body floats at the interface of water and oil (sp. gr = that 35% of its volume is submerged…

Q: 3- The volume of a substance is V= 1.4m'. If specific gravity (s.g=2.6). Find A- Its Weight W. B-…

A: Given that: Volume of substance, V=1.4 m3Specific Gravity, G=2.6

Q: kinematic viscosity

A: To find: Kinematic viscosity

Q: Which one of the following is the dimension of specific weight of a liquid? a) [MLST1. b) [ML T1. C)…

A: Specific weight is defined as the ratio of weight per unit volume . Length=LMass=MTime=TSpecific…

Q: 2. A cube of material is 4 in. on a side and floats at the interface between kerosene and water, as…

Q: An object float in a liquid where 2/3 of the object in the liquid. If the density of the object is…

A: Given data: The part of the object in liquid = 2/3 Density of object, do=0.6 gr cm3 Density of…

Q: Specific gravity is calculated by the formula: S.G. = density of sample/density of water at a given…

A: Given data: t [°C] ρH2O [g/cm3] 4 1 20 0.99820 25 0.99705 It…

Q: 16 An empirical pressure-density relationship for water is given as Pa 2001x - 2000 (Here, suffix…

A: Given, and, 1atm is equivalent to 100kN/m²

Q: Two sets of size analysis results are available for a given material. From a Gaudin-Schuhmann plot,…

Q: ss = 643.9 kg gravity of soil solids = 2.68 ine: ure content. our answer to three significant…

Q: On land, a boulder has a weight of 850 N. When placed in water, it now weighs 541 N. i) Determine…

A: Determine magnitude of bouyant force and volume of boulder

Q: 17. A liquid has an absolute viscosity of 23 CP. It weighs 8.4 kN/m³. What is its kinematic…

A: As per the guidelines we are supposed to solve only first question for multiple question posted.…

Q: If the density of a certain liquid is 1.89 slugs/ft3, what is its specific weight in KN/m3?

Q: • In the piezometers of the figure shown, liqui stands 1.37 m above point M. What is the pressure at…

Q: 2. A cube of material is 4 in. on a side and floats at the interface between kerosene (SG=0.82) and…

A: Given Data: The side of a cube is b = 4 in. The specific gravity of kerosene is 0.82. To…

Q: pls answer with solution choices: in kg/m3 490 8050 77000 7850

Q: Absolute viscosity of a fluid varies w/ pressure and temperature and is defined as a function of:…

A: Correct answer is option b. Density, shear stress and angular deformation rate

Q: Q. 4. 1 ppm CaC03 equivalent hardness is meant by A : 10 mg CaC03 equiv. Per litre B : 100 mg CaC03…

A: The accumulation of mineral salts like Ca2+, Mg2+, Al3+, Iron, as well as other heavy metals causes…

Q: If 6 m³ of oil weighs 47 kN, calculate its specific weight y, density p, and specific gravity.

A: Specific weight is the weight of sample per unit volume Density is the mass per unit of its volume…

Q: Total solids Suspended solids Volatile suspended solids Fixed suspended solids 4000 mg/L 5000 mg/L…

A: Total Solids : It is a composition of all suspended ,colloidal and dissolved solids in any type of…

Q: A cube contracts in volume by 0.05% when acted upon by normal uniform pressure of 2x 106 N/m? on all…

A: Given data: The value of uniform pressure ∆P=2×106 N/m2 The value volumetric strain…

Q: In the Figure, if the oil in region B has SG= 0.8 and the absolute pressure at point A is 1 atm,…

A: Given: The specific gravity of the oil is 0.8. The absolute pressure at point A is 1 atm. Consider…

Q: A liquid has a dynamic viscosity of 4.8x10* lb-s/ft² and weighs 54 lb/ft³. What is its kinematic…

A: Given:- Dynamic viscosity=4.8×10-4 lb-s/ft2Weight=54 lb/ft3 To find:- From the given question it is…

Q: A liquid has an absolute viscosity of 2.431023 N-s/m². It weighs 7.853103 N/m?. What is its…

A: μ(absolute viscosity or dynamic viscosity) = 2.431023 N.s/m2 γ (weight) = 7.853103 N/m3 v (kinematic…

Question

A material has a dry mass of 115 g, volume in natural state is 55cm3, volume in absolute compact state is 35 cm3 and volume in oven dry state is 30 cm3. Calculate the following in kg/m3:

A. Density and Apparent density

B. Bulk Density

C. Solidity and Porosity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given data:

VIEW

A. Calculating density and apparent density:

VIEW

B. Calculating bulk density:

VIEW

C. Calculating solidity and porosity:

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mass and mass related variables in engineering

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate of the porosity of a cubic packing model of uniform spheres？
Fluid Mechanics Last fall, researchers using a manned submarine discovered coral reefs at unprecedented ocean depths of 1/2 mile, of the coast of South Carolina. Find the hydrostatic pressure at that depth. Find the fractional changes in density (drho/rho) and in volume (dV/V) for the seawater at that depth. The density of seawater at the surface of the ocean is 1025kg/m3, and the bulk modulus of elasticity of seawater is 2.34*109 Pa.
Two sets of size analysis results are available for a given material. From a Gaudin-Schuhmann plot, determine the relations between size and mass distribution in these two cases. Using equation for case B, what is the %retained at 666 microns?
Two sets of size analysis results are available for a given material. From a Gaudin-Schuhmann plot, determine the relations between size and mass distribution in these two cases. Using equation for case A, what is the %retained at 666 microns?
IF THE SPECIFIC WEIGHT OF A LIQUID IS 52lb/ft^3, WHAT IS ITS DENSITY? ANSWER:1.616slug/ft^3 PROVE THE ANSWER IN DETAILED SOLUTION. THANKS
In a relative density test, the following values are recorded: Dry mass = 3017 g Submerged mass = 1050 g Saturated, Surface Dry (SSD) mass = 3033 g Find the relative density values (RDapparent, RDbulk, and RDSSD) by first completing the phase diagram. (write answers in the phase diagram to the nearest whole number. Write the relative density answers to two decimal places.) VOLUME MASS Va = cm3 AIR Ma = grams Vw = cm3 WATER Mw = grams Vs = cm3 SOLIDS Ms = grams VT = cm3 MT = grams RDapparent = RDbulk = RDSSD =
A cube of material is 4 in. on a side and floats at the interface betweenkerosene (SG=0.82) and water, as shown.a. Find the specific gravity of the material. (SG=0.973)b. How much weight is required to fully submerge the cube underwater?
A certain liquid has a unit weight of 8.35kN/m^3. What are the values of its mass density, specific volume, and specific gravity?
A spherical shell made of a material with a density of 1600 kg/m3 is placed in water. If the inner and outer radii of the shell are R1 = 5 cm, R2 = 6 cm, determine the percentage of the shell's total volume that would be submerged. Refer to Figure no. 3.
What volume of water is contained in one cubic meter of material if the porosity is 20% and the saturation expressed as a fraction of the pore space is 30% ?
a container, in the form of hemisphere, is 800 mm across the top. It contains oil (s=0.82) at a depth of 300 mm. Determine the mass and weight of oil in the container.
A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 m3. Find the glycerin’s(a)weight (kN),(b)mass density (kg/m3),(c)specific weight (kN/m3), and (d)specific gravity.*round off to four decimal places